pls help it's due today​

Answer:

There are four types of orbitals that you should be familiar with s, p, d and f (sharp, principle, diffuse and fundamental). Within each shell of an atom there are some combinations of orbitals

Answer:

No. Water can be used in a hydroelectric dam to generate electricity, but this does not make us use more or less water in our homes.

Explanation:

Answer:We use more freshwater to provide us with electricity. Water is the only compound that can be found naturally as a liquid, gas, and solid.

Explanation:

Answer:

Answer is 1000kg

Hope it help

Answer:

147 Joules

Explanation:

It would be potential energy because it is stored. Potential energy = gravity * mass * height. Gravity is 9.8 m/s² or more specific 9.807 m/s². Potential energy is written in Joules.

9.8 * 5 * 3 = 147 Joules

More specific:

9.807 * 5 * 3 = 147.105 Joules

Answer:

Exercising is not only good for their physical and mental health, but also helps them to socialise with other dogs and puppies, which is crucial to their ...

Explanation:

Answer:

ybuTouch and hold a clip to pin it. Unpinned clips will be deleted after 1 hour.Touch and hold a clip to pin it. Unpinned clips will be deleted after 1 hour.Touch and hold a clip to pin it. Unpinned clips will be deleted after 1 hour.Touch and hold a clip to pin it. Unpinned clips will be deleted after 1 hour.Touch and hold a clip to pin it. Unpinned clips will be deleted after 1 hour.

Answer:

it’s the third option: 4,600,000 km

Explanation:

just took the test and that was correct

Answer:

it Give only one of them a positive or negative charge

Answer:

Rubbing the balloon against hair or wool causes electrons to move from the hair or wool to the balloon. The balloon's negative charges are attracted to the positive charges in the can, and so the can rolls toward the balloon.

Answer:

The term "solar collector" commonly refers to a device for solar hot water heating, but may refer to large power generating installations such as solar parabolic troughs and solar towers or non water heating devices such as solar air heaters. radiant energy is the energy of electromagnetic and gravitational radiation.Active solar heating systems use solar energy to heat a fluid;either liquid or air; and then transfer the solar heat directly to the interior space or to a storage system for later use. If the solar system cannot provide adequate space heating, an auxiliary or back-up system provides the additional heat.

The kinetic energy of the crate as it reaches the lower surface is 80 J

Kinetic energy is the energy possed by an object in motion. Mathematically, the kinetic energy can be expressed as follow:

KE = ½mv²

With the above formula, the kinetic energy of the crate can be obtained as follow:

KE = ½mv²

KE = ½ × 10 × 4²

KE = 5 × 16

KE = 80 J

Therefore, the kinetic energy of the crate is 80 J

Learn more about kinetic energy: https://brainly.com/question/14449170

Hi there!

Since the crate is being slid at a constant speed, the forces sum to 0 N. In this instance, the following forces occur in the axis of interest:

Wsinθ = downward acceleration along incline due to gravity (N)

Fκ = kinetic friction force along incline (N)

A = applied force (N)

The acceleration due to gravity and friction force act in the same direction, so:

Wsinθ + Fκ = A

Solve for sinθ using right triangle trigonometry:

sinθ = O/H = 3/6 = 0.5

Rearrange the equation for the force of kinetic friction and solve:

Fκ = A - 0.5W

Fκ = 30.4 - 20 = 10.4 N

Now, recall that:

Work = Force × displacement (W = F × d)

Since the box's displacement is in the same axis as the force but OPPOSITE direction, we must use:

W = Fdcosθ

Angle between displacement and friction force is 180°.

cos(180) = -1

Work done by friction = -Fd = -10.4(6) = -62.4 J

Answer:

centripetal acceleration is when an object accelerates going in a circular motion.

Answer:

volume :: is the level at which something is heard or the amount of space that something takes up.

Density :: is a measure of mass per volume. The average density of an object equals its total mass divided by its total volume.

Answer:

The density, of a substance is its mass per unit volume. The symbol most often used for density is ρ, although the Latin letter D can also be used. Mathematically, density is defined as mass divided by volume: {\displaystyle \rho ={\frac {m}{V}}} where ρ is the density, m is the mass, and V is the volume

Answer:

vector quantity have both magnitude and direction but scalar quantities have only magnitude

Hi there!

Recall Newton's Second Law:

[tex]\large\boxed{\Sigma F = ma}[/tex]

∑F = net force (N)

m = mass (kg)

a = acceleration (m/s²)

We must begin by solving for the acceleration using the following:

a = Δv/t

In this instance:

Δv = 3 m/s

t = 2.5 sec

a = 3/2.5 = 1.2 m/s²

Now, plug this value along with the mass into the equation for net force:

[tex]\Sigma F = 5(1.2) = \boxed{6 N}}[/tex]

Answer:

[tex]\boxed {\boxed {\sf 6 \ Newtons}}[/tex]

Explanation:

According to Newton's Second Law of Motion, force is the product of mass and acceleration. The mass of the object is 5 kilograms, but the acceleration is unknown.

We can find acceleration using the following formula:

[tex]a= \frac{ \Delta v}{t}[/tex]

The velocity of the object increases by 3 meters per second. It accelerates in 2.5 seconds.

Substitute the values into the formula.

[tex]a= \frac{3 \ m/s}{2.5 \ s}[/tex]

[tex]a= 1.2 \ m/s/s = 1.2 \ m/s^2[/tex]

Now we know the mass and acceleration.

Substitute the values into the force formula.

[tex]F=ma[/tex]

[tex]F= (5 \ kg)(1.2 \ m/s^2)[/tex]

[tex]F= 6 \ kg*m/s^2[/tex]

Convert the units. 1 kilogram meter per second squared is equal to 1 Newton. Our answer of 6 kilogram meters per second squared is equal to 6 Newtons.

[tex]F= 6 \ N[/tex]

Answer:

F = G M m / R^2 = 6.67E-11 * 1.99E30 * 5.98E24 / (1.5E11)^2

F = 6.67 * 1.99 * 5.98 / 2.25 E21 Newtons

F = 3.53E22 N

Answer:

I think A

Explanation:

Answer:

m

Explanation:

Metres, m, is the SI unit of length

Hope this helped you-have a good day bro cya)

The final speed of the car at the given conditions is 30.1 m/s.

The given parameters:

The change in the energy applied to the car is calculated as;

[tex]\Delta E = E_1 - E_2\\\\\Delta E = 22,000 \ J \ - \ 3,666.67 \ J\\\\\Delta E = 18,333.33 \ J[/tex]

The final speed of the car is calculated as follows;

[tex]\Delta E = \frac{1}{2} m(v_f^2 - v_0^2)\\\\v_f^2 - v_0^2 = \frac{2\Delta E}{m} \\\\v_f^2 = \frac{2\Delta E}{m} + v_0^2\\\\v_f = \sqrt{ \frac{2\Delta E}{m} + v_0^2} \\\\v_f = \sqrt{ \frac{2\times 18,333.4}{1700} + (21)^2} \\\\v_f = 30.1 \ m/s[/tex]

Thus, the final speed of the car at the given conditions is 30.1 m/s.

Learn more about change in kinetic energy here: https://brainly.com/question/6480366

The ratio of time of flight for inelastic collision to elastic collision [tex](t_A :t_B)[/tex] is 1:2

The given parameters;

Considering inelastic collision, the final velocity of the system is calculated as;

[tex]m_1u_1 + m_2u_2 = v(m_1 + m_2)\\\\m_1u_1 + 0 = v(m_1 + m_2)\\\\v= \frac{m_1u_1}{m_1 + m_2} \ -- (1)\\\\[/tex]

The time of motion of the system form top of the table is calculated as;

[tex]v = u + gt\\\\v = 0 + gt\\\\v = gt\\\\t= \frac{v}{g} \\\\t_A = \frac{m_1u_1}{g(m_1 + m_2)} \ \ ---(2)[/tex]

Considering elastic collision, the final velocity of the system is calculated as;

[tex]m_1u_1 + m_2 u_2 = m_1v_1 + m_2v_2\\\\m_1u_1 + 0 = m_1v_1 + m_2v_2\\\\m_1 u_1 = m_1v_1 + m_2v_2[/tex]

Apply one-directional velocity

[tex]u_1 + (-v_1) = u_2 + v_2\\\\u_1 -v_1 = 0 + v_2\\\\v_1 = v_2 -u_1[/tex]

Substitute the value of [tex]v_1[/tex] into the above equation;

[tex]m_1u_1 = m_1(v_2 - u_1) + m_2 v_2\\\\m_1u_1 = m_1v_2 -m_1u_1 + m_2v_2\\\\2m_1u_1 = m_1v_2 + m_2v_2\\\\2m_1u_1= v_2(m_1 + m_2)\\\\v_2 = \frac{2m_1u_1}{m_1+ m_2} \ --(3)[/tex]

where;

[tex]v_2[/tex] is the final velocity of the block after collision

Since the bullet bounces off, we assume that only the block fell to the ground from the table.

The time of motion of the block is calculated as follows;

[tex]v_2 = v_0 + gt\\\\v_2 = 0 + gt\\\\t = \frac{v_2}{g} \\\\t_B = \frac{v_2}{g} \\\\ t_B = \frac{2m_1u_1}{g(m_1 + m_2)} \ \ ---(4)[/tex]

The ratio of time of flight for inelastic collision to elastic collision is calculated as follows;

[tex]\frac{t_A}{t_B} = \frac{m_1u_1}{g(m_1 + m_2)} \times \frac{g(m_1 + m_2)}{2m_1u_1} \\\\\frac{t_A}{t_B} = \frac{1}{2} \\\\t_A:t_B = 1: 2[/tex]

Learn more about elastic and inelastic collision here: https://brainly.com/question/12497950

Answer:

S = V t     where S is the horizontal distance traveled

1/2 g t^2 = H       where H is the vertical distance traveled

t^2 = 2 H / g

V^2 = S^2 / t^2 = S^2 g / (2 H) combining equations

tan theta = H / S

V^2 = S g / (2 tan theta)

Using S = L cos theta

V^2 = L g cos theta / (2 tan theta)

Giving V in terms of L and theta

Answer:

The anomalous expansion of water is an abnormal property of water whereby it expands instead of contracting when the temperature goes from 4o C to 0o C, and it becomes less dense. The density is maximum at 4 degree centigrade and decreases below that temperature as shown in graph.

Explanation:do you want me to explain it more??

The two chemical compounds having a molar ratio of 1 : 1 is CO₂ and K₂CO₃

                4KO₂ + 2CO₂ —> 2K₂CO₃ + 3O₂

                4       :    2         :   2       :       3

From the balanced equation above, the coefficients are 4, 2, 2, 3

A careful observation of the equation shows that CO₂ and K₂CO₃ exist in ratio 2 : 2 which can be simplified as 1 : 1

Therefore, we can conclude that CO₂ and K₂CO₃ has molar ratio of 1 : 1

Learn more about stiochoimetry: https://brainly.com/question/25830314

The two forces involved in this collision are the colliding force and the reaction force which are equal in magnitude but opposite in direction.

According to Newton's third law, action and reaction are equal and opposite. This law is very important in describing head - on collisions between objects and is particularly apt in describing the collision between the two boats.

In this collision, two forces are important these are the action and the reaction. The action is the colliding force which the boat that was hit experiences. The reaction force is the force that this boat experiences as a result of hitting the boat in front of it. The both forces are equal in magnitude but opposite in direction.

Learn more: https://brainly.com/question/904448

Answer:

applications of density measurements. The densities of brass and aluminum will be calculated from mass and volume measurements.

Explanation:

[tex]\text{Given that,}\\\\\text{Force, F =200 N}\\\\\text{Mass, m = 20 kg}\\\\\text{Using Newton's second law,}\\\\F = ma \\\\\implies a = \dfrac{F}{m} = \dfrac{200}{20}= 10 ~ \text{ m s}^{-2}\\\\\text{The acceleration is 10 m s}^{-2}.[/tex]