please help me out I’ll give brain to u

Answer:

answer po Yan hope it help

Answer:

The rate of reaction is doubled

Explanation:

The reaction between 1-iodopropane and sodium hydroxide is an SN2 reaction. This reaction takes place by a concerted mechanism and the hydroxide ion is the nucleophile.

In an SN reaction, the reaction is second order because the rate of reaction depends both on the concentration of the alkylhalide and that of the nucleophile. Hence, when the concentration of 1-iodopropane (the alkyl halide) is held constant and the concentration of hydroxide ion (the nucleophile) is doubled, the rate of reaction is doubled since;

Rate =k [1-iodopropane] [OH^-]

Answer:

45m

Explanation:

Heat energy will be released by solid A which will then be absorbed by liquid B.

These little particles vibrate back and forth or run into each other constantly. All matter contains a type of energy known as heat (or thermal) energy, which is produced by the movement of particles.

Particle energy increases with temperature. It is possible for some of this energy to be transferred to cooler particles. For instance, in the gas state, when a fast-moving particle strikes a slower-moving particle, some of the energy from the collision is transferred to the slower-moving particle, increasing its speed.

A region of high energy will gradually spread throughout the material as a result of billions of moving particles colliding with one another until thermal equilibrium is established.

Therefore, heat energy will be released by solid A which will then be absorbed by liquid B.

Read more about heat energy, here

https://brainly.com/question/20038450

#SPJ2

Answer:

Single replacement reaction

Explanation:

Let us try to write down the reaction equation for the reaction of a magnesium  ribbon with hydrochloric acid.

Mg(s) + 2HCl(aq) ------> MgCl2(aq) + H2(g)

A single replacement reaction is a type of chemical reaction in which one element is replaced by another element in a compound.

In this reaction, magnesium replaced hydrogen to form the product. Hence it is a single replacement reaction.

Answer:yes coefficient u mean??

Explanation:

Answer:

: kinetic energy is the energy transformation that occurs in a hot balloon.

Explanation:

Hot air balloons use a propane burner that converts chemical energy to thermal energy. The hot air is less dense than than the colder air and it lifts the balloon

Answer:

Answer is - 2. ...........

At constant temperature, if the volume of the sample of gas decreases, the pressure increases to 4.0atm.

Hence, option1)4 atm is the correct answer.

Boyle's law simply states that "the volume of any given quantity of gas is inversely proportional to its pressure as long as temperature remains constant.

Boyle's law is expressed as;

P₁V₁ = P₂V₂

Where P₁ is Initial Pressure, V₁ is Initial volume, P₂ is Final Pressure and V₂ is Final volume.

Given the data in the question question;

We substitute our given values into the expression above to determine the new pressure.

P₁V₁ = P₂V₂

P₂ = P₁V₁ / V₂

P₂ = ( 1.0atm × 0.2L ) / 0.05L

P₂ = 0.2Latm / 0.05L

P₂ = 4atm

At constant temperature, if the volume of the sample of gas decreases, the pressure increases to 4.0atm.

Hence, option1)4 atm is the correct answer.

Learn more about Boyle's law here: brainly.com/question/1437490

#SPJ2

Explanation:

its hard to explain unless we know what the question fully asks..

Answer:

genotype are the organism's hereditary information for example DNA

phenotype are the organism's physical characteristics for example your eyes or hair

or how your nose looks

it is false it reacts with oxygen

give brainliest if right

To solve such this we must know the concept of oxidation reaction. Therefore, the given statement is incorrect. When iron rust it reacts with oxygen from the air.

Chemical reaction is a process in which two or more than two molecules collide in right orientation and energy to form a new chemical compound. The mass of the overall reaction should be conserved. There are so many types of chemical reaction reaction like combination reaction, double displacement reaction.

In oxidation reaction, one of the element of the given compound oxidises to its higher oxidation state. Rusting is an example of oxidation reaction. The balanced equation for the rusting reaction can be given as

4Fe + 3O[tex]_2[/tex] + 6H[tex]_2[/tex]O → 4Fe(OH)[tex]_3[/tex]

Therefore, the given statement is incorrect.

Learn more about the chemical reactions, here:

https://brainly.com/question/3461108

#SPJ2

Answer:

i think its magma ajani i looked it up... and chelsey said u had corona so if its true hope u get better bro

Explanation:

Answer:VO(ClO4)3 i'm sure this is it

Explanation:

Answer:

The mitochondria is the organelle found in plant and animal cells and is involved in making cellular energy from respiration.

Explanation:

Answer:

[tex]\color{Blue}\huge\boxed{Answer} [/tex]

An example of the biosphere is where live occurs on, above and below the surface of Earth. The zone of planet earth where life naturally occurs, extending from the deep crust to the lower atmosphere. The living organisms and their environment composing the biosphere. The living organisms of the earth.

Answer:

a gray substance and colourless liquid

Explanation:

lead oxide is reduced to lead while hydrogen is oxidized to water

Explanation:

ur question is incomplete what elements make the compound and we talk of mass not weight and what are the units kjmol ,grams ,kgs

Answer:

27.43 kPa (Option A)

Explanation:

We can solve this by the use of the Ideal Gases Law.

P . V = n . R . T

As n and R are constant, we avoid them from the equation so:

P₁ . V₁ / T₁ = P₂ . V₂ / T₂

P₁ . 0776L / 298K = 32.6 kPa . 0.664L / 303K

P₁ . 0776L / 298K = 0.0714 kPa .L/K

P₁ . 0776L = 0.0714 kPa .L/K  . 298K

P₁ = 21.289 kPa.L / 0.776L

P₁ = 27.43 kPa

Answer:

The final pressure is 0.725 atm.

Explanation:

Gay Lussac's Law establishes the relationship between pressure and temperature of a gas when the volume is constant. This law says that when there is a constant volume, as the temperature increases, the pressure of the gas increases. And when the temperature is decreased, the pressure of the gas decreases. That is, pressure and temperature are directly proportional quantities.

Mathematically, Gay-Lussac's law states that, when a gas undergoes a constant volume transformation, the quotient of the pressure exerted by the gas temperature remains constant:

[tex]\frac{P}{T} =k[/tex]

When analyzing an initial state 1 and a final state 2, the following is satisfied:

[tex]\frac{P1}{T1} =\frac{P2}{T2}[/tex]

In this case:

Replacing:

[tex]\frac{0.81 atm}{306 K} =\frac{P2}{274 K}[/tex]

Solving:

[tex]P2=274 K*\frac{0.81 atm}{306 K}[/tex]

P2= 0.725 atm

The final pressure is 0.725 atm.

Answer:

Limting reactant: NaOH

Excess reactant: Al₂(SO₃)₃ by 104.9 grams.

315 g of Na₂SO₃ are produced in the reaction

67.4 % is the percent yield.

Explanation:

Balaced equation is:

Al₂(SO₃)₃ + 6NaOH → 3Na₂SO₃ + 2Al(OH)₃

We convert the mass of each reactant to moles, to identify the limiting reactant:

389.4 g . 1mol/ 342.15g = 1.14 moles of sulfite

200 g . 1mol / 40g = 5 moles

1 mol of aluminum sulfite react to 6 moles of NaOH, according to stoichiometry.

If we have 1.14 moles of sulfite, we need (1.14 . 6)/1 = 6.82 moles

We only have 5 mol of NaOH, so this is the limiting reactant.

Then the aluminum sulfite is the excess.

6 moles of NaOH react to 1 mol of sulfite

Then, 5 moles of NaOH may react to (5 . 1)/6 = 0.83 moles.

1.14 mol - 0.83 mol = 0.31 moles remains after the reaction goes complete.

We convert to mass: 0.31 mol . 342.15g/mol = 104.9 g

Then, we work with the limiting reactant. Stoichiometry is 6:3 (2)

6 moles of NaOH can produce 3 moles of sodium sulfite

Then 5 moles will produce (5 . 3)/6 = 2.5 moles

We convert moles to mass: 2.5 mol . 126 g/mol = 315 g.

Percent yield = (Yield produced/Thoeretical yield) . 100

Percent yield = (212.4g /315g) . 100 = 67.4  %

Answer:

pH = 9.4

Explanation:

With the given molarity of OH⁻ species we can calculate the pOH of the solution:

pOH = -log[OH⁻]

pOH = 2.6

Now we can use the pOH to calculate the pH of the solution, with the following formula:

pH = 14 - pOH

pH = 14 - 2.6

pH = 9.4

So a solution containing a OH⁻ concentration of 0.0025 M has a pH of 9.4.

Answer:

[tex]\boxed {\boxed {\sf A. \ 2.48 \ mol \ Na_2O}}[/tex]

Explanation:

We are asked to convert an amount in grams to moles. To do this, we use the molar mass. This is the number of grams in one mole of a substance. It is the same value numerically as the atomic mass on the Periodic Table, however the units are grams per mole, not atomic mass units.

Look up the molar masses for the individual elements.

Look back at the formula: Na₂O. Notice there is a subscript of 2 after sodium. This means there are 2 atoms of sodium in every molecule, so we have to multiply sodium's molar mass by 2 before adding oxygen's.

Set up a ratio using the molar mass.

[tex]\frac {61.9785386 \ g \ Na_2O}{1 \ mol \ Na_2O}[/tex]

Multiply by the given number of grams.

[tex]154 \ g \ Na_2O*\frac {61.9785386 \ g \ Na_2O}{1 \ mol \ Na_2O}[/tex]

Flip the ratio so the grams of sodium oxide can cancel each other out.

[tex]154 \ g \ Na_2O*\frac {1 \ mol \ Na_2O}{61.9785386 \ g \ Na_2O}[/tex]

[tex]154 *\frac {1 \ mol \ Na_2O}{61.9785386 }[/tex]

[tex]\frac {154}{61.9785386 } \ mol \ Na_2O[/tex]

[tex]2.48473106141 \ mol \ Na_2O[/tex]

The original measurement of grams given has 3 significant figures, so our answer must have the same. For the number we calculated, that is the hundredth place.

The 4 in the thousandth place tells us to leave the 8.

[tex]2.48 \ mol \ Na_2O[/tex]

There are 2.48 moles of sodium oxide in 154 grams, so choice A is correct.

Answer:

See explanation

Explanation:

According to Bronsted-Lowry, an acid is a proton donor while a base is a proton acceptor.

Hence, if we consider the reaction above, we will notice that for each base there is a conjugate acid and for each acid there is a conjugate base.

For the acid HNO3, its conjugate base is NO3^- while for the acid H3O^+, its conjugate base is H2O.

Answer:

C₂H₅N₂

Explanation:

In the combustion analysis, all NO comes from the nitrogen of the sample, that means:

Moles NO = Moles N in the sample

In the same way:

Moles CO2 = Moles C in the sample

Moles H2O = 1/2 moles H in the sample

To solve this problem we must convert the mass of each gas to moles in order to find the moles of each atom. The empirical formula is the simplest whole number ratio of atoms presents in the molecule:

Moles NO = N -Molar mass: 30g/mol

0.4646g * (1mol / 30g) = 0.01549 moles N

Moles CO2 = C -Molar mass: 44.01g/mol-

0.6859g * (1mol / 44.01g) = 0.01559 moles C

Moles H2O = 1/2moles H -Molar mass: 18.02g/mol-

0.6973g * (1mol / 18.02g) = 0.03870 moles H

The ratio of atoms is -Dividing in the low number of moles = moles N-:

C = 0.01559 / 0.01549 = 1

N = 0.01549 / 0.01549 = 1

H = 0.03870 / 0.01549 = 2.5

Twice this ratio of atoms -Because empirical formula must be given only with whole numbers:

C = 2

N = 2

H = 5

The empirical formula is:

Answer:

There isn't anything below, but i can help if you edit the question and put it there

Explanation:

~Bre

Answer:

C meteoroid

Explanation:

Meteoroids are the only ones of the four that are under a kilometer in size.