explain in 3 complete sentences

Answer:

OH- is the correct answer

mark me brainst answer

Answer:

h

Explanation:

The common ion in all acids is the hydrogen or hydronium ion

Answer:

The physical properties of matter are those characteristics that can be measured without altering the atomic structure, while the chemical properties of matter are those characteristics that result in a change in the atomic structure.

Answer:

575g

Explanation:

Mole ratio Fe : O2 = 3:2

so moles of Fe = 1.5 x 6.85 = 10.275 moles

mass=moles x Ar

Ar Fe= 56

mass = 10.275 x 56=575g

Answer:

Response is below

Explanation:

The different types of mining are underground, surface, placer, and in-situ. Underground mining uses various materials to excavate resources from beneath the surface of the Earth. Surface mining is a category of mining that in which soil and rock overlying the mineral deposit are removed. Placer mining is the mining of stream bed deposits for minerals. In-situ mining is a mining process used to recover minerals such as copper and uranium through boreholes drilled into a deposit.

Answer: Hence, mass of CO2​ is 22g.

Explanation: N/A

Answer:

mole=mass/RMM

5mole =mass/44

mass= 44×5=220grams

Explanation:

Co2 molecular weight =44 ,cross multiply then you get your mass.

Answer:

4.5M

Explanation:

Here is why:

Explanation:

The reaction between an acid and a base is known as a neutralisation reaction.

Reactant concentration. Increasing the concentration of one or more reactants will often increase the rate of reaction. ...

Physical state of the reactants and surface area. ...

Temperature. ...

Presence of a catalyst.

ammonia

An alkaline gas which produces dense white fumes when reacted with HCl gas is ammonia and fumes are of compound ammonium chloride.

BRAINILIEST PLEASE

Answer: Beta decay occurs when a nucleus is unstable because it has too many or too few neutrons relative to protons. The nucleus emits a beta particle and energy.  In beta-minus decay, a neutron breaks down to a proton and an electron, and the electron is emitted from the nucleus.

Explanation:

Answer:

sorry i never learned this

Explanation:

Answer:

Fe₂(SO₄)₃ + 6KOH —> 3K₂SO₄ + 2Fe(OH)₃

The coefficients are: 1, 6, 3, 2

Explanation:

__Fe₂(SO₄)₃ + __KOH —> __K₂SO₄ + __Fe(OH)₃

To determine the correct coefficients, we shall balance the equation. This can be obtained as follow:

Fe₂(SO₄)₃ + KOH —> K₂SO₄ + Fe(OH)₃

There are 2 atoms of Fe on the left side and 1 atom on the right side. It can be balance by writing 2 before Fe(OH)₃ as shown below:

Fe₂(SO₄)₃ + KOH —> K₂SO₄ + 2Fe(OH)₃

There are 6 atoms of OH on the right side and 1 atom on the left side. It can be balance by writing 6 before KOH as shown below:

Fe₂(SO₄)₃ + 6KOH —> K₂SO₄ + 2Fe(OH)₃

There are 6 atoms of K on the left side and 2 atoms on the right side. It can be balance by writing 3 before K₂SO₄ as shown below:

Fe₂(SO₄)₃ + 6KOH —> 3K₂SO₄ + 2Fe(OH)₃

Now, the equation is balanced.

Therefore, the coefficients are: 1, 6, 3, 2

Answer:

F

T

F

T

Explanation:

i hope these are right

Answer:

automatic transmission

Explanation:

An automatic transmission (sometimes abbreviated to auto or AT) is a multi-speed transmission used in motor vehicles that does not require any driver input to change gears under normal driving conditions.

Answer:

3rd law

Explanation:

when two objects interact, they apply forces to each other of equal magnitude and opposite direction.

Answer:

i believe it's D

Explanation:

Answer:

D

Explanation:

Answer:

i did c

Explanation:

Answer:

I think it would be c

Explanation:

Answer:

Some of the major biogeochemical cycles are as follows: (1) Water Cycle or Hydrologic Cycle (2) Carbon-Cycle (3) Nitrogen Cycle (4) Oxygen Cycle. The producers of an ecosystem take up several basic inorganic nutrients from their non-living environment.

Explanation:

Answer:

The right answer is "236.53 g".

Explanation:

The given values are:

P = 1.09 atm

V = 186 liters

The reaction will be:

⇒  [tex]KClO_3 (s)\rightarrow 2Kcl(s)+3O_2(g)[/tex]

The moles of O₂ will be:

=  [tex]\frac{PV}{RT}[/tex]

On substituting the values, we get

=  [tex]\frac{1.09\times 186}{0.0821\times 850}[/tex]

=  [tex]\frac{202.47}{69.785}[/tex]

=  [tex]2.90 \ moles[/tex]

Now,

1 mole O₂ is produced from

= [tex]\frac{2}{3} \ mol \ KClO_3[/tex]

then,

2.90 mole O₂ is produced from 2 mol KClO₃

= [tex]\frac{2}{3}\times 2.90[/tex]

= [tex]1.93 \ mol \ KClO_3[/tex]

hence,

The number of grans of solid in the engine will be:

= [tex]1.93\times 122.55[/tex]

= [tex]236.53 \ g[/tex]

Answer:

B- Increase

Explanation:

In the event that the temperature is increased, the normal speed and dynamic energy of the gas atoms increment. In the event that the volume is held steady, the sped up the gas particles brings about more incessant and more powerful crashes with the dividers of the compartment, hence expanding the pressing factor

Answer:

I think it's true

Explanation:

hey by the way

Answer:

The empirical formula of the hydrocarbon is C₂H₅

Explanation:

The formula for the hydrocarbon is [tex]C_xH_y[/tex]

The mass of CO₂ produced per 1,000 g of H₂O = 1,955 g

The equation for the chemical reaction is given as follows;

[tex]C_xH_y[/tex] + (x + y/4) O₂ → XCO₂ + y/2H₂O

From the given chemical equation, counting the number of atoms on both sides of the equation, we have;

The molar mass of CO₂ = 44.01 g/mol

The molar mass of H₂O = 18.01528 g/mol

The number of moles of H₂O in 1,000 g of H₂O = 1,000 g/(18.01528 g/mol) = 55.5084351 moles

The number of moles of CO₂ in 1,955 g of H₂O = 1,955 g/(44.01 g/mol) = 44.4217223 moles

Therefore, given that X moles of CO₂ is produced alongside Y/2 moles of H₂O. we have;

X = 44.4217223, Y/2 = 55.5084351

∴ Y = 2 × 55.5084351 = 111.0168702

The ratio of X to Y = X/Y = 44.4217223/111.0168702 = 0.40013488238

∴ The ratio of X to Y = X/Y ≈ 0.4 = 4/10

X/Y ≈ 4/10

The empirical formula is the representation of molecular formula in the smallest whole number ratio of the elements of the molecules

Therefore, when X = 4, Y = 10, from which we have the smallest ratio as;

When X = 2, Y = 5

The empirical formula of the hydrocarbon is therefore, [tex]C_xH_y[/tex] = C₂H₅

The given chemical equation becomes;

C₂H₅ + (2 + 5/4) O₂ → 2CO₂ + 5/2H₂O

C₂H₅ + 3.25 O₂ → 2CO₂ + 2.5 H₂O

We then have;

4C₂H₅ + 13 O₂ → 8CO₂ + 10 H₂O

The empirical formula of the hydrocarbon, [tex]C_xH_y[/tex] = C₂H₅.

Answer:

what they have in common is consist of electrons, protons, and neutrons.

Explanation:

Answer:

Anuclear power plant is used to generate electricity

Answer:

Anuclear power plant is used to generate electricity

thank me later

Explanation:

Answer:

2.57 e-9

Explanation:

The formula is H3O=10^-Ph

10^-8.59=2.57 e-9

Answer:

Explanation:

When the two atoms are in contact, potassium transfers its outer electron to chlorine which readily accepts it, resulting in both atoms achieving a state of eight outermost electrons. With this electron transfer, the ionic bond in KCl is formed.

Hope this helped!!!

Potassium has just one valence electron and Chlorine has 7 electrons, Chlorine needs just one atom to complete its octet which is provided by Potassium atom for formation of Potassium Chloride (KCl).

Chemical bonding is the formation of chemical bonds present between two or more atoms or molecules which give rise to new compound. Bond is formed from electrostatic force present between oppositely charged ions like in ionic bonds or by sharing of electrons like in covalent bonds.

There are two types of Chemical Bonding:

1. Ionic Bonding

It is formed between opposite charged particles like Anion (negatively charged) and Cation (Positively charged) by the strong force of attraction.

For example, KCl formed by the ionic bond formation present between Potassium and Chlorine

2.Chemical Bonding

It is formed between two atoms for completing its octet by sharing of electrons.

For example, [tex]H_2[/tex] formed by sharing the electrons to complete its electronic configuration.

Thus, Potassium has just one valence electron and Chlorine has 7 electrons, Chlorine needs just one atom to complete its octet which is provided by Potassium atom for formation of Potassium Chloride (KCl).

Learn more about Chemical Bonding, here:

https://brainly.com/question/15444131

#SPJ2

Answer:

please give me brainlist and follow

Explanation:

When dilute sulphuric acid is added to barium chloride solution, barium sulphate is formed as a precipitate and hydrogen chloride is formed in aqueous solution.

Answer:

0.72 good luck with the answer