Help plzzZZZZ I really need help with this

Answer: C, B, D (not sure about this one sorry) and C

Explanation:

Answer:

6=100  

Explanation:

Answer:

Gravitational potential energy of water behind the dam

Explanation:

Energy can be defined as the ability (capacity) to do work. The two (2) main types of energy are;

a. Gravitational potential energy (GPE): it is an energy possessed by an object or body due to its position above the earth.

b. Kinetic energy (KE): it is an energy possessed by an object or body due to its motion.

Hydroelectric power plant refers to a renewable source of energy used for the generation of electricity, through the use of powerful hydraulic steam turbines operating at high voltage and are being driven by the energy acquired by water falling from a height and flowing through a penstock (pipe) i.e the mechanical energy (gravitational potential energy + kinetic energy).

At a hydroelectric power plant, potential energy is changed into kinetic energy. The kinetic energy is then transformed into electrical energy.

The source of the energy that turns the turbine in the power plant is Gravitational potential energy of water behind the dam, usually from streams or rivers.

Answer:

-1, 0, +1

Explanation:

n = 2 n = 0,1,2,3,.................n

l= n-1 = 2-1 =1. l= 1,2,3,4....................n-1

m = l is 1 so now write the value of magnetic moment as -1,0,+1

for eg . if the value of l comes to 2 then u will write the value of m as -2,-1,0,+1,+2 .

i hope it will help u .....

Answer:

Correct

Explanation:

According to the balanced chemical reaction, 2 mol FeBr3 are consumed for every 3 mol Na2S consumed.

A balanced equation obey the law of conservation of mass. The coefficients are the numbers which are added to balance the chemical equation. Here the given mole ratio is correct.

An equation in which the number of atoms of reactants and products on both sides of the equation are balanced is defined as the balanced chemical equation. The coefficients which are added in front of the formula of each component represents the number of the species.

A molar ratio denotes the ratio between the amounts in moles of any two compounds involved in a balanced chemical reaction. By comparing the coefficient of each component, the mole ratio can be determined.

Here for the given reaction, for every 3 moles of Na₂S consumption 2 moles of FeBr₃ is also consumed. So the molar ratio of Na₂S to FeBr₃ is 2/3. Molar ratios are used as the conversion factors between products and reactants in many chemistry problems.

To know more about mole ratio, visit;

https://brainly.com/question/29095152

#SPJ7

Answer:

The (aq) means that the NaCl is dissolved in water.

Explanation:

Answer:

A water-based solution of sodium chloride

Explanation:

ck12

Answer:

the answer is twenty-four

Answer:

A. It will move.

Answer:

let me tell u what ASAP stands for Explanation:

Answer:Douse the fire with baking soda: The chemical compound sodium bicarbonate, commonly called baking soda, is effective for extinguishing this type of fire. It takes a lot of baking soda to smother a grease fire, so pour it on while the flames are still small for the greatest effect

Explanation:

The grease fire has been put down by the addition of sodium bicarbonate as the extinguisher.

Grease fire has been defined as the fire that has been started with the over heating of the cooking oil at home. The fire has been started with the burning of the flammable liquids.

The fire in the cooking oil has been controlled with the addition of the sheet over the fire and turning off the flame.

The addition of water to grease fire results in the splashing of water over the fire and the spreading, resulting in the hazardous effects.

The sodium bicarbonate or baking soda has been used to put down grease fire.

Learn more about grease fire, here:

https://brainly.com/question/1142755

Answer:

mamamkalalllaamakkaoakmaa

Answer:

0-14

Explanation:

The ideal gas relates the volume, pressure, and temperature to each other. The balloon was cooled to -120 degrees celsius.

Charle's law states the direct relationship between the volume and the temperature of the hypothetical gas. The law is given as,

[tex]\rm \dfrac{V_{1}}{T_{1}} = \rm \dfrac{V_{2}}{T_{2}}[/tex]

As it can be seen from the question the volume of the gas in the balloon is decreasing so the temperature will also decrease.

Given,

Initial volume = 12.0 L

Final volume = 5.0 L

Initial temperature = 357.15 K

The final temperature is calculated as:

[tex]\begin{aligned} \rm T_{2} &= \rm \dfrac{V_{2}T_{1}}{V_{1}}\\\\&= \dfrac{5\times 357.15}{12}\\\\&= 148.81\;\rm K\end{aligned}[/tex]

Therefore, -120 degrees celsius is the final temperature of the balloon.

Learn more about Charle's law here:

https://brainly.com/question/16404056

#SPJ2

Answer:

solute

Explanation:

for example sugar salt etc

solute dissolve in solvent

Answer:

pH≈1.35

Explanation:

-log(0.045)≈1.35

Answer:

65 g/100 mL of water

Explanation:

Answer:

65g/100ml of water.

Explanation:

Edge 2021.

Answer:

The equilibrium concentration of chlorine gas, Cl₂(g), is 0.0625 M

Explanation:

Chemical equilibrium is established when there are two opposite reactions that take place simultaneously at the same speed, so that no changes are observed as time passes, despite the fact that the substances present continue to react with each other.

The mathematical expression that represents Chemical Equilibrium is known as the Law of Mass Action and is stated as: The ratio of the product of high concentrations to the stoichiometric coefficients in the reaction of products and reactants remains constant at equilibrium. For any reaction:

aA + bB ⇄ cC + dD

the equilibrium constant Kc is calculated as:

[tex]Kc=\frac{[C]^{c} *[D]^{d} }{[A]^{a} *[B]^{b}}[/tex]

In this case, you have:

2 ICl(g) → Cl₂(g) + I₂(g)

So, the equilibrium constant Kc is:

[tex]Kc=\frac{[Cl_{2} ]*[I_{2} ]}{[ICl]^{2} }[/tex]

Being:

Replacing:

[tex]0.1=\frac{[Cl_{2} ]*0.40 M}{(0.50 M)^{2} }[/tex]

Solving:

[tex]0.1=\frac{[Cl_{2} ]*0.40 M}{0.25 M^{2} }[/tex]

0.1= 1.6 [tex]\frac{1}{M}[/tex]* [Cl₂]

[Cl₂]= 0.1 ÷ 1.6 [tex]\frac{1}{M}[/tex]

[Cl₂]= 0.0625 M

The equilibrium concentration of chlorine gas, Cl₂(g), is 0.0625 M

The equilibrium concentration of chlorine gas, if the equilibrium concentrations of ICl(g) and I₂(g) are known to be 0.50 M and 0.40 M respectively is 0.0625M.

Equilibrium constant for any reaction will be define as the ratio of the concentration of products to the concentration of reactants with raise to their respective coefficients.

Given chemical reaction is:

2ICl(g) → Cl₂(g) + I₂(g)

Equilibrium constant for this reaction will be calculated as:

Kc = [Cl₂][I₂] / [ICl]², where

Kc = equilibrium constant = 0.10

[I₂] = concentration of iodine gas = 0.40 M

[ICl]² = concentration of ICl = 0.50 M = (0.50M)² = 0.25M²

[Cl₂] = concentration of chlorine gas = to find?

On putting all these values on the above equation and calculate for the value of [Cl₂] as follow:
[Cl₂] = Kc × [ICl]² / [I₂]

[Cl₂] = (0.10)(0.25) / (0.40)

[Cl₂] = 0.0625M

Hence, equilibrium concentration of chlorine gas is 0.0625M.

To know more about equilibrium constant, visit the below link:

https://brainly.com/question/12858312

Reactions are faster when air contains a higher concentration of water.

High temperature and high relative humidity are very important factors that drive a reaction in which biomass decays. At high temperature and high relative humidity, decomposition occurs faster.

Hence, from the data presented, we can see that, reactions occur more quickly in air with a high concentration of water.

Learn more about decay: https://brainly.com/question/14437985

Answer:

Fluorine

Explanation:

It's tendency to gain electron is higher than Ca and P

Nitrogen-fixers are the critical links between atmospheric nitrogen and organisms that need nitrogen to survive.

Nitrogen fixers are the compounds which are used in the nitrogen fixation process to convert the nitrogen molecule in other nitrogenous compounds.

So, the nitrogen fixers converts the atmospheric nitrogen molecule (N₂) into the other compounds like ammonia (NH₃) or any other useful nitrogenous compounds which will be used or absorbed by the soil or any other aquatic species. Some examples of nitrogen fixers are bacteria, clostridium, rhizobium, and many more.

Hence option (A) is correct i.e. atmospheric nitrogen and organisms that need nitrogen to survive.

To know more about nitrogen fixers, visit the below link:
https://brainly.com/question/21040043

Answer:

pKa = 3.97

Explanation:

Let's state the equations:

NaA →  A⁻  +  Na⁺

A⁻ + H₂O  ⇄  OH⁻  +  HA    Kb

We don't have the concentration of [OH⁻] but we do know pH, so we can determine, pOH and after that, [OH⁻].

14 - pH = pOH → 14 - 8.70 = 5.30

10^-pOH = [OH⁻]  → 10⁻⁵'³⁰ = 5.01×10⁻⁶ M

Initially we can know, the moles of base, we had.

20 mL . 0.27M = 5.4 mmoles. So now, let's make the expression for Kb.

Kb = [OH⁻] . HA / [A⁻]

As the [OH⁻]  is so low, we can assume, there where no loses and the salt is well concentrated. So:

Kb = (5.01×10⁻⁶)² / 0.27 → 9.29×10⁻¹¹

Kw = Ka . Kb, then Ka = Kw/ Kb

Ka = 1×10⁻¹⁴ /9.29×10⁻¹¹ = 1.08×10⁻⁴

pKa = - log Ka → - log 1.08×10⁻⁴ = 3.97

Answer:

Secure landfills Landfilling of hazardous solid or containerized waste is regulated more stringently than landfilling of municipal solid waste. Hazardous wastes must be deposited in so-called secure landfills, which provide at least 3 metres (10 feet) of separation between the bottom of the landfill and the underlying bedrock or groundwater table.

Explanation:

Answer:

Oh hey sorry, they deleted my account again..

Explanation:

a transverse wave, this is the magnitude of height of a wave from origin to crest. In a longitudinal wave, this is corresponds to how much the wave is compressed, as compared to areas of little compression. This is wave whose energy travels in the same direction as the energy is transferred

In a transverse wave, amplitude is the magnitude of height of a wave from origin to crest. In a longitudinal wave, crest is corresponds to how much the wave is compressed

A wave is a dynamic disturbance of one or more quantities that propagates and is commonly described by a wave equation.

Hence for the transverse wave that is amplitude and for the longitudinal wave that is crest.

To know more about transverse & longitudinal waves, visit the below link:
https://brainly.com/question/13761336

#SPJ2

Answer:

From my view the answer is

D. Forests

Answer:

393.75mL

Explanation:

We know that

C1V1= C2V2

where C = centration, V= volume

C1= 0.45 M

V1= 175 mL = 0.175 L

C2 = 0.2M

⇒V2= C1V1/C2

⇒V2 = 0.175×0.45/0.2

=0.39375L

Therefore, amount of water needed= 393.75mL

Answer:

In plants, chloroplasts occur in all green tissues, though they are concentrated particularly in the parenchyma cells of the leaf mesophyl. An example of a chloroplast is a cell in algae that consumes carbon dioxide and releases oxygen while creating sugar. A plastid that contains chlorophyll and is found in the cells of green plants and algae.

Explanation:

please mark brainlest

Answer: I would say C or D.

Explanation: Maybe because there are four main tissue types in the body: epithelial, connective, muscle, and nervous. Each is designed for specific functions.

In chloroplast it is the structure within the cells of plants and green algae.

In stomach tissue has a thin simple columnar epithelial layer for secretion and absorption.

In bone tissue it is tissue that gives strength and structure to bones. Bone is made up of compact tissue (the hard, outer layer) and cancellous tissue (the spongy, inner layer that contains red marrow). Bone tissue is maintained by bone-forming cells called osteoblasts and cells that break down bone called osteoclasts.

Answer:

We need food to fuel our bodies for energy, growth and repair. The digestive system converts the foods we eat into their simplest forms, like glucose (sugars), amino acids (that make up protein) or fatty acids (that make up fats).Explanation:

hopes its right