if line segment g f = 3.2 ft, which is a possible measure of line segment t s? 1.6 ft 3.0 ft 3.2 ft 4.0 ft\

answer: c

explanation: it's job is to store and release charge

Answer:

C- It stores and releases charge

Answer:

atomic mass = 20.2 amu

atomic number = 10

Explanation:

The atomic mass is the average mass of an atom of a particular element. For neon, the atomic mass is about 20.180 amu. Rounded to the nearest tenth, the atomic mass is 20.2 amu.

The atomic number is the number of protons in the nucleus of a particular element. For neon, the atomic number is 10.

Both of these values can usually be found on the periodic table under neon (Ne).

Answer:

The area estimate is somewhat inaccurate because the length * width of the shoe will be an inaccurate measurement of the area of the shoe that actually contacts the floor.

The diagram is labelled to DRAW the RESULTANT wave and LABEL the areas of interference with CI, DI and/or points of TDI.

When a light ray falls on the interface of two medium like air and water, then the portion of light is reflected and another portion of the light is refracted into the water medium. The angle of incidence is equal to the angle of reflection but the angle of incidence is larger then the angle of refraction.

Open the attached file. It shows 2 waves (a blue one and an orange one) that are moving through the same medium at the same time.

Thus, the diagram is labelled.

Learn more about refraction.

https://brainly.com/question/14760207

#SPJ1

Temperature is increased the pressure also increases due to fast movement of molecules because of more energy.

The temperature of the gas is directly proportional to the pressure. Faster moving particles will collide with the walls of the container that put force on the wall which leads to increase in pressure.

So we can conclude that temperature is increased the pressure also increases due to fast movement of molecules because of more energy.

Learn more about pressure here: https://brainly.com/question/25736513

#SPJ1

Total internal reflection causes light to be completely reflected across the  boundary between the two media but not transmitted.

The term total internal reflection occurs when light is moving from a denser to a less dense medium such as from glass to air. This phenomenon occurs at the interface between the two media.

There are two conditions necessary for total internal reflection and they are;

1) Light must travel from a denser to a less dense medium

2) The angle of incidence in the denser medium must be greater than the critical angle.

Total internal reflection causes light to be completely reflected across the  boundary between the two media but not transmitted.

Learn more about total internal reflection:https://brainly.com/question/13088998

#SPJ1

Sian wants to count the number of seconds it takes for a beaker's contents to become purple from clear. She should utilize a stopwatch as her instrument for this job.

Watch that, when turned on and off, measures the amount of time that has passed since a specific time.

Sian wants to measure the number of seconds that it takes for the contents of a beaker to change from clear to purple. Stopwatch is the tool she should utilize for this purpose.

Hence, option B is correct.

To learn more about the stopwatch refer;

https://brainly.com/question/13758413

#SPJ1

Answer: Sian wants to count the number of seconds it takes for a beaker's contents to become purple from clear. She should utilize a stopwatch as her instrument for this job.

option b

Explanation:

Answer:

The answer is option E

Explanation:

The particles vibrate in a perpendicular direction with respect to the wave motion

Answer:

A

Explanation:

A has the most potential energy as it is higher up so it has the most gravitational potential energy.

According to the graph of displacement vs. time, the object's velocity is 0.02 m/s

The displacement is the shortest distance travelled by the particle. It is the vector quantity which re[presents both the magnitude and direction.

Velocity is the time rate of change of displacement with time.

Given is the displacement 0.2 m and time taken is 10s. So, the velocity is

v = 0.2/10

v = 0.02 m/s

Thus, the object's velocity is 0.02 m/s

Learn more about displacement.

https://brainly.com/question/11934397

#SPJ1

Graphs A, B, C, and D match the numbers 3,4,1, and 2 respectively.

Distance is a numerical representation of the distance between two objects or locations.

The distance can refer to a physical length or an estimate based on other factors in physics or common use. |AB| is a symbol for the distance between two points A and B.

Graph C shows a person leaving home and traveling at a constant speed.

Graph D shows a person leaving home, traveling at a constant speed, stopping for a short time and then returning home.

Graph A shows a person leaving home, traveling to their destination, and immediately returning.

Graph B shows a person leaving home, traveling at a constant speed, stopping for some time, and then continuing the journey away from home.

Hence, the numbers 3, 4, 1, and 2 are matched by graphs A, B, C, and D, respectively.

To learn more about the distance refer to the link;

https://brainly.com/question/26711747

#SPJ1

The answer for the missing labeling as (i) and (ii) will be (i)thermometer and (ii)condenser.

A burner is a device intended to guarantee that the flame is stabilized.

By creating a proper flow field to cause the initial temperature rise, a  The fuel/air combination is heated from within the flame to the ignition temperature.

When the flame or heat is created in fuel-burning or heat-generating equipment.

Wood, coal, kerosene, LPG, petrol, and diesel are a few of the often utilized fuels. In order to cook, heat, power vehicles, and create electricity, we utilize fuels.

The barrel, collar, air holes, gas intake, gas valve, and base are the different pieces of a Bunsen burner. Each component is essential to the process of creating a flame.

Hence, the answers for the missing labeling will be  (i) thermometer and (ii) condenser.

To learn more about the burner refer;

https://brainly.com/question/1477483

#SPJ1

Answer:

B. A system cannot take in additional matter.

Explanation: The total amount of energy in the universe remains constant, it can merely change from one form to another.

Hope it helps you:)))

have a good day

From the calculations and the data provided, the speed is obtained as 15 m/s

The term momentum refers to the product of mass and velocity. Given that we can now proceed with the answer.

Since;

p = mv

m = 750kg

v = 5 km/hr or 1.4 m/s

p = 750kg *  1.4 m/s

p = 1050 kgm/s

If the mass of the body is 70kg, the speed is

v = p/m

v = 1050 kgm/s/70 Kg

= 15 m/s

Learn more about momentum:https://brainly.com/question/24030570

#SPJ1

The energy-level change occurs as the atom is absorbs a 2.03-eV photon.

The energy change of the mercury atom is calculated as follows;

Energy emitted by a photon when it falls from level b to energy level e is calculated as follows;

ΔE = -3.71 eV - (-5.74 eV)

ΔE =  -3.71 eV + 5.74 eV

ΔE = 2.03 eV

When electron jumps from  lower energy level to higher energy level, energy is absorbed, thus, the energy-level change occurs as the atom is absorbs a 2.03-eV photon.

Learn more about energy level here: https://brainly.com/question/14287666

#SPJ1

Ten minutes after you stop exercising, your heart rate should be equal to your heart rate reserve

This is defined as the heart rate the body decreases to after an exercise session has been done.

This however varies according to age of individuals and is calculated by finding the difference between the maximum and resting heart rate.]

Read more about Heart rate here https://brainly.com/question/1575299

#SPJ1

Newton's motion laws state that if an object is at rest or in movement, it will tend to maintain its basal state.

Newton's motion laws are a set of scientific statements aimed at explaining the physical property of movement.

These laws explain why objects in movement tend to maintain the same velocity for a short period of time.

In conclusion, Newton's motion laws state that if an object is at rest or in movement, it will tend to maintain its basal state.

Learn more about Newton's motion laws here:

https://brainly.com/question/10454047

#SPJ1

The length of the immersed part of the wood​ is 0.2m.

The density is the ratio of the mass and the volume of the object. It is denoted by ρ.

ρ = mass/Volume = m/V

Volume = Area of cross-section A x height h

Given is a piece of wood of mass 40g =0.04kg and uniform cross-sectional area A= 2cm² =2x10⁻⁴ m² floats upright in water.

The density of water ,ρ = 1000 kg/m³

The density related to length of part immersed is

1000 = 0.04/ (2x10⁻⁴ x h)

h = 0.2m

Thus, the length of the immersed part of the wood​ is 0.2m.

Learn more about density.

https://brainly.com/question/9215083

#SPJ1

Answer:

Ultrasound imaging.

Explanation:

It uses high-frequency sound waves to view inside the body.

Answer:

I say 150 because i aded 850+150= 1000 so yea thats how i got my answer

Explanation:

Answer:

P V = N R T     so

V2 / V1 = T2 / T1        assuming other variables stay constant

V2 = (273 / 305) * V1

V2 = .90 V1

Cheer dance​ is a routine composed of yells and cheers gymnastic skill and dance.  

Cheer dance or cheerleading is a group activity used to entertain fans at athletic events and inspire louder, more enthusiastic cheering. It combines dancing and acrobatic aspects with shouted phrases.

A never-ending range of diverse stunts, jumps, pyramids, dances, and chants that integrate a variety of different movements can be included in the immensely complex sport of cheerleading. Base, partner, and spotter are the three primary cheerleading roles. These roles are all a part of cheerleading stunts, which pose the greatest risk of harm to participants.

It is a competitive sport and leisure activity made up of a set routine with necessary performance components, much like in gymnastics and dance. Additionally, it hopes to get the crowds to cheer in team sports event.

Learn more about cheer dance, refer the link:

https://brainly.com/question/29788167

#SPJ2

Your question is incomplete, but most probably your full question was:

1. It is a routine composed of yells and cheers, gymnastic skills and dance.

A. Contemporary dance

B. Hip-hop dance

C. Street dance

D. Cheer dance​

Answer:

Explanation:

given :-

force applied = 117.6N

Area = 20 m^2

Pressure =?

solution:-

Pressure = Force / Area

= 117.6 N / 20 m^2

= 5.88 Pascals

Hope it helps :D!

Explanation:

Answer: you got it duDee

Explanation:

The apparent weight of the pilot would be 619.48 N and the speed he would experience at weightlessness is 192. 97 m/s

Apparent weight is a property of object that co-relates to the heaviness of the object.

It differs from the weight of an object as a result of the in-balance between the force acting on the object and an equal but opposite force

Formula:

Apparent weight = Real weight (mg) - m v∧2 ÷ r

Where m = mass

g = acceleration due to gravity = 9.8 m/s²

v = constant velocity = 2. 10 × 10∧2 m/s

r = radius = 3.80 × 10∧3 m

Note that weight = mg

m = weight ÷ g = 623 ÷ 9.8 = 63. 57 kg

a. Apparent wieight = 623 - (63. 57 × 2.10 × 10∧2 × 2.10 × 10∧2) ÷ 3.80 × 10∧3)

= 623 - (63.57 × 210) ÷ 3800

= 623 - 13377 ÷ 3800

= 623 - 3. 52

= 619.48 N

b. At weightless, weight = 0

Speed, V = √g× r = √ 9.8 × 3800 = √37,240 = 192. 97 m/s

Hence, The apparent weight of the pilot would be 619.48 N and the speed he would experience at weightlessness is 192. 97 m/s

Read more on apparent weight here:

https://brainly.com/question/11180653

#SPJ1

The portion of the object submerged in water is determined as 0.25.

The fraction of the object submerged in water is calculated as follows;

S.G =  (density of object) / (density of water)

where;

S.G = (250 kgm⁻³) / (1000 kgm⁻³)

S.G = 0.25 = ¹/₄

Thus, the portion of the object submerged in water is determined as 0.25.

Learn more about density here: https://brainly.com/question/1354972

#SPJ1