Please help me in this question about series circuit and pararell circuit

Answer:

the main cause of pollution is mankinds work like gases and extreme heat caused by factories and cars and littering is also caused by people's careless throwing away so In term man kind is responsible for the pollution

Explanation:

Answer:

I think it is a)in freshwater lakes,rivers,and stream

Answer:

a) in freshwater lakes, rivers, and streams

it wouldnt let me type it because it said it was too inappropriate

Explanation:

Answer:

Geosphere and Hydrosphere.

Explanation:

Hot springs are heated by geothermal heat—heat from the Earth's interior. In volcanic areas, water may come into contact with very hot rock heated by magma. The geosphere and hydrosphere interact when hot springs form. The geosphere gets a little melted by the hot hydrosphere and then when the springs shoot up in the air they break some rocks.

Answer:

1050-452 = 598, the liquid is more than the ammonium chloride so it is the majority

Answer:

Anser is C Agl

Explanation:

Agl does not dissolve in water.

All of the following compounds are soluble in water except AgI because of  very high value of lattice energy. Therefore, the correct option is option C.

The capacity of a material, the solute, to combine with a different material, the solvent, is known as solubility in chemistry. Insolubility, or the solute's inability to create such a solution, is the opposite attribute. The concentration for the solute within a saturated solution—a solution where no more of the substance can be dissolved—is typically used to gauge the degree of a substance's solubility in a particular solvent. The two compounds are considered to be at the point of solubility equilibrium at this time. All of the following compounds are soluble in water except AgI because of  very high value of lattice energy.

Therefore, the correct option is option C.

To know more about lattice energy, here:

https://brainly.com/question/29735933

#SPJ6

Answer:

b I think it is the correct answer

Answer:

A. candle wax cooling on the table

Explanation:

Candle wax cooling on a table is an example of freezing because the atoms in the candle wax start to slow down as the wax cools. This is considered "freezing" because the slower an atom is vibrating then the colder it is and of course the faster an atom is vibrating then the hotter it is! :)

Answer:

.....................

30.973761

Answer:

2. Products; FeCl2 and H2S

Reactants; FeS and HCl

3. a) 36g of water

b) 64g of oxygen

Explanation:

=>7.7 x10¹⁴ to 4.2 x10¹⁴Hz

Answer:

0.354 molal

Explanation:

The molarity (M) or the concentration of a solution is defined as the number of moles of a compound in the solution per liter of solution (mol/L), whereas molality, is defined as the number of moles of a compound in the solution per kg of the compound (mol/kg).

Given that the density of the solution is 1.202 g/mL, which is equivalent to 1.202 kg/L. Since the prefix mili- denotes a factor of one thousandth ( [tex]10^{-3}[/tex] ) and kilo- denotes a factor of one thousand ( [tex]{10}^3[/tex] ),

[tex]1.202 \ \frac{g}{mL} \ = \ 1.202 \ \frac{g}{(10^{-3}) L} \ = \ 1.202 \ \frac{{10}^3g}{L} \ = \ 1.202 \ \frac{kg}{L}[/tex].

To calculate the corresponding molality of the solution, the formula

[tex]Molality \ (mol/kg) \ = \ \frac{Molarity \ (mol/L)}{Density \ (kg/L)}[/tex] is used.

Therefore,

[tex]Molality \ = \ \frac{0.426 \ mol/L}{1.202 \ kg/L} \ = \ 0.354 \ mol/kg \ \ (3 \ s.f.)[/tex]

The options that describe the experimental errors that would affect the percent of chloride reported are:

While performing experiments, there are some errors that occur which are generally known as experimental errors.

These experimental errors are the difference between the true measurement and what we measured.

There are three types of experimental errors they include:

Human errors occur due to carelessness of the observer.

Examples are:

Therefore, the options describe the experimental errors that would affect the percent of chloride reported are B and D.

Learn more about experimental errors here:

https://brainly.com/question/2764830

The Lewis structure is the way of expressing the covalent bonding in molecules. The covalent bond formation takes place by the sharing of electrons in a molecule.

In Lewis dot structures or simply the Lewis structures, the dots are used to represent the electrons. They provide a picture of bonding in molecules in terms of the shared pair of electrons and the octet rule.

The concept of covalent bond is introduced by the scientist G.N Lewis. According to him, the atoms achieve stable octet when they are linked with each other by sharing of one more pairs of electrons. The covalent bonding occurs between the atoms which do not differ much in their electronegativity.

The Lewis structure of CaBr₂ is denoted below. Here two bromine atoms acquires a stable electronic configuration by sharing electrons. There are two single bonds between them.

To know more about Lewis structure, visit;

https://brainly.com/question/20300458

#SPJ5

Answer: The density because it stays the same with any same liquids or solids or gas with whatever amount of it is added. It only changes if the matter of state is different or there is any environmental change.

[tex] = 1kg \: \: \times 9.8 {ms}^{ - 2} \\ = 9.8 \: \: N[/tex]

B. 9.8 N

Hope you could get an idea from here.

Doubt clarification - use comment section.

Answer:

Erosion.

Explanation:

It can be as small as a grain of sand or as large as a boulder. Sediment moves from one place to another through the process of erosion. Erosion is the removal and transportation of rock or soil. Erosion can move sediment through water, ice, or wind.

I'm not sure but I think it is C. CrO3

Answer:

Hey mate....

Explanation:

This is ur answer....

Plants use a process called photosynthesis to make food. During photosynthesis, plants trap light energy with their leaves. Plants use the energy of the sun to change water and carbon dioxide into a sugar called glucose. Starch is stored in seeds and other plant parts as a food source.

Hope it helps!

Brainliest pls!

Follow me! :)

Answer:

Plants use photosynthesis to convert sun light into their own food to consume. Green plants use this light energy to change water and carbon dioxide into oxygen and nutrients called sugars. The plants use some of the sugars and store the rest. The oxygen is released into the air.

God had warned Noah of the flood and directed him to build an ark. Noah had faith in God and began building.

Answer:

God Warned Noah for the Flood comindg to Earth to wash away all the bad people's lives and god also said get couple animals girls and boys then build an ark then bring your family and food there to then noah had a faith in god so he obey and start builind the ark in a top of a mountain

Explanation:

Hebrews 11:7

Answer:

wavelengths

Explanation:

Answer:

38.38 L (3 d.p.)

Explanation:

In response to questions addressing the expansion of gas via heating, Charles's Law should be considered. Charles's Law is an experimental gas law explaining the tendency of gases to expand when heated.

The law states that the volume ([tex]V[/tex])  of a gas is directly proportional to its temperature ([tex]T[/tex]) given that the pressure ([tex]P[/tex]) and the amount of gas ([tex]N_{A}[/tex]) are constant.

[tex]\displaystyle\frac{V}{T} \ = \ k \ \ \ \ \ \ \ or \ \ \ \ \ \ \ V \ = \ kT[/tex], where k is a proportionality constant.

*Note that when substituting temperature into the equation, the temperature must be in terms of the Kelvin scale and not in degrees Celsius. The relation between the Kelvin scale and the Celsius scale is  [tex]\mathrm{K} \ = \ ^{\circ}\mathrm{C} \ + \ 273[/tex].

Charles's law can be used to compare changing conditions of a particular gas. Let  [tex]V_{1}[/tex]  and  [tex]T_{1}[/tex]  be the initial volume and temperature for the gas, while  [tex]V_{2}[/tex]  and  [tex]T_{2}[/tex]  be the final volume and temperature. The mathematical relationship of Charles's law becomes:

[tex]\displaystyle\frac{V_{1}}{T_{1}} \ = \ \displaystyle\frac{V_{2}}{T_{2}}[/tex].

In accordance with the question,

[tex]V_{1} \ = \ 33.4 \ \mathrm{L}, \ T_{1} \ = \ (22 \ + \ 273) \ \mathrm{K} \ = \ 295 \mathrm{K}, \ T_{2} \ = \ (66 \ + \ 273) \ \mathrm{K} \ = \ 339 \ \mathrm{K}[/tex]

while  [tex]V_{2}[/tex]  is the final volume of the gas that we would like to find. Therefore,

[tex]V_{2} \ = \ \displaystyle\frac{V_{1} \ \times \ T_{2}}{T_{1}} \\ \\ V_{2} \ = \ \displaystyle\frac{33.4 \ \mathrm{L} \ \times \ 339 \ \mathrm{K}}{295 \ \mathrm{K}} \\ \\ V_{2} \ = \ 38.38 \ \mathrm{L}[/tex].

Answer:

it is in the same phase as the reactants

The  statement describes a homogeneous catalyst is,

So, option B is correct one.

The substance which increases the rate of the reaction without being itself change at the end of the reaction is called catalyst.

learn about homogeneous catalyst,

https://brainly.com/question/4249142

#SPJ2

According to the forces of attraction freezing point and boiling point of water are different and are not related to  strength of electrostatic forces.

Forces of attraction is a force by which atoms in a molecule  combine. it is basically an attractive force in nature.  It can act between an ion  and an atom as well.It varies for different  states  of matter that is solids, liquids and gases.

The forces of attraction are maximum in solids as  the molecules present in solid are tightly held while it is minimum in gases  as the molecules are far apart . The forces of attraction in liquids is intermediate of solids and gases.

The physical properties such as melting point, boiling point, density  are all dependent on forces of attraction which exists in the substances.

Learn more about forces of attraction,here:

https://brainly.com/question/23841038

#SPJ2

Answer:

potassium I believe is the correct answer

Explanation:

Potassium is the period four element with the lowest mass; its average mass is 39.0983amu.

The fourth period of the periodic table is where potassium has its lowest atomic mass.

Atomic mass is defined as the combined mass of an atom's protons, neutrons, and electrons.  The term "atomic mass" refers to the weight of an atom or molecule. To determine the average mass of elements and molecules as well as to resolve stoichiometry issues, the atomic mass is used.

An electrically neutral atom has an equal number of protons and electrons. As a result, using any of the two formulas, we may calculate the atomic mass of an element. The atomic mass of an element grows as we move from left to right in a period of the periodic table. In the fourth period of the current periodic table, Krypton has the highest atomic mass and potassium has the lowest.

Thus, the fourth period of the periodic table is where potassium has its lowest atomic mass.

To learn more about atomic mass, refer to the link below:

https://brainly.com/question/17067547

#SPJ2

why are electric switches and boards are made up of plastic

Because plastic is a poor conductor of electricity.

Plastics do not conduct enough heat and electricity. Therefore, it is used in the manufacture of plug switches, plug boards, etc.

Answer:

1) B. determining what data to collect

2) C. Heat samples of water and ethanol in two separate beakers using a Bunsen burner. Measure the temperatures at which the samples boil using a thermometer. Conduct several trials and record the average temperatures as the boiling points.

3) B. Heat energy overcomes the forces of attraction between the molecules of the substance, so the molecules can move more freely.

4). The addition of thermal energy causes the motion of water molecules to overcome electrostatic forces.

Explanation:

I think these are the answers, i'll confirm when I finish the test.

In an experiment it is known what quantity has to measured, thus the measurement of melting point has been determining what data to collect. Thus, Option B is correct.

To investigate the boiling point of water and ethanol, the samples has to boiled at constant parameters and the data has been collected with several trials. Thus, option C is correct.

Melting has been described as the change of the solid to the liquid state. With melting, there has been heat energy higher than the force of attraction allowing the molecules to move freely. Thus, option B is correct.

The boiling has been the change in the water at liquid state to the gaseous state. With boiling there is thermal energy capable of increasing the motion of water molecules overcoming electrostatic force.

For more information about melting, refer to the link:

https://brainly.com/question/12499685