Convert 1663.5 g to mg

Explanation:

Each carbon atom is covalently bonded to four other carbon atoms in diamond. A lot of energy is needed to separate the atoms. This is because covalent bonds are strong. This is the reason why diamond has a high melting point.

Answer:

4320 inches

Explanation:

math

A football field is supposed to be exactly 120yd long, including the end zones is 4320 inches.

Zones are defined as a space that is physically or artificially isolated from other spaces. There are numerous sorts and sizes of zones.

Zones are also defined as a region that is designated as having a specific average annual minimum temperature, which is important for many plants to survive.

There are four types of zones.

The Torrid Zone, Temperate Zone, and Frigid Zone are the three temperature-based regions of the Earth.

Planting zones are predetermined areas based on the types of plants that thrive there.

Thus, a football field is supposed to be exactly 120yd long, including the end zones is 4320 inches.

To learn more about zones, refer to the link below:

https://brainly.com/question/17067679

#SPJ12

Answer:

the rest mass of an electron is 9.1093837915

Answer:

Fundamental properties. The invariant mass of an electron is approximately 9.109×10−31 kilograms, or 5.489×10−4 atomic mass units. On the basis of Einstein's principle of mass–energy equivalence, this mass corresponds to a rest energy of 0.511

Answer:

Presence of impurities in the product.

Explanation:

Laboratory experience has shown that the percent yield obtained from a reaction may be greater than 100% if the product obtained from the reaction contains impurities that causes its mass to be greater than it actually would be if the product was pure.

A typical impurity that may be present in a product is the solvent used. This can be removed by evaporation of the solvent or by washing the product thoroughly.

Reaction of solid products with gases may also increase the percentage yield above 100%.

Answer:

1. d. Person A rounded their measurement

2) a. 105.

b. 76.4

c. 0.04

d. 1.988

Explanation:

1. Measuring an object is done with the least precise one. Person A recorded 1.5cm while Person B recorded 1.50cm of the same object. This measurement differs in the sense that Person A rounded up their measurement to 2 significant figures (1.5) while Person B recorded their answer as three significant figures (1.50).

2. During multiplication and division, the result is written as the measurement in the lowest significant figure.

a. 7.00 x 15.00 = 105. Calculator showed 105.00, which is 5 s.f (two zeros after decimal point are significant). The least significant figure is 3, hence 105.00 is rounded up to 105.

b. 40.2.1.901 = 76.4; The calculator answer of this operation is 76.420200 but since the lowest significant figure is 3. We round up our answer to 3 s.f i.e. 76.4

c. (0.003)(13.2) = 0.04. For this operation, calculator answer is 0.0396, however, the lowest significant figure in the question is 1 i.e. 0.003. Note that the two zeros before 3 are insignificant. Hence, our answer will be rounded up to 1 s.f i.e. 0.04

d. 1.590+ 0.3975 = 1.988. the calculator answer to this operation is 1.9875. However, the least significant figure in the question is 4 i.e. 1.590. hence, the answer will be rounded up to 4 s.f which is 1.988.

Answer: 0.05

Explanation:Divide the length (1.5 cm) by the number of turns (30)

The direct proportion rule allows you to find that the correct answer for the result of the thickness of the copper wire is:

            0.05 cm

Copper is a strong material with which the cross section is constant, therefore the copper wire has a constant thickness, which is why when making a full turn it advances the same amount

When Jade wound thirty times (n = 30) it has the same diameter each time, therefore with a direct rule of proportions we can find the thickness of the wire.

If in 30 laps we have 1.5 cm, in one lap we have?

            [tex]x= 1 turn ( \frac{1.5 cm}{30 turn} )[/tex]  

            x = 0.05 cm

In conclusion using a direct rule of proportions we can that the correct answer for the result of the thickness of the copper wire is:

             0.05 cm

Learn more here:  brainly.com/question/23530320

Answer:

B. what happens when iron rusts in the presence of water

Explanation:

Answer:

See explanation

Explanation:

In this question, we have to remember that in all combustion reactions we will have Oxygen as reactive ([tex]O_2[/tex]) and the products are Carbon dioxide ([tex]CO_2[/tex]) and Water ([tex]H_2O[/tex]). Additionally, for the states, we will have (l) for the liquid state and (g) for the gas state. So, we can analyze each reaction:

Part A.

The formula for nonane is [tex]C_9H_2_0[/tex], with this in mind we can write the combustion reaction:

[tex]C_9H_2_0_(_I_)~ +~ O_2~->~CO_2_(_g_)~ +~H_2O_(_g_) [/tex]

When we balance the reaction we will obtain:

[tex]C_9H_2_0_(_I_)~ +~14 O_2_(_g_)~->~9CO_2_(_g_)~ +~10H_2O_(_g_) [/tex]

Part B.

The formula for 2-methylbutane is [tex]C_5H_1_2[/tex], with this in mind we can write the combustion reaction:

[tex]C5H12_(_I_)~ +~O_2_(_g_)~->~CO_2_(_g_)~ +~H2O_(_g_) [/tex]

When we balance the reaction we will obtain:

[tex]C5H12_(_I_)~ +~8O_2_(_g_)~->~5 CO_2_(_g_)~ +~6 H2O_(_g_) [/tex]

Part C.

The formula for 3-ethyltoluene is [tex]C_9H_1_2[/tex], with this in mind we can write the combustion reaction:

[tex]C_9H_1_2_(_I_)~+~O_2_(_g_)~->~CO_2_(_g_)~+~H2O_(_g_)[/tex]

When we balance the reaction we will obtain:

[tex]C9H12_(_I_)~ +~12O_2_(_g_)~->~9CO_2_(_g_)~ +~6H2O_(_g_)[/tex]

See figure 1 for further explanations.

I hope it helps!

Answer:

1. because what if you do a incorrect ion? it would be all wrong! 2. you dont get it quickly because! you might get the wrong equipment. 4. yep! no food or drinks!

Explanation:

hope this helps ☻︎

Answer: Sí

Explanation: ya que una mascota es inofensiva, pero para fotografiar a un animal salvaje, debes esperar pacientemente el momento perfecto

Answer: 65%

Explanation:

When in probability and the outcome is mutually exclusive which means that either one or the other will happen then the probabilities of the events should be added up.

P(A or B) = P(A) + P(B)

P(Rain or Hail) = P(Rain) + P(Hail)

P(Rain or Hail) = 30% + 35%

P(Rain or Hail) = 65%

A variable within a scientific experiment is something that is changed (i.e. it varies). There should be only one manipulated variable within a scientific experiment so that the experimenter can be certain it is this variable which causes a pattern in the resultant data, if any exists at all.

HOPE IT HELPS PLZ BRAINLIEST

The heat from the oven heats up the metal pan, and the metal pan transfers the heat to the brownies.

Heat conduction is defined as the transfer of heat in an object from the area of hotter region to the area of cooler region through microscopic particles and movement of electrons within the body.

All the objects such as metal brownie pan that is capable of conducting heat is called the term thermal conductivity.

Examples of metals that are good conductors of heat include the following Gold, Silver, Copper, Aluminium, Iron.

Therefore, is can be concluded that the oven heats up the metal pan, and the metal pan transfers the heat to the brownies.

Learn more about conductor here:

https://brainly.com/question/28298618

#SPJ1

Answer:

Protons: 26

Neutrons: 30

Explanation:

Answer:

Explanation:

Homogeneous mixture is a mixture in which the components of the mixture are in the same proportion throughout any sample extracted from the mixture while an heterogeneous mixture is a mixture in which the components of the mixture differ in term of proportion when different samples of the mixture are extracted and compared.

For example, a sandy water will have some parts (usually the bottom) of the mixture with more sand than other parts of the mixture, hence, it (sandy water) is a heterogeneous mixture. While salty and ocean water has it's salt dissolved in the same proportion throughout the water in the mixture, hence salty and/or ocean water is a homogeneous mixture.

Sandy water can be separated by filtration (i.e using a filter paper to separate the sand from the water when the mixture is poured over a filter paper) while salty and ocean water can be separated by distillation (i.e boiling of the mixture so the water molecules can boil and move through a tube as gas or steam into another container where they are cooled and converted back to liquid or water while leaving the solid salt component of the mixture in the boiling tube).

Answer: She needs to divide the mass by the volume to find the density of the object.

Explanation:

Answer:

The  correct option is  D

Explanation:

From the question we are told that

 The pH of the aqueous solution is  [tex]pH  =  7[/tex]

 The  isoelectric point  is  [tex]pl =  9[/tex]

From the data given we see that the  

        [tex]pH[/tex] is  below  [tex]pl[/tex]

So the protein will have a net positive charge

A protein has an isoelectric point (pI) of 9, the statement which best describes the state of this protein is that the protein will have a net positive charge.

Isoelectric point of any susbatnce is the pH of the substance where net charge on that substance will be zero, i.e. no. of positive charged ions will equal to the number of negative charged ions.

In the question it is given that value of isoelectric point (pl) of protein is 9 and given value of pH is 7. It means that isoelectric point is higher that given pH so the protein molecule should bear a positive charge on it. If pH value is greater than pl value then molecule will bear a negative charge.

Hence option (D) is correct.

To know more about isoelectric point, visit the below link:
https://brainly.com/question/14511468

Answer:

B) The molecular orbital formed is lower in energy than a hydrogen 1s atomic orbital.

Explanation:

When two atoms of hydrogen come close to each other , there is formation of molecular orbital . Due to overlap of 1 s orbital of one and 1 s orbital of another atom , two molecular orbitals are formed . One of these molecular orbital has energy less than 1 s atomic orbital . It is called 1 s sigma bonding molecular orbital . The other molecular orbital has energy more than 1 s atomic orbital . It is called antibonding molecular orbital . Two electrons occupy bonding sigma molecular orbital .

So , the statement that "the molecular orbital formed is lower in energy than a hydrogen 1s atomic orbital " is wrong .

Answer:

28.705 cm

Explanation:

Hello,

In this case, for rounding the number to five significant figures we must "cut" it at 5 so we hide the 3, therefore it turns out:

28.705 cm.

Moreover, we must realize that since such 3 is less than five, we do not modify the previous five to six, case which would happen if that three has changed to five or more.

Regards.

Answer:

ΔH = 87.8kJ

Explanation:

You can determine ΔH of a reaction from the sum of similar reactions (Hess's law). In the problem with the given ΔH:

1. C5H12(l)+8O2(g)→ 5CO2(g)+6H2O(g) ΔH= -3505.8 kJ

2. C(s)+O2(g)→CO2(g) ΔH= -393.5 kJ

3. 2H2(g)+O2(g)→ 2H2O(g) ΔH= -483.5 kJ

5 times 2. + 3 times 3:

5C(s) + 8O2(g) + 6H2(g) → 5CO2(g) + 6H2O(g)  

ΔH= 5*(-393.5 kJ) +  3*(-483.5 kJ) = -3418kJ

Now, this reaction - 1:

5C(s)+6H2(g) → C5H12(l) ΔH= -3418kJ - (-3505.8kJ)

Answer:

The mass of  Mg  and the mass of  Cl  in the sample

Explanation:

We have that the sample's is purity is simply the mass of Mg and the mass of Cl in the sample

From the Question we are told that

Mass of MgCl2 =5g

Therefore

What we need to  determine that the sample's is purity is simply the mass of Mg and the mass of Cl in the sample because

the mass of MgCl should be equal to mass of Mg and mas of Cl

For more information on this visit

https://brainly.com/question/17391424

Answer:

Calculate the unknown variable in the equation for gravitational potential energy, where potential energy is equal to mass multiplied by gravity and height; PE = mgh. Calculate for different gravity of different enviornments - Earth, the Moon, Jupiter, or specify your own. Free online physics calculators, mechanics, energy, calculators.

Explanation:

Answer:

the density increases

Explanation:

Coz high temperature makes water less dense. As water gets warmer, its molecules spread out, so it becomes less dense. As it gets colder, it becomes denser

Answer:

A. 2 protons, 2 electrons, and 1 neutron .

Answer:

A 2 protons, 2electrons,1 neutron

Answer:

For 1 hour 75w light bulb requires 270 kj  for burning

for 3 hours 75 w light bulb requires 270*3 = 810kj for burning

Explanation:

Answer:

d. I and II only

Explanation:

Evaporation is the breakaway of liquid molecules through the surface of a liquid, into the surrounding atmosphere in the form of a gas. Evaporation increases with temperature, since the molecules posses more kinetic energy to break through the liquid surface barrier at a higher temperature. Also, an increase in the surface area puts more of the molecules of the liquid close to the interface of the liquid and the surrounding atmosphere, increasing their chances of breaking away. An increase in the intermolecular forces between the molecules of the liquid will only decrease the rate of evaporation, since more energy will be required by the liquid molecules to break free from the bond between them and their neighboring molecules.