Which one of the following is an example of an acid-base reaction?
A. 2HCl + Mg(OH)2 + 2H2O + MgCl2
B. Fe + CuSO4 → FeSO4 + Cu
C. 2Li + ZnSO4 → Li2SO4 + Zn
O D. C5H12 + 802 - 5CO2 + 6H20
No links please

Answer:

[tex] |d| = |(25 - 15)| \\ |d| = 10 \: m[/tex]

Answer:

The speed at which a planet orbits the Sun changes depending upon how far it is from the Sun. When a planet is closer to the Sun the Sun’s gravitational pull is stronger, so the planet moves faster. When a planet is further away from the sun the Sun’s gravitational pull is weaker, so the planet moves slower in its orbit.

Answer:

skateboard mid-ollie is being actively steered. This is exactly what makes doing an ollie so hard. It's not enough to get the skateboard up into the air - you also have to steer it while it's in the air. You should keep your hands up in the hair a bit to help with balance, scrunch your legs a bit down to have a proper and effective jump. wear nee pads incase you dont fix the landing. Practice jumping on ur skate board tho, if u jump at it without knowing much youll just get hurt.

Explanation:

Answer:

60N

Explanation:

force = mass * acceleration

force = 12 * 5

force =60N

Answer:

I think it is Potential energy is stored energy

Explanation:

Answer:

potential energy is stored energy, to my knowledge

Answer:

The actual answer would be c, oxygen.

Explanation:

Plants need the energy glucose provides in order to grow and reproduce. Glucose is also required for the process of cellular respiration, in which plants convert carbon dioxide from the air into oxygen.

A weally works when you pull something and a axle is something that you can push

Explanation:

I hope this helps

Answer:

X-ray Telescope

Explanation:

X-ray Telescope which can be either hard or soft is an instrument on an orbiting satellite that would detect the flare first.

This is because X-ray Telescope is technically designed to detect and determine X-rays or radio and optical emissions from flares, from places or points beyond Earth's atmosphere.

Answer:

Because it's wattage is 500W.

Explanation:

This is its mearurement

Answer:

Wait what is the distance of the water from the br

The speed of the penny drops of a bridge just before it hits the water is 11.76 ms⁻¹.

Given,

Time, t = 1.2 s

The initial velocity (u), final velocity (v), acceleration (a), displacement (s), and time (t) of an object traveling with constant acceleration are related by the first equation of motion, often known as the first kinematic equation or the equation of motion with constant acceleration.

From the first equation of motion:

v = u + at

Since the initial velocity is zero. The final velocity is:

v = at

v = (9.8 ) × (1.2 s)

v = 11.76 ms⁻¹

Hence, the speed of the penny drops of a bridge just before it hits the water is 11.76 ms⁻¹.

To learn more about Speed, here:

https://brainly.com/question/17661499

#SPJ4

Answer:

 #_electrons = 2 10¹⁰ electrons

Explanation:

For this exercise we can use a direct rule of three proportions rule. If an electron has a charge of 1.6 10⁻¹⁹ C how many electrons have a charge of 3.2 10⁻⁹ C

          #_electrons = 3.2 10⁻⁹ ( [tex]\frac{1}{1.6 \ 10^{-19}}[/tex])

          #_electrons = 2 10¹⁰ electrons

Answer:

a) The work done by the force is 720 joules, b) The power supplied by the force is 138 watts.

Explanation:

a) Since force is uniform and parallel to the direction of motion, the work ([tex]W[/tex]), in joules, done by the force ([tex]F[/tex]), in newtons, is defined by this formula:

[tex]W = F\cdot s[/tex] (1)

Where [tex]s[/tex] is the travelled distance, in meters.

If we know that [tex]F = 60\,N[/tex] and [tex]s = 12\,m[/tex], then the work done by the force is:

[tex]W = F\cdot s[/tex]

[tex]W = (60\,N)\cdot (12\,m)[/tex]

[tex]W = 720\,J[/tex]

The work done by the force is 720 joules.

b) And an expression for the power supplied by the force ([tex]\dot W[/tex]), in watts, is concieved by differentiating (1) in time:

[tex]\dot W = F\cdot \dot s[/tex]

Where [tex]\dot s[/tex] is the speed of the wagon, in meters per second.

If we know that [tex]F = 60\,N[/tex] and [tex]\dot s = 2.3\,\frac{m}{s}[/tex], then the power supplied by the force is:

[tex]\dot W = F\cdot \dot s[/tex]

[tex]\dot W = (60\,N)\cdot \left(2.3\,\frac{m}{s} \right)[/tex]

[tex]\dot W = 138\,W[/tex]

The power supplied by the force is 138 watts.

Answer:

0.1m/s²

Explanation:

Using the equation of motion

V = u+at

V is the final speed = 0.9m/s

Initial speed u = 0.5m/s

Time = 4secs

Get the acceleration

0.9 = 0 5+4a

0.9-0.5 = 4a

0.4 = 4a

a = 0.4/4

a = 0.1m/s²

Hence the acceleration is 0.1m/s²

Answer:they are a renewable source

Explanation: because they come from the ocean and the ocean is 75% of the world so there will always be waves.

Answer:

Mount Everest is Earth's highest mountain above sea level, located in the Mahalangur Himal sub-range of the Himalayas. The China–Nepal border runs across its summit point. Its elevation of 8,848.86 m was most recently established in 2020 by the Nepali and Chinese authorities.

Explanation:

Answer:

the speed of the waves is 150 cm/s

Explanation:

Given;

frequency of the wave, f = 10 Hz = 10

distance between 4 nodes, L = 15.0 cm

The wavelength (λ) of the wave is calculated as follows;

Node to Node = λ/2

L = 2(Node to Node) = (4 Nodes) = 2 (λ/2) = λ

Thus, λ = L = 15.0 cm

The speed (v) of the wave is calculated as follows;

v = fλ

v =  10 Hz   x  15.0 cm

v = 150 cm/s

Therefore, the speed of the waves is 150 cm/s

Answer:

the impulse experienced by this object is 4 Ns

Explanation:

Given;

mass of the object, m = 3 kg

velocity of the object, v = 4 m/s

resistive force, F = 20 N

duration of impact, t = 0.2 s

The impulse experienced by this object is calculated as follows;

J = F x t

J = 20 x 0.2

J = 4 Ns

Therefore, the impulse experienced by this object is 4 Ns

Answer:

[tex] \infty \infty [/tex]

Answer:

Distance

Explanation:

Because each path you take will have a different distance. Each path will be different, leading to a different distance. Hope this helped :D

Answer:

  [tex]\frac{Y}{Y_o}[/tex] = 2/3

Explanation:

The yuong modulus of a rod is defined as the relationship between the tensile strength and the strain

         Y =  [tex]\frac{ \frac{F}{A} }{\frac{\Delta L}{L_o} }[/tex]

let's use the subscript "o" for rod A

         I = [tex]\frac{ \frac{F}{A_o} }{ \frac{\Delta L}{L_o} }[/tex]

tells us that rod B has

         A = 3 A₀

         L = 2 L₀

we substitute

         Y = [tex]\frac{ \frac{F}{A} }{ \frac{\Delta L}{L} }[/tex]

          Y = [tex]\frac{ \frac{F}{3A_o} }{ \frac{\Delta L}{ 2L_o} }[/tex]

         y = ⅔  [tex]\frac{ \frac{F}{A_o}}{ \frac{\Delta }{L_o} }[/tex]

substituting the value of Y₀

          Y = ⅔  Y₀

           [tex]\frac{Y}{Y_o}[/tex] = 2/3

Answer:

A path that allows most of the current in an electric circuit to flow around or away from the principal elements or devices in the circuit.

Answer:

every object will remain at rest or in uniform motion in a straight line unless compelled to change its state by the action of an external force.

Explanation:

Answer:

140

hope this helps

have a good day :)

Explanation:

Answer:

24kgm/s

Explanation:

momentum(p)=mass×velocity

=6×4

=24 kgm/s

Raising the temperature results in the radiator giving off photons of high-energy ultraviolet light. As heat is added, the radiator emits photons across a wide range of visible-light frequencies

Answer:

Hooke's law can be written as:

F = -k*Δx

Where k is a constant that depends on the spring, called the spring constant.

And Δx = (x - x₀) is the displacement of the spring with respect to the rest position x₀

And a proportional equation is something like:

y = c*x

Where c is a constant of proportionality.

In the case of Hooke's law, the constant is K, then the force is proportional to the displacement of the spring with respect to the rest position Δx.

Answer:

A. Moon

Explanation:

The Moon is hundreds of thousands of miles away from the Earth while the other options are hundreds of millions of miles away.

Answer:

it would decrease to one half your original weight

Explanation: