when two forces on the same object are equal and oppostie, these forces are called

1.96 kg * m2/s2

Explanation:I'm assuming that you are asking what is the elastic potential energy stored in the spring at the position stretched by 16.5 cm...Since you know the spring constant k, 144 N/m and the spring stretch from the equilibrium position x, is 16.5 cm, or 0.165, you find the spring's potential energy from the equation PE = 12kx2, which equals 1.96 Joules, or kg * m2/s2 if you want SI units.

Answer:

It's easier if you just read the explanation.

Explanation:

about 3.54x1022 N

The gravitational force between the Sun and the Earth is about 3.54x1022 N. This force keeps the Earth orbiting around the Sun.

Answer:

Is called a(n) revolution

Explanation:

Answer:

Dying

Explanation:

I know I am scared

[tex]weight \: and \: force[/tex]

Based on the calculated Young’s modulus of the material, the material the cylinder could most likely be made of is butyl rubber which has a Young’s modulus of 0.001 to 0.002 GPa.

Young's modulus, Y is a measure of a solid's ability to resist deformation in its length under stress or strain.

Mathematically,

where:

Y = Fl/Ae

where;

π = 3.14

r = 2 cm = 0.02

Area of the cylinder = 3.14 × 0.02^2 = 0.00125 m^2

When a mass 5 kg was placed on the cylinder:

F = 5 × 10 = 50 N

l = 10 cm = 0.1 m

e = 10 - 7.73 = 0.39 cm = 0.0039 m

A = 0.00125 m^2

Using Y = Fl/Ae

Y = (50 × 0.1)/(0.00125 × 0.0039)

Y = 1025641.026 N/m^2

1 N/m^2 = 1 × 10^-9 GPa

Y = 0.001025 Gpa

When a mass 50 kg was placed on the cylinder:

F = 50 × 10 = 500 N

l = 10 cm = 0.1 m

e = 10 - 7.73 = 2.27 cm = 0.0227 m

A = 0.00125 m^2

Using Y = Fl/Ae

Y = (500 × 0.1)/(0.00125 × 0.0227)

Y = 1762114.537 N/m^2

1 N/m^2 = 1 × 10^-9 GPa

Y = 0.00176 Gpa

The Young’s modulus of the material is between 0.001025 Gpa and 0.00176 Gpa.

Therefore, the material the cylinder could most likely be made of is butyl rubber which has a Young’s modulus of 0.001 to 0.002 GPa.

Learn more about Young’s modulus at: https://brainly.com/question/6864866

The material that the cylinder is made from is Butyl Rubber.

Young's modulus, or the modulus of elasticity in tension or compression, is a mechanical property that measures the tensile or compressive strength of a solid material when a force is applied to it.

A = πr²

[tex]A = \pi \times (0.02)^2 = 0.00126 \ m^2[/tex]

[tex]E = \frac{stress}{strain} \\\\E = \frac{F/A}{e/l} \\\\E = \frac{Fl}{Ae} \\\\[/tex]

Where;

When 5 kg mass is applied, the extension = 10 cm - 9.61 cm = 0.39 cm = 0.0039 m.

[tex]E = \frac{(5\times 9.8) \times 0.1}{0.00126 \times 0.0039} \\\\E = 9.97 \times 10^5 \ N/m^2\\\\E = 0.000997 \times 10^9 \ N/m^2\\\\E = 0.000997 \ GPa\\\\E \approx 0.001 \ GPa[/tex]

When the mass is 50 kg,

extension = 10 cm - 7.73 cm = 2.27 cm = 0.0227 m

[tex]E = \frac{(50\times 9.8) \times 0.1}{0.00126 \times 0.0227} \\\\E = 1.7 \times 10^6 \ N/m^2\\\\E = 0.0017 \times 10^9 \ N/m^2\\\\E = 0.0017 \ GPa\\\\E \approx 0.002 \ GPa[/tex]

The Young's modulus is between 0.001 GPa  to 0.002 GPa

Thus, the material that the cylinder is made from is Butyl Rubber.

Learn more about Young's modulus here: https://brainly.com/question/6864866

Answer:

subdivision of a heavy atomic nucleus, such as that of uranium or plutonium, into two fragments of roughly equal mass.

Explanation:

Answer:

Distance travelled: 20meters

Displacement: 10 meters.

Explanation:

In geometry and mechanics, a displacement is a vector whose length is the shortest distance from the initial to the final position of a point P undergoing motion. It quantifies both the distance and direction of the net or total motion along a straight line from the initial position to the final position of the point trajectory. A displacement may be identified with the translation that maps the initial position to the final position.

Answer:

The astronaut will get a velocity 0.064ms−1 opposite to the direction of the object.

If a 75 kg astronaut floating in space throws a 5 kg rock at 5 m/sec, then the astronaut would move backward with a speed of 0.33 meters/second.

It can be defined as the product of the mass and the speed of the particle, it represents the combined effect of mass and the speed of any particle, and the momentum of any particle is expressed in Kg m/s unit.

P = mv

As given in the problem if a 5 kg astronaut floating in space throws a 5 kg rock at 5 m/sec,

By using the conservation of the momentum,

Assuming the initial momentum of the astronaut and ball would have been zero, the total final momentum of the system would be zero as well,

75*v +5*5 = 0

v = 25/75

v = -0.33 m/s

Thus, the astronaut would move backward with a speed of 0.33 meters/second.

To learn more about momentum from here, refer to the link;

brainly.com/question/17662202

#SPJ2

A. the moving charge induces a magnet field

B. the energy of the charge pushes on the compass

C. the electrons heat up the wire, causing the compass to deflect

Hi there!

1)

Since the charge placed in the middle is positive, we know that the particle is being repelled.

The particle experiences a greater repelling force by the 9μC charge. We can use the equation for electric force:
[tex]F_E = \frac{kq_1q_2}{r^2}[/tex]

k = Coulomb's Constant

q₁, q₂: Charges (C)
r = distance between charges (m)

This is a VECTOR quantity, so we must subtract the forces since they point in opposite directions.

Force from 9μC particle:
[tex]F_E = \frac{k(.000005)(.000009)}{2^2} = .101\\\\[/tex]

Force from 4μC particle:
[tex]F_E = \frac{k(0.000005)(0.000004)}{2^2} = 0.0450[/tex]

Subtract:
[tex].101 - 0.0450 = \boxed{0.561 N}[/tex]

2)

We can find a position by setting the two equations equal to one another. (Both repelling forces must be EQUAL for the force = 0 N)

Let the distance between the 9μC and 5μC charge equal 'x', and the distance between the 4μC and 5μC charge equal '4 - x'.

[tex]\frac{k(0.000009)(0.000005)}{x^2} = \frac{k(0.000004)(0.000005)}{(4 - x)^2}[/tex]

Cancel out 'k' and the 5μC value.

[tex]\frac{0.000009}{x^2} = \frac{0.000004}{(4 - x)^2}[/tex]

Solve for 'x' using a graphing utility.

[tex]\boxed{x = 2.4 m}[/tex]

Answer:

from W-Z.. i think on a swing you get your most potential energy at W and Z is where you go up so Z would be where the kinetic energy increased and W is where potential energy decrease

Explanation:

hope this helps

Olivia is on a Swing at Playground - Option 2 Olivia is on a swing at the playground. Her kinetic energy increasing at x and her potential energy decreasing at x. At mean position velocity is maximum so kinetic energy ( K.E ) is also maximum and at mean position potential energy is minimum. Therefore, kinetic energy is increasing and potential energy decreasing at x.

Explanation

Credits to someone on a different answer

Answer:

Capricorn what is yours

Answer:

leo

Explanation:

Answer:

The mass of the satellite does not matter, as long as the ratio between the satellite's and the orbited object is small. On the other hand, if the masses are closer to each other, like the Earth and its Moon, then the model is more complicated.

Explanation:

Answer:

buy what you need to reduce waste, eat organic foods. drive less when transporting try walking instead of using a car or train

Explanation:

Answer:

-2 m/s²

Explanation:

Answer:

It is A that best describe it.

The image that shows the direction someone would need to kick the ball in order to move it toward the goal is image A.

We have,

The arrow in a diagram tells us the direction in which it will go.

Now,

From image A and image B,

Image A tells us that if we kick the ball in the right direction it will hit the goal.

Image B tells us that if we kick the ball in the left direction the ball will not hit the goal but go to the opposite direction.

Thus,

The image that shows the direction someone would need to kick the ball in order to move it toward the goal is image A.

Learn more about arrow signs here:

https://brainly.com/question/31306491

#SPJ3

[tex]\qquad \qquad\huge \underline{\boxed{\sf Answer}}[/tex]

Here's the solution ~

As we know, Displacement =

[tex]\qquad \sf  \dashrightarrow \: velocity \times time[/tex]

[tex]\qquad \sf  \dashrightarrow \: 6.8 \times 250[/tex]

[tex]\qquad \sf  \dashrightarrow \: 1700 \: m[/tex]

[tex]\qquad \sf  \dashrightarrow \: 1.7 \: km[/tex]

The car travelled 1700 meters ( 1.7 km )

Explain why scientists replace an old scientific model with a new model.

Include an example from Physics in your answer.

A scientific model is created to understand the concepts and explain the reason behind unexplained observations.

But the scientific models cannot explain all the unexplained observations.

When another scientific model which could explain some more observations than the previous model.

This new model replaces the old one.

 One such example in physics is geocentric and heliocentric models.

The geocentric model was based on the principle that all celestial bodies revolve around the earth as its center.

But this model failed to explain some planets move backward instead of forward.

The heliocentric model was based on the principle that all planets revolve around the sun as its center including earth.

 This model was able to resolve the backward and forward motion dilemma.

That is why heliocentric replaced the geocentric model.

[tex]\boxed{\huge \text{Hope this helps! :)}}[/tex]

[tex]\huge \text{Happy president's day! :)}[/tex]

-InLoveWithNature-

The model was used by scientists to predict the results of their investigations. The data frequently did not support their forecasts. This required a modification to the model.

The contemporary atomic model emerged as a result of numerous scientists building on one another's research.

Creating a physical, mental, or mathematical model of a genuine occurrence that is challenging to see firsthand is known as scientific modeling.

In a range of scientific disciplines, from chemistry and science to ecology and also the Earth sciences, scientific models are employed to explain and forecast the behavior of real things or systems.

Though modeling is an essential part of contemporary science, scientific models are, at best, approximations rather than perfect representations of the systems and things they represent. As a result, scientists are always trying to enhance and improve models.

Scientific modeling has a variety of goals. Some models, which are frequently developed from experimental data, are being used mainly to visualize an object or system, such the three-dimensional dbl model of DNA.

To know more about scientific model:

https://brainly.com/question/18893139

#SPJ2

Answer:

Centre is the Answer hope its is right and helpfull

Answer:

1500 N

Explanation:

• Initial velocity, u = 12 m/s

• Final velocity, v = 20 m/s

• Time taken, t = 6.4 s

• Mass, m = 1200 kg

[tex]\longrightarrow[/tex] F = ma

a = (v – u)/t, so

[tex]\longrightarrow[/tex] F = 1200 × (20 – 12)/6.4

[tex]\longrightarrow[/tex] F = 1200 × 8/6.4

[tex]\longrightarrow[/tex] F = 1200 × 80/64

[tex]\longrightarrow[/tex] F = 1200 × 40/32

[tex]\longrightarrow[/tex] F = 1200 × 20/16

[tex]\longrightarrow[/tex] F = 300 × 20/4

[tex]\longrightarrow[/tex] F = 300 × 5

[tex]\longrightarrow[/tex] F = 1500 N (Answer)

vf = vi + at

vf = 0

a = - (to stop (deceleration))

input the value:

0 = 4 m/s -a.8

8a = 4

a = 0.5 m/s²

F = m.a

F = 75 kg x 0.5 m/s²

F = 37.5 N

Substances are composed of atoms, although I'm not sure if this is what you mean

Answer:

4.5 billion

Explanation:

There are many stars big and small so there must be billions

Answer:

-80 m/s/s

Explanation:

acceleration = (v final - v initial) / time

a = (0 m/s - 40m/s) / 0.5 seconds

a = - 40 m/s / 0.5 seconds

a = - 80 m/s/s

Answer:

The same

Explanation:

Momentum is conserved before and after collision.

Hope this helps!

Answer:

net force.

Explanation: