Answer:
due to warm temperature
Explanation:
Explanation:
There is water present in liquid form instead of liquid nitrogen on the outer side of the can because of the temperature present in the surrounding environment. The temperature around the can is little warm which is favourable for the water but not for the liquid nitrogen. The liquid nitrogen present in liquid state when the temperature of the surrounding is too cold. if it is warm, the liquid nitrogen starts boiling and converts into gaseous state so that's why the warmer temperature is responsible for the presence of water not the liquid nitrogen.
ghjguygyughyyhghygyuguyg
OOO OOO
Water's strong hydrogen bonds result in which physical properties? Check all that apply.
high boiling point
low boiling point
high specific heat
low specific heat
density of ice being less than that of liquid water
density of ice being greater than that of liquid water
6. The valence number of a metallic element x is 3. What is the chemical formula of its B. Nitride?
what happens if we mix vitamin c and d together
we can get rid of scurvy as well as rickets ......
A student borrows $10,000 from a bank but ends up paying $13,000 on the
loan over the next five years. How much interest did the student pay?
The student paid an interest of $3,000 over the next five years.
HOW TO CALCULATE INTEREST:
The interest on a borrowed amount of money can be calculated by subtracting the principal from the amount paid over time. That is;
Interest = principal - amount
According to this question, a student borrows $10,000 from a bank but ends up paying $13,000. This means that the principal is $10,000 while the amount is $13,000. The interest is calculated thus;
Interest = $13,000 - $10,000
Interest = $3,000
Therefore, the student paid an interest of $3,000 over the next five years.
Learn more about interest at: https://brainly.com/question/4626564
Answer the following question attached!!
Answer:
I think It is Covalent. Not 100% sure but like 90% sure.
Differentiate between acids and bases on the basis of their pH values Give an example of each type. Please help worth 100 points!!!!!!!
Answer: Well 0-7 is acid, and 0-3 is a strong acid. 4-7 is a weak acid. 8-11 is strong base. 12-14 is weak base!
Explanation:
How can a redox reaction be identified?
O A. Atoms have rearranged.
O B. Protons have been transferred.
.
O
C. lons are present in solution.
D. Oxidation states have changed.
Answer:
'Oxidation states have changed.'
Explanation:
Redox Reactions can be identifiable by a change in oxidation number/states of two of the atoms in the reaction. Any reaction in which no oxidation numbers/state change is not a redox reaction.
What is the mass percent of nitrogen in:
1. N2O
2. NO
3. NO2
4. N2O2
identify a binary salt among the following a,KNO3 b,NACIO3 c,MGSO4 d,CaCL2
The binary salt among the given salts is CaCl₂. The correct option is d,CaCl₂
From the question,
We are to identify the binary salt among the given salts.
First, we will define the term binary salt
A binary salt is a chemical compound that is formed from the mixture of a metal and a non-metal.
Among the given options, CaCl₂ is the salt formed from the mixture of a metal and a non-metal.
The metal is Calcium (Ca)
and the non-metal is Chlorine (Cl)
Hence, the binary salt among the given salts is CaCl₂. The correct option is d,CaCl₂
Learn more here: https://brainly.com/question/3103303
one of the biggest dangers of storms that produce heavy rains or storm surges is ___.
A. Low Temperatures
B. Flooding
Answer:
B. Flooding
Explanation:
Flooding can be caused by heavy rains/storm surges. Hope this helped!
the sequence of stages an organisms go through from one generation to the next lace where an organism lives is called in
Answer:
A life cycle is the sequence of stages an organisms goes through from one generation to the next. Organisms that reproduce sexually can have different types of life cycles, such as haploid or diploid life cycles.
Which model represents a compound with a 1:2 ratio?
Please explain your answer.
Answer:
D
Explanation:
D is the correct answer due to the fact that they way they are connected has 2 purple atoms and 1 orange one. thus would create a 1:2 ratio with 1 orange atom and 2 purple atoms.
A would create a 2:3 ratio, B wouldn't create a ratio comparable to the others, and C creates a 1:1 ratio with a few purple atoms floating around them, making all of the answers except D invalid.
In the given figures, the name of the model representing a compound with a 1:2 is figure D.
What is molar ratio?Molar ration of any compound gives idea about the ratio of the concentration of given constituents present in that compound.
In the figure A molar ratio is 2:3, in figure B molar ratio of given constituents is not given because each molecule is composed of same types of atoms, in figure C molar ratio of given constitutes particles is 1:1 and in the figure D molar ratio of constituents is 1:2. Because in figure D, two atoms of one element and 1 atom of another element is present.
Hence, figure D is correct option.
To know more about molar ratio, visit the below link:
https://brainly.com/question/4408248
Determine the volume (L) of nitrogen monoxide gas that is created at STP when 32.2 g
of solid copper reacts with excess nitric acid.
3Cu(s) + 8HNO3(aq) — 3Cu(NO3)2 (aq) + 4H2O(1) + 2NO(g)
Taking into account the reaction stoichiometry and STP conditions, the volume of nitrogen monoxide gas that is created at STP when 32.2 g of solid copper reacts with excess nitric acid is 7.5677 L.
Reaction stoichiometryThe balanced reaction is:
3 Cu(s) + 8 HNO₃(aq) → 3 Cu(NO₃)₂ (aq) + 4 H₂O(l) + 2 NO(g)
By reaction stoichiometry, the following amounts of moles of each compound participate in the reaction:
Cu: 3 molesHNO₃: 8 molesCu(NO₃)₂: 3 molesH₂O: 4 moles NO: 2 molesThe molar mass of the compounds is:
Cu: 63.54 g/moleHNO₃: 63 g/moleCu(NO₃)₂: 187.54 g/moleH₂O: 18 g/moleNO: 30 g/moleBy reaction stoichiometry, the following mass quantities of each compound participate in the reaction:
Cu: 3 moles× 63.54 g/mole= 190.62 gramsHNO₃: 8 moles× 63 g/mole= 504 gramsCu(NO₃)₂: 3 moles ×187.54 g/mole= 562.62 gramsH₂O: 4 moles ×18 g/mole= 72 gramsNO: 2 moles ×30 g/mole= 60 gramsSTP conditionsThe STP conditions refer to the standard temperature and pressure, which values are 0 °C and 1 atmosphere and are reference values for gases. In these conditions 1 mole of any gas occupies an approximate volume of 22.4 liters.
Moles of NO formedThe following rule of three can be applied: if by reaction stoichiometry 190.62 grams of Cu form 2 moles of NO, 32.2 grams of Cu form how many moles of NO?
moles of NO= (32.2 grams of Cu× 2 moles of NO)÷ 190.62 grams of Cu
moles of NO= 0.3378 moles
Then, 0.3378 moles of NO are formed.
Volume of NO createdNow, you can apply the following rule of three: if by definition of STP conditions 1 mole of NO occupies a volume of 22.4 liters, 0.3378 moles occupies how much volume?
volume= (0.3378 moles× 22.4 L)÷ 1 mole
volume= 7.5677 L
Finally, the volume of NO created is 7.5677 L.
Learn more about the reaction stoichiometry:
brainly.com/question/24741074
#SPJ1
In lab a student is asked to mix solutions of copper (II) sulfate and potassium phosphate. The
student wants to produce exactly 3.75 grams of precipitate. Based on the desired outcome
determine the volume of 1.25M copper (Il) sulfate and 0.75 M potassium phosphate required.
I believe the volume would turn out to be 2.35M but i could be wrong
what's the (snowy sour) mixture?
CH6COOH
Vinegar pickles
13) Which of the following is NOT a true statement concerning what happens in all chemical
reactions
A) The ways in which atoms are joined together are changed
B) New atoms are formed as products,
C) The starting materials are named reactants.
D) The bonds of the reactants are broken and new bonds of the products are formed,
E) in a word equation representing a chemical reaction, the reactants are written on the left
and the products on the right
BARI
Gold has a specific heat of 0.126 J/g.C. Copper has a specific heat of 0.386 J/g C. Which of the two metals would require more
heat energy to raise the temperature of the same weight of metal by 10.5C?
Answer:
The copper, because its specific heat is higher, meaning it takes more heat (Joules) per gram to raise the temperature 1 degree Celsius.
Explanation:
Which best defines color? (1 point)
a physical property of matter related to how a material interacts with different wavelengths
of light
a chemical property of matter related to how a material interacts with different wavelengths
of light
O a physical property of matter related to a material's ability to reflect light
O a chemical property of matter related to a material's ability to reflect light
Answer:
O a physical property of matter related to a material's ability to reflect light
Explanation:
Color is a physical property of matter.
1. List the ketose carbon(s) that is(are) reduced with NaBH4.
Answer:
ehh im nit sure but here!
Explanation:
How many moles are contained in 127 grams of lead?
Answer:
18.015
Explanation:
Please answer!!
No links.
Picture is included!
Answer:
c
Explanation:
What test was used to identify hydrogen gas? Write a balanced equation to represent the test?
How many grams of CaSO4 form when
50.0 mL of 0.20 M Ca(NO3)2 react with
excess potassium sulfate solution?
Ca(NO3)2 + K2SO4 → CaSO4 + 2KNO3
-
?] g CaSO4
Answer:
1.36g CaSO4 (FIXED THIS)Explanation:
.01 mol CaSO4 is the conversion factor between these values and now you just need to multiply it by the molar mass of .01 x 136.14=1.36g CaSO4
Apologies for having the wrong answer before this, it's been a long day.
I have a problem with solving this type of chemistry problem. Please Help!
help please I'll mark you as a brainliest promise.
Answer:
Law of the Sea Treaty
LOST Local Option Sales Tax (special purpose tax)
LOST Linux One Stanza Tips
LOST Liberty Owners Special Team
LOST Looking Over Strange Terrain :-)
LOST Line Of Sight Tasking
Explanation:is this what you meant?
Write a paragraph on "lipids as pigments".
A 2.50-mL aliquot of a solution that contains 6.4 ppm iron(III) is treated with an appropriate excess of KSCN to form the Fe(SCN)21 complex and diluted to 50.0 mL. What is the absorbance of the resulting solution at 580 nm in a 2.50-cm cell
Answer:
In the final solution, the concentration of sucrose is 0.126 M
Explanation:
The number of moles of solute in the volume taken from the more concentrated solution will be equal to the number of moles of solute in the diluted solution. Then, the concentration of the first solution can be calculated using the following equation:
Ci · Vi = Cf · Vf
Where:
Ci = concentration of the original solution
Vi = volume of the solution taken to prepare the more diluted solution.
Cf = concentration of the more diluted solution.
Vf = volume of the more diluted solution.
For the first dillution:
26.6 ml · 2.50 M = 50.0 ml · Cf
Cf = 26.6 ml · 2.50 M / 50.0 ml
Cf = 1.33 M
For the second dilution:
16.0 ml · 1.33 M = 45.0 ml · Cf
Cf = 16.0 ml · 1.33 M / 45.0 ml
Cf = 0.473 M
For the third dilution:
20.0 ml · 0.473 M = 75.0 ml · Cf
Cf = 20.0 ml · 0.473 M / 75.0 ml
Cf = 0.126 M
In the final solution, the concentration of sucrose is 0.126 M
hope that help
hope you have a great Christmas
mark me brinilylist
Complete the balanced dissociation equation Cs2CO3
The balanced dissociation equation for Cs₂CO₃ is:
Cs₂CO₃(aq) —> Cs⁺(aq) + CO₃²¯(aq)
A dissociation equation is an equation showing the available ions present in a solution.
To obtain the dissociation equation, the compound must be dissolved in water to produce an aqueous solution.
The dissociation equation for Cs₂CO₃ can be written as follow
Cs₂CO₃(aq) —> Cs⁺(aq) + CO₃²¯(aq)
Learn more about dissociation equation: https://brainly.com/question/1903354
During the formation of an ionic compound
1) One atom losses electrons and the second gains electrons
2) Two atoms lose electrons
3) Two atoms gain electrons