Answer:
the second one is correct
Explanation:
Explanation:
» If the net force on an object is zero, its velocity will remain constant
what is the largest, low-cost airline carrier in the world, which recently canceled thousands of flights for reasons partially disputed by the federal aviation administration?
The largest, low-cost airline carrier in the world that recently canceled thousands of flights for reasons partially disputed by the federal aviation administration (FAA) is Southwest Airlines.
Southwest Airlines canceled 2,500 flights in just a few days.
According to Southwest Airlines, the cause of the cancellation is due to air traffic control problems and disruptive weather.
While FAA claimed that nothing like a reported case of air traffic and staffing shortages.
Southwest Airlines is the world's largest low-cost carrier and has its main office is located in Dallas, Texas.
Hence, in this case, it is concluded that the correct answer is "Southwest Airlines."
Learn more here: https://brainly.com/question/24782945
on some early automobiles both headlights went out when one bulb burned out. the headlights must have been connected in
what year is gas powered cars expected stop being produced
Answer:
2035
Explanation:
The governors of a dozen U.S. states including California, New York, Massachusetts and North Carolina called on President Joe Biden on Wednesday to back ending sales of new gasoline-powered vehicles by 2035, a dramatic shift away from fossil fuels.
Answer:(:
Explanation:
Joe Biden on Wednesday to back ending sales of new gasoline-powered vehicles by 2035, a dramatic shift away from fossil fuels
describe how you could engineer the situation to produce even more friction and heat
To select the proper twist drill, one should check
оа
drill speed
Ob
size, sharpness and type of shank
ос
length of the drill cutting lips
Od
lubrication needed
Answer:
OB. size, sharpness and type of shank.
Explanation:
Hope this is helpful if not sorry :(
2. How were scientists able to access a car's computer system?
3. What other looming dangers are there for drivers of newer, computer controlled
in the multiple pipe system shown below, which of the following is true concerning the linear system?.
Answer:
maybe
Explanation:
th liner pupe us it it had ore moecuke and tepiract
what kind of abilities are needed to run a business
Answer:
Essential business skills:
1. Financial management. Being able to effectively manage your finances is critical. ...
2. Marketing, sales and customer service. ...
3. Communication and negotiation. ...
4. Leadership. ...
5. Project management and planning. ...
6. Delegation and time management. ...
7. Problem solving. ...
8. Networking.
Which of these is NOT one of the four A’s of defensive driving?
Answer:
It's called The LLLC Defensive Driving Principles™, but we just call it “Triple-L-C.” Using the Four Driving Principles of Safety, Look Ahead, Look Around, Leave Room, and Communicate, gives you the time and information you need to avoid an accident and be an all-around better driver.
.Name the control group ___________________________ 2.Name the experimental group ____________________ 3.Name the independent variable __________________ 4.Name the dependent variable __________
Answer:
please
Explanation:
what is the story
Technician A says that the connecting rod and main bearing caps should be marked before removing to ensure that they can be installed in the exact same location when reassembled. Technician B says that the tip of the valve stem should be filed before removing valves from the cylinder head to help prevent damage to the valve guide. Who is right
Answer:
Technician A
Explanation:
This is because when the dimacations are made, the surface area and length respectively can be maintained to reduce to idea of force which may lead to damage
Which of these systems creates and delivers high voltage sparks at the right time to ignite the air-fuel
mixture in the combustion chamber?
Answer: Ignition System
Explanation:
Ignition System is the systems creates and delivers high voltage sparks at the right time to ignite the air-fuel mixture in the combustion chamber.
What are the 3 types of ignition systems?Automotive ignition systems can be categorised: coil-on-plug, distributor-based, and distributor-free (COP). Early ignition systems delivered the spark at the appropriate time using entirely mechanical distributors.
Thus, it is Ignition System
For more details about types of ignition systems, click here:
https://brainly.com/question/14094081
#SPJ2
BTSAUDY5 NAME STARTS FROM THIS
Why do you think Construction is desirous of a gender mixed work force
Answer:
According to the Bureau of Labor Statistics, only 9.9% of construction professionals are women. In regard to race, 30.7% of professionals in the industry are Hispanic or Latino, 6.2% are black, and a staggering 2% are Asian.
Explanation:
List Examples of what an engineer does
What does MPL stand for in robot form.
Answer:
Mechanical Parts list
Answer:
Modular Prosthetic Limb
Explanation:
What are the rules for maintaining a time margin for safe driving?
Answer:
We should keep a good distance between the vehicle infront of us and from ours to avoid any type of accident.
3-second rule=>allowing a minimum of 3 seconds of travel between our vehicle and the vehicle we are behind.
Explanation:
HOPE IT HELPS YOU!!Why are plastics known as synthetic materials?
What is the total resistance of three resistors in parallel with values of 2 ohms, 4 ohms, and 4 ohms?
Answer:
So 1/Rt=1/4+1/4+1/2=4/4 = 1 so Rtotal=1
The total resistance of three resistors in parallel with values of 2 ohms, 4 ohms, and 4 ohms is 1 ohm.
What is resistance?The impediment to current flow in an electrical circuit is quantified by resistance. The Greek letter omega represents the unit of measurement for resistance, known as ohms.
The equivalent resistance will also be equal to R/n, where R is the value of the resistor. n is the total number of resistors in the combination if three or more resistors of the same value are connected in parallel.
As the resistors are connected parallelly, the resistance of all the resistors will be greater than the results. The calculation will be smaller than all resistors.
1 / Rt = 1 / 4 + 1 / 4 + 1 / 2 = 4 / 4 = 1
Therefore, the total resistance of three resistors in parallel is 1 ohm.
To learn more about resistance, refer to the link:
https://brainly.com/question/13831338
#SPJ2
Write a short summary of the power of dreams
Answer:
Walker went on to front Paranoid Saints, the Ex-Kings and the Bollox.
Reunion
In November 2009, Power of Dreams announced a reformation and tour to promote the 20th anniversary re-release of their first album (on 100% Music)[8] in March 2010.[9] In December 2010, a further tour of Ireland took place with Sultans of Ping and The Frank and Walters to support the release of a compilation album, 1989: The Best of Power of Dreams, which included a new track.[10] Power of Dreams' most recent gig was as part of "Indie Daze" at London's Forum in September 2014.
In March 2011, Keith Walker announced an amicable departure from the band and has gone on to play with Sister Cities,[11] Being Cool Is Lonely and The Holy Coast.[12] Olney plays with a new band, Cat Meat.[13] Walker continued to perform as Power of Dreams and to work on new material alongside his new project, Mineral, based in Paris.[14] In 2014, The Avener had a chart-topping hit single in several European countries with "Fade Out Lines", a remix of a song written by Walker and Phoebe Killdeer (ex-Nouvelle Vague) for Phoebe Killdeer and the Short Straws' second album Innerquake, released in 2012.
In December 2011, Immigrants, Emigrants and Me appeared in the book 101 Irish Records You Must Hear Before You Die.[15] In April 2013, the album was in the Irish Independent's top 30 albums of all time.[16]
In 2020, Power of Dreams released two new singles, "America"/"Across the Shannon",[17][18] and "Hurricane",[19] to promote forthcoming album Aüslander.
In July 2021, Aüslander, their first album in 27 years was released by The state51 Conspiracy and became a new entry on the Official Irish Albums Chart Top 50 when it charted at Number 22 on the chart of 05 August 2021
_____________ designers want to modernize the ao dai in many different ways. *
1 điểm
A. Fashion
B. Fashionable
C. Fashionably
D. Lot of
Answer:
fashion designers is the answer
Answer:
Fashion
Explanation:
hope my answer helps you .
Complete two examples of how scientists, technologists, engineers, and mathematicians may work together to create a new product invention or innovation
Based on your client's request, you will now create a sketch model of your designed pet toy. You will use your technical sketch and scale dimensions to create a computer model according to the same scale. However, the creation of the sketch model is only part of the engineer's responsibility. You must create a 300- to 500-word script for a persuasive presentation of your sketch model to your audience (client) and convince him or her that this new pet toy is a product that the company will want to sell. Be sure to incorporate design elements and materials into your reasoning in your presentation.
Answer:
From this in-depth examination we aimed to draw out some of the key ... closely their business case and employ model makers to create a 3D prototype.
Explanation:
Hęłłõ hõw årę ÿõū dõìńg tõdāÿ
Answer:
All good :)
What about you??
what happen when position and crest of a light wave decreases
Answer:
All photons travel at the speed of light. ... From this equation, it is clear that the energy of a photon is directly proportional to its frequency and inversely proportional to its wavelength. Thus as frequency increases (with a corresponding decrease in wavelength), the photon energy increases and visa versa.
Explanation:
a ventilation blower should be operated for how long after fueling?
draw perpendicular lines based on the info in the image.
on gasoline powered boats, when should the blower be operated?
On gasoline powered boats, the blower should be operated before starting the engine, during fueling, etc.
In the following circumstances, the blower should be used on boats powered by petrol:
It's crucial to run the blower for a few minutes before starting the engine.It is advised to keep the blower going while you are fueling.When the vessel is in motion: Some marine safety recommendations advise running the blower continuously while the boat is underway, especially in enclosed engine compartments, however this is not required.Thus, during these conditions, one should operate the blower.
For more details regarding gasoline powered boats, visit:
https://brainly.com/question/4143582
#SPJ6
tech a says that all wheels must be torqued to prevent wheels from loosening up and falling off. tech b says that all wheels must be torqued to prevent over tightening, which can weaken lug studs and warp brake rotors. who is correct
Answer: New wheels should be re-torqued after the first 50 to 100 driving miles. This should be done in case the clamping loads have changed following the initial installation due to the metal compression/elongation or thermal stresses affecting the wheels as they are breaking in, as well as to verify the accuracy of the original installation.
Answer:
I thinkC
Explanation:
pleaseee help! 100 points!!!!!!!!!!!!!! geometry angles in parallel lines question.
Answer:
answer are c=74
d= 122
a= 58
b= 48