Answers
Answer:
Gravity will always be pulling everything towards Earth's center at an acceleration of 9.81 m/sec².
Related Questions
need little help pls
Answers
Answer:
0.354 molal
Explanation:
The molarity (M) or the concentration of a solution is defined as the number of moles of a compound in the solution per liter of solution (mol/L), whereas molality, is defined as the number of moles of a compound in the solution per kg of the compound (mol/kg).
Given that the density of the solution is 1.202 g/mL, which is equivalent to 1.202 kg/L. Since the prefix mili- denotes a factor of one thousandth ( [tex]10^{-3}[/tex] ) and kilo- denotes a factor of one thousand ( [tex]{10}^3[/tex] ),
[tex]1.202 \ \frac{g}{mL} \ = \ 1.202 \ \frac{g}{(10^{-3}) L} \ = \ 1.202 \ \frac{{10}^3g}{L} \ = \ 1.202 \ \frac{kg}{L}[/tex].
To calculate the corresponding molality of the solution, the formula
[tex]Molality \ (mol/kg) \ = \ \frac{Molarity \ (mol/L)}{Density \ (kg/L)}[/tex] is used.
Therefore,
[tex]Molality \ = \ \frac{0.426 \ mol/L}{1.202 \ kg/L} \ = \ 0.354 \ mol/kg \ \ (3 \ s.f.)[/tex]
How to find total mass of water in final solution
Answers
Answer:
Explanation:
Just like a solid, the density of a liquid equals the mass of the liquid divided by its volume; D = m/v. The density of water is 1 gram per cubic centimeter.
All of the following compounds are soluble in water EXCEPT
a
MgSO4
b
Ca(NO3)2
с
Agi
d
K2CO3
Answers
Answer:
Anser is C Agl
Explanation:
Agl does not dissolve in water.
All of the following compounds are soluble in water except AgI because of very high value of lattice energy. Therefore, the correct option is option C.
The capacity of a material, the solute, to combine with a different material, the solvent, is known as solubility in chemistry. Insolubility, or the solute's inability to create such a solution, is the opposite attribute. The concentration for the solute within a saturated solution—a solution where no more of the substance can be dissolved—is typically used to gauge the degree of a substance's solubility in a particular solvent. The two compounds are considered to be at the point of solubility equilibrium at this time. All of the following compounds are soluble in water except AgI because of very high value of lattice energy.
Therefore, the correct option is option C.
To know more about lattice energy, here:
https://brainly.com/question/29735933
#SPJ6
( picture ) identify each type of reaction shown below
Answers
it wouldnt let me type it because it said it was too inappropriate
Explanation:
Van der Waals bonds initiate
a) Between non-metals
b) Within ionic binds
c) Between metals
d) With H-bond
e) All of the above
Answers
I think e no
I am giving you hint
what is oxidation number on Ni in the next compound
K2[NiBr6] ???
Answers
Explanation:
The oxidation number of Ni is +4
please help me and promise I will mark as brainiest I need it in ISEF please
how much energy does the vehicle hydrogen fuel cell need to break hydrogen into ions ?!
Answers
Answer: A typical hydrogen fuel cell produces 0.5 V to 0.8 V per cell. To increase the voltage individual cells can be connected in series.
What is the lowest frequency photon that can ionize a hydrogen atom with excited state electron configuration 3s^1?
Answers
Calculate the emf of the following concentration cell: Au(s) | Au3+ (0.10 M) || Au3+ (0.50 M) | Au(s)
Answers
The emf of the cell as written is calculated to be 0.014 V.
Using the Nernst equation;
Ecell = E°cell - 0.0592/n log Q
We must note that E°cell = 0 because the anode and cathode are composed of the same type of metal.
Now;
Substituting values, we have;
Ecell = 0 - 0.0592/3 log (0.50 M)/(0.10 M)
Ecell = 0.014 V
Learn more: https://brainly.com/question/15394851
Which element on the periodic table is the lowest mass in period 4??
Answers
Answer:
potassium I believe is the correct answer
Explanation:
Potassium is the period four element with the lowest mass; its average mass is 39.0983amu.
The fourth period of the periodic table is where potassium has its lowest atomic mass.
What is atomic mass?Atomic mass is defined as the combined mass of an atom's protons, neutrons, and electrons. The term "atomic mass" refers to the weight of an atom or molecule. To determine the average mass of elements and molecules as well as to resolve stoichiometry issues, the atomic mass is used.
An electrically neutral atom has an equal number of protons and electrons. As a result, using any of the two formulas, we may calculate the atomic mass of an element. The atomic mass of an element grows as we move from left to right in a period of the periodic table. In the fourth period of the current periodic table, Krypton has the highest atomic mass and potassium has the lowest.
Thus, the fourth period of the periodic table is where potassium has its lowest atomic mass.
To learn more about atomic mass, refer to the link below:
https://brainly.com/question/17067547
#SPJ2
What other scientific fields are
included in earth science?
Answers
How could you distinguish a compound from a mixture
Answers
Answer:
Compound are substances which can be formed by chemically combining two or more elements. Mixtures are substances that are formed by physically mixing two or more substances.Which statement describes a homogeneous catalyst?
It is in a gaseous phase only.
It is in the same phase as the reactants.
It is completely consumed by reactants.
It forms different products than the uncatalyzed reaction forms.
Answers
Answer:
it is in the same phase as the reactants
The statement describes a homogeneous catalyst is,
It is in the same as the reactants.So, option B is correct one.
What is homogeneous catalyst?The homogeneous catalyst is refer to catalytic system.In this, the phase of substrates for a reaction and catalytic components are same.Mainly it is in liquid phase.Example: Production of acetic acidWhat is catalyst?
The substance which increases the rate of the reaction without being itself change at the end of the reaction is called catalyst.
learn about homogeneous catalyst,
https://brainly.com/question/4249142
#SPJ2
what layers of protection can be used tot detect and respond to abnormal reactions or process conditions
Answers
In the body, the main protective layer is known as the epithelium, this can be found in the skin as well as other organs such as the lungs.
The body is often exposed to external factors that can damage it; due to this, throughout evolution, most animals and multicellular organisms have developed protective mechanisms.
In the case of humans and other animals, the protective layer is known as the epithelium, which is composed of epithelial cells. This protective layer can be found internally and externally.
External layer: This is the first protective layer, commonly known as skin, this layer protects the inner organs from extreme temperatures, changes in pressure, etc.
Internal layer: Organs such as the lungs or the ones in the gastrointestinal system are all covered by a thin epithelial layer that helps each organ to be protected.
Learn more about skin in: https://brainly.com/question/12057617
Explain the verse below in your own words in a little summary.
Hebrews 11:7
Answers
God had warned Noah of the flood and directed him to build an ark. Noah had faith in God and began building.
Answer:
God Warned Noah for the Flood comindg to Earth to wash away all the bad people's lives and god also said get couple animals girls and boys then build an ark then bring your family and food there to then noah had a faith in god so he obey and start builind the ark in a top of a mountain
Explanation:
Hebrews 11:7
I’m not sure if it’s the square on the right or left. Please help
Answers
Answer:OK im not 100% sure but it should be the right one
Explanation:
the normal human eye responds to visible light of wavelength range from about 390 to 710nm. Determine the frequency range of the human eye.
Answers
Explanation:
=>7.7 x10¹⁴ to 4.2 x10¹⁴Hz
Which property is the same for a 50 mL sample of liquid water and a 100 mL sample of liquid water?
Answers
Answer: The density because it stays the same with any same liquids or solids or gas with whatever amount of it is added. It only changes if the matter of state is different or there is any environmental change.
Check all of the following below which describe experimental errors that would affect the percent chloride you report in your experimental results: ____________
a) The solid product was wet when you weighed the final mass
b) You added excess silver nitrate into the reaction mixture
c) The liquid collected from the filtration was cloudy
d) The transfer from the reaction beaker to the filter funnel was imperfect (you lost some of the reaction solution or some was left in the beaker)
e) Extra water was used to dissolve the original unknown solid
Answers
The options that describe the experimental errors that would affect the percent of chloride reported are:
B (You added excess silver nitrate into the reaction mixture) and D (The transfer from the reaction beaker to the filter funnel was imperfect).While performing experiments, there are some errors that occur which are generally known as experimental errors.
These experimental errors are the difference between the true measurement and what we measured.
There are three types of experimental errors they include:
systematic, random, and human error.Human errors occur due to carelessness of the observer.
Examples are:
when you added excess silver nitrate into the reaction mixture when the transfer from the reaction beaker to the filter funnel was imperfect due to lost of some of the reaction solution.Therefore, the options describe the experimental errors that would affect the percent of chloride reported are B and D.
Learn more about experimental errors here:
https://brainly.com/question/2764830
What is the correct form of the equilibrium constant for the reaction of hydrogen and oxygen to form water? The equation is:
2H 2( g) + O 2( g) ⇌ H 2O( g)
Kc = ([H2O]/[O2] [H2])
Kc = ([H2O]/[O2] [H2]2)
Kc = ([H2O]/[O2] [H22])
Kc = ([H2O]2/[O2] [H22])
Kc = ([H2O]/[O2] [2H2])
Answers
the second one.
A student wants to determine the melting point of water as part of an investigation into the strength of electrostatic forces. The student considers determining the freezing point of water instead. Is this a valid option?
Answers
According to the forces of attraction freezing point and boiling point of water are different and are not related to strength of electrostatic forces.
What are forces of attraction?
Forces of attraction is a force by which atoms in a molecule combine. it is basically an attractive force in nature. It can act between an ion and an atom as well.It varies for different states of matter that is solids, liquids and gases.
The forces of attraction are maximum in solids as the molecules present in solid are tightly held while it is minimum in gases as the molecules are far apart . The forces of attraction in liquids is intermediate of solids and gases.
The physical properties such as melting point, boiling point, density are all dependent on forces of attraction which exists in the substances.
Learn more about forces of attraction,here:
https://brainly.com/question/23841038
#SPJ2
USCTIR ENFIK meaning?
Answers
Answer:
la branche de la mécanique concernée par le mouvement des objets sans référence aux forces qui provoquent le mouvement
Answer:
the features or properties of motion in an object.
A 4.190 g sample of an oxide of chromium contains 2.179g of chromium, what is its empirical formula?
a. CrO2
b. Cr2O
c. CrO3
d. Cr2O3
Answers
I'm not sure but I think it is C. CrO3
why is it important to use compound fixative in histology
Answers
Answer:
To prevent autolysis (enzymes attack) as well as putrefaction (bacterial attack) of tissues.
Find the volume of 8 gram of oxygen gas
Answers
So 16 g of oxygen contains = N atoms of Oxygen.
{ N= Avagadro number= 6.022 x 10²³}
So 8 g of Oxygen contains= N/2 ATOMS of Oxygen
=6.022x10²³/2
= 3.011 x10²³ atoms
Number of moles of O
2
=
32
8
=
4
1
=0.25
Volume of 1 mol of O
2
at STP =22.4 L
∴ Volume of 0.25 mol of O
2
at STP =22.4×0.25=5.6 L
What was the name of the original supercontinent that wegener proprosed in his theory
Answers
Answer:
pangea
Explanation:
Mole problems. See the image for reference. Please show your work.
Answers
Look at the diagram of 2 basic cell types. Which of the following describes cell 2?
A) a plant cell
B) an animal cell
C) a eukaryote cell
D) a prokaryote cell
Answers
Draw the Lewis structures for
Calcium bromide, CaBr2
Answers
The Lewis structure is the way of expressing the covalent bonding in molecules. The covalent bond formation takes place by the sharing of electrons in a molecule.
What is Lewis structure?In Lewis dot structures or simply the Lewis structures, the dots are used to represent the electrons. They provide a picture of bonding in molecules in terms of the shared pair of electrons and the octet rule.
The concept of covalent bond is introduced by the scientist G.N Lewis. According to him, the atoms achieve stable octet when they are linked with each other by sharing of one more pairs of electrons. The covalent bonding occurs between the atoms which do not differ much in their electronegativity.
The Lewis structure of CaBr₂ is denoted below. Here two bromine atoms acquires a stable electronic configuration by sharing electrons. There are two single bonds between them.
To know more about Lewis structure, visit;
https://brainly.com/question/20300458
#SPJ5
Which muscles is most important to you and why?
Answers
Answer:
cardiac muscle
Explanation:
because they help the heart to pump blood to all parts of the body
Answer:
Muscle is also very important to everyone because we need our muscles to survive. The HEART is the strongest muscle in our body and is always looking to get stronger. Muscles enable us to be active and exercise. Our strength comes for our muscles and how much they are used.
Explanation:
#Carryonlearning