Answer:
Akash
Explanation:
it could be a magnet with the same poles facing eachoher
PLEASE HELP !!
Use the diagram below to answer the following questions.
PLEASE HELP
E TE
Figure B
In Figure B, which region contains the noble gas family of elements?
ОА
OD
ОС
OB
Noble gas located in the region D
Further explanationNoble gas are located in group 18 in the periodic table consisting of helium (He), neon (Ne), argon (Ar), krypton (Kr), xenon (Xe), have a stable electron configuration where the valence electrons are 8(full outer shell of electrons), so it is very hard to react because of its stability
If we look at the periodic system of the elements, the noble gases are on the far right, so that in Figure 8 it is located in area D
And the other region :
A : alkali elements(group 1),
B : alkaline earth elements(group 2)
C : halogen elements(group 17)
Which process is caused by natural selection
Answer:
Four general conditions necessary for natural selection to occur are: More organisms are born than can survive. Organisms vary in their characteristics, even within a species. Variation is inherited.
Answer:
Natural selection can lead to speciation, where one species gives rise to a new and distinctly different species. It is one of the processes that drives evolution and helps to explain the diversity of life on Earth.
Explanation:
When two continental plates of similar
densities collide,
A. they remain level since densities in both plates are equal.
B. they both push back down into the mantle
C. one plate rides over the other one and forms a trench
D.they buckle upward and form mountains
Answer:
D. They buckle upward and form mountains.
Explanation:
When two plates (either oceanic or terrestrial) converge and they are of similar density then they will crash into each other and form mountains. A great example of this is when India crashed into the Asian continent and the Himalayas were formed.
list three things that rely on the Sun as the major source of energy
Answer:
Three things that rely on the sun for energy is coal,oil, and natural gases
Explanation:
We use engery too cook our food that's an example of how gases are used.
We run our cars .Cars use oil.
And we use electricity for lights. You need coal for the electricity
Answer:
*Sun sends oxygen so all living kind (humans, plants, animals etc.) can live
*The sun sends heat to the earth so it wouldnt freeze
*We can use the sun as to create solar energy
Explanation: I hope this helps <3
SOMEONE ANSWER?!!?!?!,!,EMERGENCY Can someone tell me the answer plz plz I’ll give you brainlist and points plz This is my final test No wrong answers
Answer: Should be A)
Explanation:
the size of planets effects the amount of gravitational force each planet has, like jupiter, it has the most gravity.
What happens in this circuit if one of the light bulb burns out?
1. Both light bulbs will stop glowing
2. The other light bulb will stay on but get dimmer
3. the other light bulb will stay on and glow more brightly
4. the battery will lose its charge and stop working
Answer:
option 3
Explanation:
it is so because when both bulbs were there It took more electricity to charge both of them. now since only one is there it takes the power that is produced which made the other bulb glow and uses it for itself.
I'm sorry if u didn't understand
The number placed in front of a compound to balance a chemical reaction is called?
Answer:
coefficients
Explanation:
good luck
(oh no)
What is the mass of silicon when there are 1.8 x 10^21 atoms of silicon?
Answer:
Mass = 0.084 g
Explanation:
Given data:
Mass of silicon = ?
Number of atoms of silicon = 1.8 × 10²¹ atom
Solution:
Avogadro number:
The given problem will solve by using Avogadro number.
It is the number of atoms , ions and molecules in one gram atom of element, one gram molecules of compound and one gram ions of a substance. The number 6.022 × 10²³ is called Avogadro number.
1 mole = 6.022 × 10²³ atoms
1.8 × 10²¹ atom × 1 mole / 6.022 × 10²³ atoms
0.299× 10⁻² mol
0.00299 mol
Mass of silicon:
Mass = number of moles × molar mass
Mass = 0.00299 mol × 28.1 g/mol
Mass = 0.084 g
1. Shankar and Sameer performed an experiment to differentiate primary, secondary and tertiary amines in a laboratory.Shankar correctly identified those 3 compounds but Sameer could only identify primary amine. a) What may be the reagent used by Sameer 1) Ammonical Silvernitrate solution 2) Chloroform & Caustic potash 3) Aqueous Copper Sulphate solution
Answer: 2) Chloroform & Caustic potash
Explanation:
The carbylamine reaction is a kind of chemical test which is done to detect primary amines in an unknown solution. It cannot detect secondary and tertiary amines.
The reaction involves the heating with up of the unknown solution with alcoholic potassium hydroxide or caustic potash and the chloroform.
In the presence of primary amine, the production of isocyanide results.
Write application of isotopes .
Answer:
In the chemical industry.
Isotopes are the atoms of the same element with same atomic no: and different mass numbers. ... ⇒As isotope of uranium is used as a fuel in nuclear reactor. ⇒An isotope of iodine is used in the treatment of goitre. ⇒An isotope of cobalt is used in the treatment of cancer.
What do the three types of mixtures have in common?
(colloid, solution, suspension)
Answer:
A colloid is a heterogeneous mixture in which the dispersed particles are intermediate in size between those of a solution and a suspension. The particles are spread evenly throughout the dispersion medium, which can be a solid, liquid, or gas.
Explanation:
In diamond, each carbon atom is covalently bonded to four other carbons in a
a. Polyhedron
b. Hexagon
c. Pentagon
d. Tetrahedron
Answer:
Tetrahedron
Explanation:
Each carbon atom in a diamond is covalently bonded to four other carbons in a tetrahedron. These tetrahedrons together form a three-dimensional network of six-membered carbon rings in the chair conformation, allowing for zero bond-angle strain.
“True or False”
Unsaturated solution contains the maximum amount of solute dissolved by a given amount of solvent
ANSWER- True
EPLANATION
What would happen if a proton, an electron, and 2 neutrons were removed from Lithium (7)
Answer:
This would give us Helium 4.
Explanation:
Lithium7 has 3 protons, 4 neutrons and 3 electrons.
Removing 1 Proton 1 electron and 2 neutrons would form an element with
2 protons 2 electrons and 2 neutrons.
This is Helium 4.
where are the oldest stars on the hr diagram????
Answer: The oldest stars are found on the top right on the HR diagram. Hope this helps!
The oldest stars on the Hertzsprung-Russell (HR) diagram are located in the lower-right region known as the main sequence turnoff, the stars in the universe can se seen and studied in several ways.
The main sequence turnoff represents the point where stars begin to leave the main sequence and enter different stages of evolution. The position of the turnoff depends on the age of the stellar population being observed. Older stellar populations, such as globular clusters or the halo stars of a galaxy, have turnoffs located at lower luminosities and cooler temperatures.
Learn more about the Hertzsprung-Russell (HR) diagram here
https://brainly.com/question/12484470
#SPJ2
separation methods for coconut oil and water
Answer:
[tex]\huge\mathtt{{\colorbox{silver}{ANSWER~~~↴}}}[/tex]
we use a separating funnel to separate oil from water , we are using funnel because both water and oil both are immiscible liquids.
the process of separation of oil from water is called filtration ✔️
no copied answer :)
▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃▃
How many rings/energy levels would the Bohe model for an element
have if it had 12 electrons?
PLEASE HELP
A 1.25 g sample of aluminum is reacted with 3.28 g of copper (II) sulfate. What is the limiting reactant?
2Al(s) + 3CuSO4(aq) = Al2(SO4)3(aq) + 3Cu(s)
Select one:
a. Copper
b. Aluminum sulfate
c. Aluminum
d. Copper (II) sulfate
Answer:
d. Copper (II) sulfate
Explanation:
Given data:
Mass of Al = 1.25 g
Mass of CuSO₄ = 3.28 g
What is limiting reactant = ?
Solution:
Chemical equation:
2Al + 3CuSO₄ → Al₂ (SO₄)₃ + 3Cu
Number of moles of Al:
Number of moles = mass/molar mass
Number of moles = 1.25 g/ 27 g/mol
Number of moles = 0.05 mol
Number of moles of CuSO₄:
Number of moles = mass/molar mass
Number of moles = 3.28 g/ 159.6 g/mol
Number of moles = 0.02 mol
now we will compare the moles of reactant with product.
Al : Al₂ (SO₄)₃
2 : 1
0.05 : 1/2×0.05=0.025 mol
Al : Cu
2 : 3
0.05 : 3/2×0.05 = 0.075 mol
CuSO₄ : Al₂ (SO₄)₃
3 : 1
0.02 : 1/3×0.02=0.007 mol
CuSO₄ : Cu
3 : 3
0.02 : 0.02
Less number of moles of reactants are produced by CuSO₄ thus it will act as limiting reactant.
Observe Record the appearance (colors,
textures, etc.) of the reactants in the data table.
How many reactants are there?
DONE
Answer:
1
Explanation:
By observing the appearance (colors, textures, etc.) of the reactants in the data one reactant is there.
What is reactant?A reactant is a substance or can say a chemical compound that is present at the start of a chemical reaction. The substance(s) to the right of the arrow are called products.
For example we take a reaction-
O₂(g) + H₂(g) → H₂O(g)
Here, O₂ and H₂ are the reactants and H₂O is the product.
A reactant is present 100% initially and after sometimes it reduces gradually to form product according to chemical kinetics.
Given, the picture shown and the colour and texture of the reactant is shown.
Therefore, By observing the appearance (colors, textures, etc.) of the reactants in the data one reactant is there.
Learn more about chemical reactions, here:
https://brainly.com/question/29039149
#SPJ5
Which answer choice correctly lists only elements?
A
Cl, Na, CH3, Ne
B
Mg, NO2, Mg, B
C
H2O, Li, N, I2
D
N2, O2, Al, Zn
Group of answer choices
A
Answer:
D
Explanation:
Nitrogen^2, Oxygen^2, Aluminum, Zinc
the others have combination
what's the molar mass of Li3p
Answer:
51.79g Li₃P.
Explanation:
Li has a molar mass of 6.94 g (since there are 3, you multiply it 3 times) and P has a molar mass of 30.97 g. 6.94(3) + 30.97 = 51.79g.
A force between an object and the surface it is moving over, is known as what?
power
O velocity
O force
O friction
Select True or False.
The Sun is like the stars we see at night.
False
True
Answer:
yes
Explanation:
Sun is a star not a planet.
Yes true I guess but its just a lot closer
If the producers of the ecosystem below make 14,000 units of energy. How much energy would be available to the very top trophic level?
Answer:
1.4
Explanation took test
Which electron are the valence electrons of the atom?
A. The electrons that have lost their charge
B. The electrons closest to the nucleus
C. The electrons that have entered the nucleus
D. The electrons farthest away from the nucleus
Answer:
D.
Explanation:
The valence electrons are located in the outermost shell.
Electron geometry of the central atom br in brf4+
Answer:
Octahedral
Explanation:
Recall that according to Valence Shell Electron Pair Repulsion Theory(VSEPR) the shape of a molecule is based on the number of electron pairs on the outermost shell of its central atom.
In BrF4^-, the bromine atom is surrounded by 6 electron pairs. Four bond pairs and two lone pairs. This means a total of six regions of electron density.
According to VSEPR Theory, BrF4^- has an octahedral electron geometry and its the molecular geometry will be square planar since it is of the type AX4E2.
An image of the BrF4^- is attached below.
The more variation in a species, the less likely the chance that species has of surviving. true or false
Answer:
The more variation in a species, the less likely the chance that species has of surviving. false
Explanation:
As species have heritable variation the species produce more offsprings that can survive and offsprings within a favorable variation are more likely to survive and reproduce. Hence favorable variation makes the species diverse and more in population. Thus greater are the chances of survival, a decrease in diversity will lead to a decline in variability, and fewer chances of survival.Do sulphates react with acids
no it cannot I hope I helped
Answer:
Can not
Explanation:
Because both are salts of sodium and hydroxide
What are the flocculation basins?
Answer:
Flocculation is the operation in which the coagulated water must be gently mixed at a propeller speed of 15 to 20 rpm to promote the growth of the floc. ... The flocculation basin often has a number of compartments with decreasing mixing speeds as the water advances through the basin.
Which of the following best describes spectator ions? A. that do not participate in the reaction B. lons made when compounds dissolve in water C. that are made of a single element D. Ions that combine to form a precipitate
Answer: A. that do not participate in the reaction
Answer:
a
Explanation:
a p e x :)