pls help me with this chem question

Answer:

the equation is balanced

The pressure of the confined gas will be 769-17 = 752 mmHg

Manometer is a U shaped instrument which is used to measure the pressure acting on a column of fluid , a difference in the pressure  in the two arms of the manometer causes the liquid to reach different heights.

The difference  in the heights of the Hg columns in Diagram B is17 mm-Hg.

the atmospheric pressure is 769 mm-Hg,

the pressure of the confined gas in mm-Hg = ?

The pressure of the confined gas will be 769-17 = 752 mmHg

To know more about Manometer

https://brainly.com/question/18354578

#SPJ1

Answer:

increasing the pressure

Explanation:

You can make a solution more concentrated by increasing the pressure.

Answer:

C

Explanation:

just did it

Answer:

20 ml

Explanation:

2.5 M   x      =     1 M  * 50

x = 20 ml

Answer:

If there is a decrease in the amount of carbon dioxide or methane, the amount of energy leaving the Earth system increases, so less energy enters than exits. When less energy enters than exits, Earth's surface absorbs less energy.

Explanation:

Answer:

the aNSWRER TOP UR QUESTION IS THAT I NMEED TO ANSWER THIS SO I DONT HAVE TO WQATCH ADS  LOL

Explanation:

DSADSDASDASDASDSDSDSDSDS and i knowq chem is bio chwem is

Answer:

Pedal, Pushing, and also launching it off a cliff with a catapult

Explanation:

I know nothing

the answer would be B an atom that has lost an electron

The empirical formula is C₂H₃O₂

The empirical formula is the simplest whole number ratio of elements present in a compound.

The total molar mass of the compound is 118.084 g/mol.

mass of Carbon present = 40.6

mass of Hydrogen present = 5.1 grams

mass of Oxygen present = 2 grams

Moles of C = 40.6/12 = 3.38

Moles of H = 5.1/1.008 = 5

Moles of Oxygen = 54.2/15.999 = 3.38

Ratio of Moles of C to Oxygen is 1 : 1

Ratio of Moles of C to H is 1/1.5

Multiplying each mole fraction by 2

The empirical formula is C₂H₃O₂

To know more about Empirical Formula

https://brainly.com/question/14044066

#SPJ1

A gas at STP is heated to 35 degree C. The new pressure will be 2.41 atm.

The pressure of the mass of the gas is directly proportional; to the temperature of the gas.

[tex]\dfrac{P_1 }{T_1} =\dfrac{P_2}{T_2}[/tex]

Converting the temperature into kelvin

The initial temperature = 35 °C = 35 + 273 K= 308 K

The final temperature = 50 °C =50 + 273 K = 323 K

Initial pressure = 2.3 atm

Final pressure ?

Putting the values in the equation

[tex]\dfrac{P_1 }{T_1} =\dfrac{P_2}{T_2}\\\\\\{P_2 = \dfrac{P_1 \times T_2}{T_1} \\\\\\\\\\{P_2 = \dfrac{2.3 \times 323 }{308} = 2.41 atm.[/tex]

Thus, the new pressure will be 2.41 atm.

Learn more about Gay-Lussac law

https://brainly.com/question/11387781

#SPJ1

Answer:

both particles and waves

Explanation:

this is known as wave-particle duality.

I hope this helps.

Have a nice day.

The order would be coefficient, law of conservation of mass, products, and reactants respectively.

The number written in front of a chemical symbol in an equation is called a coefficient.

The total mass of a system being unchanged is known as the law of conservation of mass

The substances made in chemical reactions are called products.

The starting materials in chemical reactions are called reactants.

More on reactions can be found here: https://brainly.com/question/17434463

#SPJ1

Answer:

1. not affected by a magnet                      1 liquid

2. mostly space                                          2 solid

3. flows freely but particles still attract 3 proton

4. positively charged particles                  4 gas

5. free to move in all space                       5 alpha particles

6. negatively charged particles                 6 atoms

7. atoms nearly fixed in space                   7 gamma ray                                                    8. helium nucleus                                        8 electron (beta)

The final concentration of a solution that has been diluted by adding 100 ml of water to the original solution is 0.15M.

How to calculate concentration?

The concentration of a solution can be calculated using the following formula:

C1V1 = C2V2

Where;

C1 = initial concentration

C2 = final concentration

V1 = initial volume

V2 = final volume

1.5 × 10 = 100 × C2

15 = 100C2

C2 = 0.15M

Therefore, the final concentration of a solution that has been diluted by adding 100 ml of water to the original solution is 0.15M.

Learn more about concentration at:

#SPJ1

The Newman projection gives the view of the molecule. In molecule A the torsional strain and in B steric strain are present because of the gauche methyl group.

The Newman projection depicts the molecules in the head-on view and uses the letters and the lines to represent the molecule. The torsional strain is because of the molecule's resistance to the twisting.

The steric strain is the Vander wall strain that is due to the forced interaction of the molecules separated by covalent bonds resulting in molecular potential energy.

The diagram for the question is attached below.

Therefore, the correct blanks are torsional, steric, and gauche.

Learn more about torsional strain here:

https://brainly.com/question/27852131

#SPJ1

Answer:

The reaction is H2SO4 + 2KOH = K2SO4 + 2H2O

It resembles a double displacement reaction.

Notice how it is balanced so that there are the same number of each type of atom on both sides of the reaction.

The potassium sulfate will ionize into K+ ions and SO4-- ions, but the formula is usually written as above.

Answer:

121 million joules energy is released

Explain :

As there are 500 moles of hydrogen gas in a kilogram, this means that burning a kilogram of hydrogen gas releases 500 times as much energy or 121 million joules .

The statements that are true regarding a catalyst are as follows:

It undergoes no permanent change during a reaction

It does not participate in a chemical reaction

What is a catalyst?

A catalyst is a substance that increases the rate of a chemical reaction without being consumed in the process.

A catalyst increases the rate at which a chemical reaction occurs by decreasing the activation energy of the reaction.

Since a catalyst is not used up in the reaction, the following statement applies:

It undergoes no permanent change during a reaction

It does not participate in a chemical reaction

Learn more about catalyst at:

#SPJ1

Answer:

yes

Explanation:

im pretty sure yes, also i think this is 20 characters long

The normality is the ratio of the equivalent to the volume of the solvent. To the mixture, 1.182 gms of magnesium should be added.

Normality (N) is the grams or moles of solute per liter of solution.

Magnesium has 2 valence electrons in the outermost shell so,

1 mEq of Mg⁻² ions = atomic number of Mg ÷ valence electron

= 12 ÷ 2

= 6 mg

In a liter solution having 197 meq/l of Mg⁻²:

197 meq/l of Mg⁻² × 6 = 1182 mg

Therefore, 1.182 gms of magnesium ions should be added to the mixture.

Learn more about gram equivalents here:

https://brainly.com/question/14833835

#SPJ4

Answer:

The particles moves faster thus Expanding the liquid

The amount, in grams, that will remain of the isotope will be 2.75 grams

It is the time it takes for a given amount of radioactive substance to decay into half of its original amount.

The half-life is 15 hours. This means that the amount is halved every 15 hours.

If the starting amount is 22 grams, it will become 11 grams (22/2) after the first 15 hours. The 11 grams will become 5.5 grams (11/2) after another 15 hours, making 30 hours.

The 55.5 grams remaining will become 2.75 grams (5.5/2) if another 15 hours should pass, making a total of 45 hours that have passed.

Thus, only 2.75 grams of the isotope will remain in 45 hours.

More on half-life can be found here: https://brainly.com/question/24710827

#SPJ3

Answer:

Flame testing is an analytical technique where a sample is applied to a flame, and the characteristic emission spectrum is used to identify different elements.

Answer:

Flame testing is an analytical technique where a sample is applied to a flame, and the characteristic emission spectrum is used to identify different elements. When this technique is used to identify metal species, it is called metal flame emission testing while Flame emission spectrophotometry is based on the characteristic emission of light by atoms of many metallic elements when given sufficient energy, such as that supplied by a hot flame.

Answer:

Because the cohesive forces inside the droplets are stronger than the adhesive forces between both the drops and the wax, water does not penetrate waxed surfaces. Because the adhesive forces between the liquid and the glass are stronger than the cohesive forces inside the water, water wets glass and spreads out across it.

Explanation:

EDMENTUM

At constant pressure, the volume of a gas is directly proportional to temperature as measured on the kelvin temperature scale.

This is defined as the degree of hotness or coldness of a substance and is influenced by thermal energy.

The standard unit is Kelvin which also compares it to volume  at constant pressure of a given gas.

Read more about Temperature here https://brainly.com/question/2331658

#SPJ1

Answer:

how many particles are pushing something

Wavelengths of absorbed or emitted photons causes lines in a line spectrum.

Spectral lines are produced by transitions of electrons within atoms. As the electrons move closer or farther from the nucleus of an atom, energy is released in the form of light is emitted.

So we can conclude that Wavelengths of absorbed or emitted photons causes lines in a line spectrum.

Learn more about spectrum here: https://brainly.com/question/1968356

#SPJ1