in descriptive scientific investigations scientis often make observations to understand the interacting parts of a complex​

Answer:

64g of Oxygen

Explanation:

Firstly, carbon and oxygen react to form CO2 as follows;

C + O2 => CO2

According to the equation, one mole of C reacts with one mole of O2 to give one mole of CO2

Since molar mass of C= 12g/mol, O= 16g/mol

One mole of (C) contains 12g

One mole of O2 contains 16(2) = 32g

Hence, If there are 24g of C, there would be 24 × 32 / 12

= 768/12

= 64g

Hence, there would be 64g of oxygen if there are 24g of Carbon

Answer:

A:DNA is a double helix, and RNA is a single strand.

C:DNA is involved only in transcription, and RNA is involved in both transcription and translation.

E:DNA does not have uracil as a nitrogen base, but RNA does have uracil as a nitrogen base.

Explanation:

I did the test an Edge.

Answer:

0.22 moles of air we carry inside our lungs.

Explanation:

An ideal gas is a theoretical gas that is considered to be composed of point particles that move randomly and do not interact with each other. Gases in general are ideal when they are at high temperatures and low pressures.

The gas laws are a set of chemical and physical laws that allow determining the behavior of gases in a closed system. The parameters evaluated in these laws are pressure, volume, temperature and moles.

The ideal gas law is an equation that relates the variables pressure P, temperature T and volume V if the amount of substance, number of moles n, remains constant and where R is the molar constant of the gases as follows:

P * V = n * R * T

In this case:

Replacing:

0.98 atm* 5.8 L= n* 0.082 [tex]\frac{atm*L}{mol*K}[/tex] * 310 K

Solving:

[tex]n=\frac{0.98 atm* 5.8 L}{0.082 \frac{atm*L}{mol*K} *310 K}[/tex]

n= 0.22 moles

0.22 moles of air we carry inside our lungs.

Answer:

5

Explanation:

you have two zeros that are sandwiched in between and one following a signifincant figure after the decimal.

Answer:

3). Chemical potential energy

1). lower in charcoal than in coal.

Explanation:

Chemical potential energy is defined as the energy that can be absorbed or stored in a substance's chemical bonds. It can be released when there is a change in the number of particles of the substance.

As per the question, coal releases more heat than charcoal because 'the chemical potential energy of charcoal is lower than the coal' and hence, the latter would release more heat on burning i.e. the energy that was absorbed in the chemical bonds of the substance. Hence, option 3 and 1 are the correct answers.

Answer:

8.3334%

Explanation:

You have two masses. To find the percent of sodium chloride in water by mass, you divide the mass of NaCl by water. First, make both units the same. Easiest is to convert kg into g. 1.5kg = 1500g

125g NaCl/1500g H2O = 0.0833333333 ==> 8.3334%

Answer: D. All of the above

Answer:

B. Alpha Particles

Explanation:

P: Have a Nice Day!

the  Answer is C

Both the atomic mass and the atomic number increase from left to right.

Answer: is C

Explanation:

Both the atomic mass and the atomic number increase from left to right

Answer:

formed at earths surface

Explanation:

so easy

Answer:

match emit 350 J light energy.

Explanation:

By law of conservation of energy,  total energy before and after reaction for an isolated system remains constant.

Total energy for unlit match = 1000 j

When it burns type of energy released

thermal energy = 400 j

light energy --> it value is unknown which we have to find

also remaining match has 250 joule of chemical energy

applying   law of conservation of energy

energy before match was unlit = energy after match was lit

1000 j = thermal energy + light energy + chemical energy of remaining match

1000 J = 400 J  + light energy + 250 J

light energy = 1000 J - 400J - 250J

light energy = 350 J

Thus, match emit 350 J light energy.

Answer: Meteorhpayne

Explanation: Correct me if im wrong :(

Answer:

A.  Peroxide breaking down into water and oxygen

Explanation:

Generally when it comes to changes, there are physical and chemical changes. In physical changes, there are no new substances been formed, however in chemical change new substances are formed.

A.  Peroxide breaking down into water and oxygen

This is a chemical change.

B . Bubbles forming when a pot of water is heated

This is a physical change

C. A pair of jeans soaked in water drying after hanging outside

This is a physical change

D . A block of ice decreasing in size due to a change in temperature

This is a physical change.

Only option A is different from the rest,hence this is the answer.

Answer:

Explanation:a

Scientific predictions are best described as consistent data that are presented in the form of if and then. It is a solution to the problem that may be identified. Thus, option a is correct.

Scientific prediction is a statement that describes the events of the future that are not always correct or incorrect. In scientific research, the experiment is conducted based on the hypothesis to draw conclusions and results that are expected.

The expected results are said to be scientific predictions when they are represented in the form of "if and then" before the analysis of the experimental method and its result are done. It is an account of the events that may possibly take place under specific conditions.

Therefore, option A. scientific prediction is an expected problem.

Learn more about scientific predictions, here:

https://brainly.com/question/20101086

#SPJ2

Answer:

he oxygen ion you have with 8 protons attracting 10 electrons is larger, ... As a result, the 3Al3+ ion will be smaller than the Si element, which has ... O<Al3+<Si<Al<O2-<Ag<Rb<Cs ... It is fairly easy to arrange the atoms according to atomic size. ... I would put it between Al and Ag .

Explanation:

Answer: because the very polar water molecules attract both the positively charged sodium ions and the negatively charged chloride ions.

Answer: An air mass that originates over land in Central America is most likely warm & dry.

Answer:

Explanation:

A mixture of a weak acid and its conjugate base (or a mixture of a weak base and its conjugate acid) is called a buffer solution, or a buffer. Buffer solutions resist a change in pH when small amounts of a strong acid or a strong base are added (Figure 1). A solution of acetic acid and sodium acetate (CH3COOH + CH3COONa) is an example of a buffer that consists of a weak acid and its salt. An example of a buffer that consists of a weak base and its salt is a solution of ammonia and ammonium chloride (NH3(aq) + NH4Cl(aq)).

The pH of the resulting buffer solution is 6.60.

pH of acidic  buffer solution is calculated by Henderson equation which is,

    pH =pK[tex]_a[/tex] +log[salt]/log[acid]

As the buffer is diluted the concentration is reduced to half, that is

[acid]=0.075 M

[salt]=0.02 M    pK[tex]_a[/tex]=4.74

substituting these values in Henderson's equation for acid buffers,

pH=4.74+log[0.075]/[0.02]

     =6.6071

Thus, the pH of resulting buffer solution is 6.6071.

Acid buffers  consist of a solution  of weak acid  and its salt.A commonly used acid buffer is  prepared by mixing  acetic acid and sodium acetate.

Henderson equation is used to calculate pH of buffer solution and ratio of salt to acid to prepare acid solution. pK[tex]_a[/tex] for acid buffers is constant.

To know more about buffers click here:

https://brainly.com/question/16857546

#SPJ2

Answer:

adding or removing protons

Explanation:

Elements are defined by the number of protons they have. If you add or subtract protons then that changes and makes a new element.

Answer:

by changing the number of protons in the nucleus

Your height should be measured in meters. Centimeters is much too small of a unit to measure the several feet most people are.

Answer: crushing a can, boiling water, breaking a glass

Explanation:

Answer: The density of the rock is 2g/mL. Hope this helped! :)

Explanation:

V= 3.0mL                                                               D=M/V

M= 6.0g

D=6.0g/3.0mL

D= 2.0g/mL

Answer:

B.  Na

Explanation:

To identify an atom, you simply need to look at the number of protons.  This atom has 11 protons.  On the periodic table, you can see that the element with 11 protons is sodium (Na).

A wind-up toy that is not wound up will have Potential Energy Hence, The correct option is Option (B)

Potential energy is that the energy control by associate object due to its position relative to alternative objects, stresses among itself, its charge, or alternative factors.

The total energy of a mechanical toy is given as follows ;

Total Mechanical Energy = Kinetic Energy + Potential Energy

During the winding up of the coil, the total energy becomes the kinetic energy

The total energy at the point of winding up of the coil = The kinetic energy supplied to the toy by winding the coil

From the first law of thermodynamics, energy can not be created nor destroyed however may be modified from one type to a different

Due to the coil being prevented from unwinding, the kinetic energy stored as Potential energy of the toy

When the toy is operated it then unwinds the coil bringing about motion and converting back the potential energy to kinetic energy by itself as if it was alive.

Therefore, A wind-up toy that is not wound up will have Potential Energy Hence, The correct option is Option (B)

Learn more about Potential Energy here ;

https://brainly.com/question/24284560

#SPJ2

Answer:

The total measurements of the oil is 3.45mL

Explanation:

Given

1.5 mL, 0.75 mL, and 1.2 mL.

Required

Determine the total

To get the total, we simply add the given volumes together.

[tex]Total = 1.5 mL+ 0.75 mL + 1.2 mL[/tex]

[tex]Total = 3.45mL[/tex]

Hence;

The total measurements of the oil is 3.45mL

Answer:

Explanation:

There are 3 types of plastids :-

1) Chloroplasts:- The green plastids which contain chlorophyll pigments for photosynthesis.

2) Chromoplasts:-The coloured plastids for pigment synthesis and storage.

3) Leucoplasts:- The colourless plastids for monoterpene synthesis found in non- photosynthetic parts of the plants.

They are of three types:-  

a) Amyloplasts- stores starch.

b) Proteinoplasts-  stores proteins.

c) Elaioplasts- stores fats and oils.

Answer:

scientists benefit the society because they prove many theories, plus they are always finding new solutions to new things

Explanation:

Answer:

The scientist uses specialized training to help solve problems

faced by society.

Explanation:

A P E X

Answer:

Im pretty sure the answers b

Explanation:

Because if its talking about overall tempature the it means ihas tension with high surface.

Complete question :

A jeweler has five rings, each weighing 18 g, made of an alloy of 10% silver and 90% gold. She decides to melt down the rings and add enough silver to reduce the gold content to 75%. How much silver should she add?

Answer:

Kindly check explanation

Explanation:

Given the following :

Weight of each alloy = 18g

Initial % of Silver = 10% = 0.1

Initial % of Gold = 90% = 0.9

New % of gold = 75% = 0.75

Hence, new % of silver will be (1 - 0.75) = 0.25

Let the amount of silver to be added = s

Hence,

Initial gold content = final gold content + added silver

18 * 0.9 = 0.75(18 + s)

16.2 = 13.5 + 0.75s

16. 2 = 13.5 + 0.75s

16.2 - 13.5 = 0.75s

2.7 = 0.75s

s = 2.7 / 0.75

s = 3.6

S = 3.6

Hence the amount of silver needed per ring in other to reduce the gold content = 3.6g

Total for the 5 rings = (3.6 * 5) = 18g