The structure of Disodium edta

Answer:

Answer D. Picture II shows a chemical change, because the same substance changes form

Explanation:

This is the temperature that water molecules slow down enough to stick to each other and form a solid crystal

Answer:

D Im 90% Sure

Explanation:

If its not right i owe you one I did this one before

Answer: 1.324L

Explanation: use Boyles law, sorry so late!

Answer:

-85 °C

Explanation:

O and S are in the same group( Group 16). Since S is below O it's atomic mass is higher than O. So molar mass of H2S is higher than H2O. The strength of Vanderwaal Interactions ( London dispersion forces) increases when the molar mass increases. However, only H2O can form H bonds with each other. This is because electronegativity of O is higher than S and therefore H in H2O has a higher partial positive charge than H of H2S.

H bond dominate among these 2 types of forces so the strength of attractions between molecules is higher in H2O than H2S. Therefore more energy should be supplied for H2O to break inter

molecular forces and convert from solid to liquid state than H2S. So mpt of H2O must be higher than that of H2S.

Answer:

Subduction Process where the oceanic plate subducted under the continental plates because it denser than the Continental plate.

Answer:

I hope that help you

Explanation:

energy is change from one form to another called    _energy conversion

energy can neither be created nor destroyed it can only be transformed from one form to another called --The law of conservation of energy

cause to change in form character or function called - convert

the last sentensce

energy  transformation

From the dilution formula, we have that at constant value of the solute, the volume of the solution is inversely proportional to the concentration.

The correct responses are;

Reasons:

The given parameters are;

The concentration of the KCl solution = 4% m/v

Taking the solution as solution of KCl

The volume of the solution in container 1 = Two times less than the volume of KCl solution.

[tex]V_{container \, 1} = \displaystyle \mathbf{ \frac{1}{2} \cdot V_{4\% \, solution}}[/tex]

The volume of the solution in container 2 = Two times larger compared to the volume of KCl solution.

[tex]V_{container \, 2} = \mathbf{\displaystyle 2 \times V_{4\% \, solution}}[/tex]

The volume of the solution in container 3 = Two times larger than the container two solution volume.

[tex]V_{container \, 3} = \displaystyle \mathbf{ 2 \times V_{container \, 2}}[/tex]

Therefore;

[tex]V_{container \, 3} = \displaystyle 2 \times 2 \times V_{4\% \, solution} = \mathbf{4 \times V_{4\% \, solution }}[/tex]

Part A Required:

a. To select the container that represent the dilution of the 4% solution to 2%

Solution:

The dilution formula is; C₁·V₁ = C₂·V₂

Therefore;

[tex]\displaystyle V_1 = \mathbf{\frac{C_1 \cdot V_1}{C_2}}[/tex]

C₁ =4%, C₂ = 2%, we get;

[tex]\displaystyle V_1 = \frac{4 \cdot V_1}{2} = 2 \cdot V_1[/tex]

The volume of the container that represents a 2% dilution is container 2

which is filled with a solution of a volume two times larger compared to the

KCl solution.

Part B:

Required:

The container diluted to a 1% m/v KCl solution.

Solution;

Using the dilution formula, we have;

C₁ = 4%, C₂ = 1%

Therefore;

[tex]\displaystyle V_1 = \frac{C_1 \cdot V_1}{C_2}[/tex]

[tex]\displaystyle V_1 = \frac{4 \cdot V_1}{1} = \mathbf{4 \cdot V_1}[/tex]

The volume of the solution is four times the volume of the 4% KCl solution, which is equivalent to the volume in container 3.

Possible parts of the question are;

Select the container that represents the dilution of the 4% (m/v) KCl solution to obtain the solutions that follows;

Part A: a 2% (m/v) KCl solution

Part B: a solution that is a 1% (m/v) KCl solution

Please see attached drawings

Learn more here:

https://brainly.com/question/11493179

Answer: International Union of Pure and Applied Chemistry

The International Union of Pure and Applied Chemistry (IUPAC), established in 1919, is the international body that represents chemistry and related sciences and technologies.

[tex]pH = -\log[H^{+}] \\\\\implies \log[H^{+}] = -pH\\\\\implies [H^{+}] = 10^{-pH}\\\\\implies [H^{+}] = 10^{-4.83} = 0.000015[/tex]

The temperature of an object will increase if the kinetic energy of the particle increases.

Kinetic energy is an energy that is said to be in motion. According to the kinetic molecular theory of ideal gas, the particles of the gas are usually moving in constant random motion and they exert no force on each other.

Also, the temperature varies directly proportional to the average kinetic energy of the gas particles. As a result, when the kinetic energy of the particles increases, the temperature will also increase.

Learn more about the kinetic theory of gas here:

https://brainly.com/question/9949658?referrer=searchResults

[MnCl6] 3- is high spin and has five unpaired electrons while [Mn(CN)6] 3- has only two unpaired electrons.

A complex may be low spin or high spin depending on the kind of ligand attached to the central metal atom/ion. If the ligand is a weak field ligand, the complex may be high spin (maximum number of unpaired electrons). If the complex is low spin, there are few unpaired electrons (minimum number of unpaired electrons). In that case, the ligand is a strong field ligand.

In the octahedral geometry,  [MnCl6] 3- is high spin and has five unpaired electrons since the chloride ion is a weak field ligand. On the other hand  [Mn(CN)6] 3- has only two unpaired electrons because the cyanide ion is a strong field ligand.

Learn more: https://brainly.com/question/6111443

[tex]▪▪▪▪▪▪▪▪▪▪▪▪▪  {\huge\mathfrak{Answer}}▪▪▪▪▪▪▪▪▪▪▪▪▪▪[/tex]

The correct choice is ~ A

S.I unit of time is Second

1Touch and hold a clip to pin it. Unpinned clips will be deleted after 1 hour.

Answer:

we heat up because the component with lower boiling evaporates first,

leaving the other behind

Answer:

qrtyuioplkjhgfdssssssazxcvbn

Answer:

The option where the atoms are furthest apart.

Explanation:

Gasses are the most energetic of the three basic states of matter, their atoms have more kinetic energy than either solids or liquids and will therefore also have the most spread out atoms.

Answer:

A, B, C, D

Explanation:

The water cycle is included in the atmosphere (water vapor in the air), the geosphere (water collection), the hydrosphere (water on earth: lakes, oceans, rivers), and the biosphere (where water interacts with all living things).

In an ecosystem, the water cycle is included in all the spheres that is biosphere,geosphere,hydrosphere and atmosphere.

Ecosystem is defined as a system which consists of all living organisms and the physical components with which the living beings interact. The abiotic and biotic components are linked to each other through nutrient cycles and flow of energy.

Energy enters the system through the process of photosynthesis .Animals play an important role in transfer of energy as they feed on each other.As a result of this transfer of matter and energy takes place through the system .Living organisms also influence the quantity of biomass present.By decomposition of dead plants and animals by microbes nutrients are released back in to the soil.

Learn more about ecosystem,here:

https://brainly.com/question/13979184

#SPJ2

Answer:

b. Electronegativity

Explanation:

electronic configuration

Using Hess's law we found:

1) By adding reaction 10.2 with the reverse of reaction 10.1 we get reaction 10.3:

KOH(aq) + HCl(aq)  → H₂O(l) + KCl(aq)   ΔH  (10.3)

2) The ΔHsoln must be subtracted from ΔHneut to get the total change in enthalpy (ΔH).    

The reactions of dissolution (10.1) and neutralization (10.2) are:

KOH(s) → KOH(aq)   ΔHsoln    (10.1)

KOH(s) + HCl(aq) → H₂O(l) + KCl(aq)     ΔHneut     (10.2)

1) According to Hess's law, the total change in enthalpy of a reaction resulting from differents changes in various reactions can be calculated as the sum of all the enthalpies of all those reactions.      

Hence, to get reaction 10.3:

KOH(aq) + HCl(aq) → H₂O(l) + KCl(aq)    (10.3)

We need to add reaction 10.2 to the reverse of reaction 10.1

KOH(s) + HCl(aq) + KOH(aq) → H₂O(l) + KCl(aq) + KOH(s)

Canceling the KOH(s) from both sides, we get reaction 10.3:

KOH(aq) + HCl(aq)  → H₂O(l) + KCl(aq)    (10.3)

2) The change in enthalpy for reaction 10.3 can be calculated as the sum of the enthalpies ΔHsoln and ΔHneut:

[tex] \Delta H = \Delta H_{soln} + \Delta H_{neut} [/tex]

The enthalpy of reaction 10.1 (ΔHsoln) changed its sign when we reversed reaction 10.1, so:

[tex] \Delta H = \Delta H_{neut} - \Delta H_{soln} [/tex]

Therefore, the ΔHsoln must be subtracted from ΔHneut to get the total change in enthalpy ΔH.

Learn more here:

I hope it helps you!

Answer:

Explanation:

Hydrodistillation is a traditional method for the extraction of bioactive compounds from plants. In this method, plant materials are packed in a still compartment then water is added in sufficient amount and brought to a boil. ... The vapor mixture of water and oil is condensed by indirect cooling with water.

AnswerExplanation:I finsished d

Answer:

17.55L

Explanation:

0.48mol : 11.7

0.72mol :   x

0.48x = 8.424

x = 17.55

The freezing point of a solution prepared by dissolving biphenyl (C12H10) into naphthalene is  67.99oC.

Freezing point can be obtained from;

ΔT = K m i

ΔT = freezing point depression

m = molality of the solution = 1.506 m

i = Van't Hoff factor = 1 for molecular substances

K = Freezing constant of naphthalene = 8.15 oC/m

ΔT = 8.15 oC/m × 1.506 m × 1 = 12.27oC

Freezing point of pure naphthalene = 80.26 °C

ΔT =  Freezing point of pure naphthalene - Freezing point of solution

Freezing point of solution =  Freezing point of pure naphthalene - ΔT

Freezing point of solution =  80.26 °C - 12.27oC = 67.99oC

Learn more:

When the pressure of the equilibrium mixture of SO2, O2, and SO3 is doubled at constant temperature, the Kp is also doubled.

The equation of the reaction is given by; 2SO2 + O2 → 2SO3. The Kp of the reaction is obtained from;

Kp = pSO3^2/pSO2^2 . pO2

Since the Kp depends on the individual partial pressures of each of SO2, O2, and SO3 at equilibrium, if the pressure of the equilibrium mixture is doubled, the Kp is also doubled.

Learn more: https://brainly.com/question/11324711

Answer:

radiation, conduction, convection, conduction

Answer:

radiation , conduction, convection, conduction

Answer:

bladder or bowel diseases, or arthritis. These might be your answer.

Answer: The correct answer is black because the product of its side and mass is lower.

Explanation: The density of a substance is defined as the amount of matter that can be stored in a given volume.

Hence, the black cube will be denser because the product of its side and mass is lower.

Answer: it was wrong on my test

Explanation:

literally dont believe them

The reduction half equation of the galvanic cell is is;  3Cu2+(aq)  + 3e ------> 3Cu(s).

A galvanic cell is a cell that produces chemical energy by a spontaneous chemical reaction. The equation of the reaction is; 2Cr(s) + 3Cu2+(aq) → 2Cr3+ (aq) + 3Cu(s). We can see that chromium was oxidized and copper was reduced.

Since reduction occurs at the cathode, it follows that the reduction half equation is;  3Cu2+(aq)  + 3e ------> 3Cu(s).

Learn more about galvanic cell; https://brainly.com/question/25606438

Answer:

6am

Explanation:

answer this please thank you

Answer:

The formula for Avagadro's law is V1/n1 = V2/n2, where V = volume and n = amount of gas (in moles).

Explanation:

The molarity of the solution is 0.01.

Brainliest?