Which salt preparation uses a burette and a pipette

Answer:

Explanation:

The equation we use to calculate the volume needed to prepare other [tex](C_1,V_1)[/tex] the solution that has a concentration [tex]C_2[/tex]  and volume [tex]V_2[/tex]  is:

[tex]C_1V_1 =C_2V_2[/tex]

[tex]V_1=\dfrac{C_2V_2}{C_1}[/tex]

where;

[tex]C_1[/tex]= concentration of the first solution

[tex]V_1[/tex] = volume of the first solution

[tex]C_2[/tex] = concentration of the second solution

[tex]V_2[/tex] = volume of the second solution

2) Reduction half cell reaction for the copper (II) ion is:

[tex]Cu^{2+} + 2e^- \to Cu[/tex]

3) [tex]Cu^{+2} + 2e^- \to Cu \text{ \ \ \ E = 0.3370}[/tex]

[tex]Zn^{+2} + 2 e^- \to Zn \ \ \ \ \ \ E = -0.763[/tex]

[tex]Zn \to Zn^{+2} + 2 e^- \ \ \ \ \ \ E = +0.763[/tex]

Since the reduction potential of Cu is more; it means copper will go into reduction and zinc will undergo oxidation.

Standard Potential =[tex]E^0_{left} - E^0_{right}[/tex]

[tex]= -0.763 -0.337[/tex]  ( since both are reduction potential)

[tex]\mathbf{E^0_{cell} = -1.100 volt}[/tex]

Answer:

C

Explanation:

because then you'd be able to make a group to raid, run with you, and save more people.

Answer:1 2 and 4

Explanation:

Answer:

No,  22.09%  is not a valid measurement

Explanation:

Precision has to do with how close a given set of measured values are to each other. It is quite different from accuracy. Accuracy refers to how close a given set of values is to the true value. A given set of values may be precise but not accurate and vice versa.

If we look at the values obtained;  22.09%,  22.15%, 22.18%, 22.23%, 22.25%, the value 22.09% is too far off the other values. This implies that it does not represent a valid measurement since it is not close to all the other values obtained.

1. The standard cell potential for this reaction is 0.14 V.

2. The standard cell potential for this reaction is 0.46 V.

3. The reduction potential for Hg2+(aq) + 2e^- → Hg(l) is 0.79 V.

1. The half-reactions are:

Oxidation: Sn2+(aq) → Sn(s) + 2e^-

Reduction: Pt2+(aq) + 2e^- → Pt(s)

To balance the charges, we multiply the oxidation half-reaction by 2:

2Sn2+(aq) → 2Sn(s) + 4e^-

Now, we can combine the half-reactions to form the overall cell reaction:

2Sn2+(aq) + Pt2+(aq) → 2Sn(s) + Pt(s)

The cell notation for this reaction is:

Sn(s) | Sn2+(aq) || Pt2+(aq) | Pt(s)

To calculate the standard cell potential (E°), we can look up the reduction potentials for each half-reaction. The reduction potential for Pt2+(aq) + 2e^- → Pt(s) is typically listed as 0.00 V. The reduction potential for Sn2+(aq) + 2e^- → Sn(s) is -0.14 V. The standard cell potential is the sum of the reduction potentials:

E° = E°(reduction) - E°(oxidation)

E° = 0.00 V - (-0.14 V) = 0.14 V

2. The half-reactions are:

Oxidation: Co2+(aq) → Co(s) + 2e^-

Reduction: Cr3+(aq) + 3e^- → Cr(s)

To balance the charges, we multiply the reduction half-reaction by 2:

2Cr3+(aq) + 6e^- → 2Cr(s)

Now, we can combine the half-reactions to form the overall cell reaction:

Co2+(aq) + 2Cr3+(aq) + 6e^- → Co(s) + 2Cr(s)

The cell notation for this reaction is:

Co(s) | Co2+(aq) || Cr3+(aq) | Cr(s)

To calculate the standard cell potential (E°), we look up the reduction potentials for each half-reaction. The reduction potential for Co2+(aq) + 2e^- → Co(s) is typically listed as -0.28 V. The reduction potential for Cr3+(aq) + 3e^- → Cr(s) is -0.74 V. The standard cell potential is the sum of the reduction potentials:

E° = E°(reduction) - E°(oxidation)

E° = -0.28 V - (-0.74 V) = 0.46 V

3. The half-reactions are:

Oxidation: Cr2+(aq) → Cr(s) + 2e^-

Reduction: Hg2+(aq) + 2e^- → Hg(l)

The balanced overall cell reaction is:

Cr2+(aq) + 2Hg2+(aq) + 4e^- → Cr(s) + 2Hg(l)

The cell notation for this reaction is:

Hg(l) | Hg2+(aq) || Cr2+(aq) | Cr(s)

To calculate the standard cell potential (E°), we look up the reduction potentials for each half-reaction. The reduction potential for Cr2+(aq) + 2e^- → Cr(s) is typically listed as -0.91 V.

For more such question on reaction. visit :

https://brainly.com/question/11231920

#SPJ8

Answer:Scientists have identified more than 260,000 kinds of plants. They classify plants according to whether they have body parts such as seeds, tubes, roots, stems, and leaves. The three main groups of plants are seed plants, ferns, and mosses.

Explanation:

hope i help

They can be replenished fast.

Answer:

iron and chlorine

Explanation:

Answer:

Life in the Han Dynasty (206 BCE - 220 CE) differed significantly from today in family, government, social structure, religion, and trade. For example, the Han Dynasty emphasized a patriarchal family structure, where the eldest male held authority, and filial piety was highly valued. In contrast, contemporary societies embrace more egalitarian family dynamics with shared decision-making.

The government system of the Han Dynasty relied on a centralized bureaucracy and emphasized meritocracy, while modern societies often adopted democratic systems. Socially, the Han Dynasty followed a hierarchical model influenced by Confucian principles, whereas contemporary societies strive for greater equality and social mobility.

Religion in the Han Dynasty combined Confucianism, Taoism, and Buddhism, whereas modern societies exhibit diverse religious beliefs. Lastly, trade in the Han Dynasty thrived along the Silk Road, while modern trade was globally interconnected and facilitated by technological advancements. These differences highlight the evolution of society over time.

Explanation:

Answer:

1.75 g HCl

Explanation:

First we convert 2.00 g of PCl₅ into moles, using its molar mass:

Then we convert PCl₅ moles into HCl moles, using the stoichiometric coefficients of the equation:

Finally we convert HCl moles into grams, using its molar mass:

Answer:

The answer is agriculture.

Explanation:

Answer: Agriculture

Explanation:

I got it right on my exam

Answer:

[tex]T_F=17.56\°C[/tex]

Explanation:

Hello there!

In this case, for this calorimetry problem, it is possible for us to realize that the heat lost by the hot silver is gained by the cold far whose specific heat is 3.94 J/g°c, so we can write:

[tex]-Q_{Ag}=Q_{fat}[/tex]

Which can be written in terms of mass, specific heat and temperature as shown below:

[tex]-m_{Ag}C_{Ag}(T_F-T_{Ag})=m_{fat}C_{fat}(T_F-T_{fat})[/tex]

In such a way, solving for the final temperature, we obtain:

[tex]T_F=\frac{m_{Ag}C_{Ag}T_{Ag}+m_{fat}C_{fat}T_{fat}}{m_{Ag}C_{Ag}+m_{fat}C_{fat}}}[/tex]

Then, we plug in the given data to obtain:

[tex]T_F=\frac{14.16g*0.2165J/g\°C*133.5\°C+250g*3.94J/g\°C*17.20\°C}{14.16g*0.2165J/g\°C+250g*3.94J/g\°C} \\\\T_F=17.56\°C[/tex]

Best regards!

Answer:

5.56 x 10^23

Explanation:

Just convert and cancel out.

85 g N2O4 x 1 mol/92.01 g x 6.02 x 10^23 molecules /1 mol

Answer:

1. Electron-deficient molecules

2. Odd electron molecules

3. Expanded valence shell molecules

Explanation:

Answer:

0.29 atm

Explanation: add both partial pressure and subtract from total pressure

Answer:

A)Renewable Energy Sources

Explanation:

Answer:

c and d

Explanation:

mitochondria and vacoule

Answer:

It is actually D and A

Explanation:

I took this assignment before on edge and the guy who said C and D is wrong

Answer:

12 M

Explanation:

The reaction between HNO₃ and KOH is:

First we calculate how many KOH moles reacted with the diluted HNO₃ sample, using the given volume and concentration:

As 1 KOH mol reacts with 1 HNO₃ mol, in 25 mL of the diluted HNO₃ solution there are 30 HNO₃ mmoles.

With that information in mind we can calculate the HNO₃ concentration in the diluted solution:

Finally we can use the C₁V₁=C₂V₂ formula to calculate the concentration of the original solution:

Answer:

So confusing but I'll try

Answer:

The answer is "2.459".

Explanation:

The cell potential or emf norm  = oxidation pot. of anode -oxidation pot. of cathode

When the pot oxidizer is the opposite of a red pot size it's been transformed to either the redox reaction so that anode was its higher oxide pot material that means (AL) so,

[tex]\to emf=1.66-(-0.799) \\\\ \to emf=1.66+0.799) \\\\ \to emf =2.459[/tex]

Answer:

Nitrogen cycle

Explanation:

Answer: 1 mole =  6.02 x 10^ 23

Explanation:

The number of atoms in one mole of helium is equal to 6.022×10²³ He atoms.

Avogadro’s constant can be demonstrated as the proportionality factor that utilizes to count the number of particles such as ions, molecules, atoms, or ions in a sample of the substance.

Avogadro's number can be defined as the approximate count of nucleons in 1 gram of substance. The value of the Avogadro number is the mass of 1 mole of a compound, in grams, and is the number of nucleons in one particle.

The value of Avogadro’s number is equal to 6.022×10²³ per mole.

Given, the number of moles of the helium = 1 mol

Helium is a monatomic gas so it contains only one atom in its one molecule.

The number of atoms of Helium in one mole = 6.022 × 10²³

Therefore, the total number of atoms contained in a 1 mole sample of

helium is 6.022 × 10²³.

Learn more about Avogadro's number, here:

brainly.com/question/11907018

#SPJ6

Answer:

C

Explanation:

It is run by Elon Musk, who is determined to get to Mars.

Answer:

2. m = 426.6 gr

4. m = 143 gr

Answer:

1.34 mol

Explanation:

Molarity, which is the molar concentration of a solution, can be calculated by dividing the number of moles (n) by the volume (V).

That is;

Molarity (M) = n/V

According to the information provided in this question;

M = 2.40M

V = 56.0 mL = 56/1000 = 0.056 L

Since molarity = n/V

number of moles = M × V

n = 0.056 × 24

n = 1.34 mol

The percent by mass of nitrogen in ammonia (NH3) is approximately 82.15%

Calculating the mass of nitrogen to the total mass of the compound and then expressing the result as a percentage will allow us to determine the percent by mass of nitrogen in NH3 (ammonia).

Ammonia's molecular structure, NH3, indicates that it is made up of one nitrogen atom (N) and three hydrogen atoms (H). We must take both the molar masses of nitrogen and ammonia into account when calculating the percent by mass of nitrogen.

Nitrogen's (N) molar mass is roughly 14.01 g/mol. The molar masses of nitrogen and hydrogen are added to determine the molar mass of ammonia (NH3). Since hydrogen's molar mass is around 1.01 g/mol, ammonia's molar mass is:

(3 mol H 1.01 g/mol) + (1 mol N 14.01 g/mol) = 17.03 g/mol = NH3.

Now, we can use the following formula to get the nitrogen content of ammonia in percent by mass:

(Mass of nitrogen / Mass of ammonia) / 100% is the percentage of nitrogen by mass.

Ammonia weighs 17.03 g/mol and contains 14.01 g/mol of nitrogen by mass. By entering these values, we obtain:

(14.01 g/mol / 17.03 g/mol) 100% 82.15 % of nitrogen by mass

Ammonia (NH3) has a nitrogen content that is roughly 82.15 percent by mass.

For more questions on mass
https://brainly.com/question/24191825
#SPJ8