Colligative properties of solutions include all of the following except: a. an increase in the osmotic pressure of a solution upon the addition of more solute b. elevation of the boiling point of a solution upon addition of a solute to a solvent c. an increase of reaction rate with increase in temperature d. depression of the freezing pont of a solution upon addition of a solute to a solvent e. depression of vapor pressure upon addition of a solute to a solvent

Answer:

hot water is thinner than cold water.

Explanation:

The rate of diffusion of a substance has a lot to do with the temperature of a body.

Let us take water for instance, cold water has a greater density than hot water. As a result of this, the molecules in cold water are slower when in motion and more sluggish.

On the other hand, the molecules of hot water are quite faster since hot water has a lower density(thinner than cold water).

Thus, an  increase in temperature will cause an increase in diffusion rate because hot water is thinner than cold water.

Answer:

1.96 × 10²⁴ molecules

Explanation:

Step 1: Given data

Mass of ethanol (m): 150. g

Step 2: Calculate the number of moles (n) corresponding to 150. g of ethanol

The molar mass of ethanol is 46.07 g/mol.

150. g × 1 mol/46.07 g = 3.26 mol

Step 3: Calculate the number of molecules in 3.26 moles of ethanol

To convert moles into molecules, we need Avogadro's number: there are 6.02 × 10²³ molecules in 1  mole of molecules.

3.26 mol × 6.02 × 10²³ molecules/1  mol = 1.96 × 10²⁴ molecules

Answer:

C

Explanation:

energy from different sources leads to different types of rocks. energy inside the earth(volcanoes) melts rocks into liquid rock(molten larva) but energy from the sun(heat radiation) causes rock to weather(breakdown) into small pieces of rocks

Answer:

c

Explanation:

Answer:

See explanation.

Explanation:

Hello there!

3. In this case, according to the given question, it turns out possible for us to say that any chemical formula, for an ionic compound, has the cation (positive) on the left and the anion (negative) on the right; thus, since Mg is a metal, which tends to lose electrons and become positively charged whereas the Cl is a nonmetal, which tends to gain electrons and become negatively charged, we have the following:

[tex]Mg^{2+}Cl^-\\\\Mg^{2+}Cl^-_2\\\\MgCl_2[/tex]

4. In this case, since lithium is a metal, as well as magnesium, it is not possible for them to switch around their charges as they will not be bonded because they will be repelled rather than attracted because of their equal positive charges.

Regards!

[tex] \huge \mathrm{ \underline{Answer} ࿐}[/tex]

The correct option is B.

A Catalyst is a chemical which promotes or speed up a chemical reaction without undergoing any chemical reaction itself.

for example : potassium permanganate - Hydrogen peroxide will decompose into water and oxygen gas in the presence of KMnO4.

_____________________________

[tex]\mathrm{ \#TeeNForeveR}[/tex]

Answer:

2.82 g

Explanation:

Step 1: Write the balanced precipitation reaction

3 Ba(NO₃)₂ (aq) + Al₂(SO₄)₃ (aq) ⇒ 3 BaSO₄(s) + 2 Al(NO₃)₃(aq)

Step 2: Calculate the reacting moles of Ba(NO₃)₂

45.0 mL (0.0450 L) of 0.548 M Ba(NO₃)₂ react.

0.0450 L × 0.548 mol/L = 0.0247 mol

Step 3: Calculate the moles of Al₂(SO₄)₃ that react with 0.0247 moles of Ba(NO₃)₂

The molar ratio of Ba(NO₃)₂ to Al₂(SO₄)₃ is 3:1. The reacting moles of Al₂(SO₄)₃ are 1/3 × 0.0247 mol = 8.23 × 10⁻³ mol

Step 4: Calculate the mass corresponding to 8.23 × 10⁻³ moles of Al₂(SO₄)₃

The molar mass of Al₂(SO₄)₃ is 342.2 g/mol.

8.23 × 10⁻³ mol × 342.2 g/mol = 2.82 g

Answer:

the original substances in any chemical reaction. products. the resulting substances in any....chromium(III) oxide, and water. (NH4)2Cr2O7(s) → N2(g) + Cr2O3(s) + 4H2O(g).

Answer: The concentration of [tex]NO_{2}[/tex] in the given equilibrium mixture is 0.0545 M.

Explanation:

The ratio of concentration of products and reactants raised to the power of their coefficients is called equilibrium constant. The symbol used to denote equilibrium constant is [tex]K_{eq}[/tex].

As the given reaction equation is as follows.

[tex]2NO_{2}(g) \rightleftharpoons N_{2}O_{4}(g)[/tex]

The expression for equilibrium constant of this reaction is as follows.

[tex]K_{eq} = \frac{[N_{2}O_{4}]}{[NO_{2}]^{2}}[/tex]

Now, substitute the given values into above formula as follows.

[tex]K_{eq} = \frac{[N_{2}O_{4}]}{[NO_{2}]^{2}}\\67.3 = \frac{(0.2)}{[NO_{2}]^{2}}\\So, [NO] = \sqrt{\frac{0.2}{67.3}}\\= 0.0545 M[/tex]

Thus, we can conclude that the concentration of [tex]NO_{2}[/tex] in the given equilibrium mixture is 0.0545 M.

Answer:

65.38 u

Explanation:

hope this helps you out!!!!!!!

They Mean D and not U H just took the test and its D i hope this help

Answer:

18.6 ml

Explanation:

From the balanced equation given:

Volume of oxygen = 27.9 mL

From the equation, we will see that three moles of oxygen react with CS_2 to give two moles of sulfur dioxide (SO_2)

Also, three mL of O_2 yields two mL of SO_2

Now, to calculate the volume of SO_2; we have:

[tex]=27.9 mL \times \dfrac{2 mL \ of SO_2}{3 mL \ O_2}[/tex]

= 18.6 mL of SO_2

The correct answer is

C. -432.4 J/mol K

Answer:

ako po kailangan ko po nga ayuda

Explanation:

thanks for the points ❤️

Answer:

The right answer is "[tex][Na^+]=5.57 \ ppm[/tex]".

Explanation:

The given values are:

[tex]\frac{A_s}{A_{coffee}} =\frac{0.840}{1.000}[/tex]

According to the question,

The concentration of standard will be:

=  [tex]\frac{7.80}{50.00}\times 4.80[/tex]

=  [tex]0.156\times 4.80[/tex]

=  [tex]0.748 \ ppm[/tex]

Coffee after dilution,

⇒  [tex]\frac{A_{coffee}}{C_{coffee}} =F\times \frac{A_s}{C_s}[/tex]

or,

⇒  [tex]C_{coffee}=\frac{A_{coffee}}{A_s}\times \frac{C_s}{F}[/tex]

On substituting the values, we get

⇒               [tex]=\frac{1.000}{0.840}\times \frac{0.748}{1.68}[/tex]

⇒               [tex]=1.191\times 1.3104[/tex]

⇒               [tex]=1.561 \ ppm[/tex]

hence,

In unknown sample, the concentration of coffee will be:

=  [tex]1.561\times \frac{50}{14}[/tex]

=  [tex]\frac{78.05}{14}[/tex]

=  [tex]5.57 \ ppm[/tex]

Answer:

Answer: Number of moles of KOH present in solution is 3.75.

Explanation:

0.1 moles

There are 0.1 moles of solute in 250 mL of 0.4 M solution.

1 Answer. 1 mol of NaOH

Answer:

- log{H+ }= - log {5}= -0.6990

Answer:

4.78 mol O2

Explanation:

Grams --> moles

Grams/molar mass = moles

153 g O2 / 32 g/mol O2 = 4.78125 (significant figures so round it up; the grams has 3 significant figures, so round it up) 4.78 mol O2

Answer:

the frequency of photons [tex]v = 1.509\times10^{39}Hz[/tex]

Explanation:

Given:  first ionization energy of 1000 kJ/mol.

No. of moles of sulfur = 1 mole

[tex]\Delta E_1 = 1000KJ/mol[/tex]

We know that plank's constant

[tex]h = 6.626\times10^{-34} Js[/tex]

Let the frequency of photons be ν

Also we know that ΔE = hν

this implies ν = ΔE/h

[tex]= \frac{10^6J}{6.626\times10^{-34} Js}[/tex]

[tex]v = 1.509\times10^{39}Hz[/tex]

Hence, the frequency of photons [tex]v = 1.509\times10^{39}Hz[/tex]

Answer:

Ag(I)C2H3O2 ....................

Silver only has a single valence value (+1) so you really don't need to put the (I) in the chemical formula.

Answer:

I'd there and pictures?? can put the list

Explanation:

Chemistry is overall a very interesting subject and it really depends on what you personally consider enjoyable. I love chemistry and I think that grade 11 chemistry is very easy. It's mostly based on balancing chemical equation, molar mass calculations and more. But it's a great course to take based on my experience.

Answer:

A

Explanation:

got from another website

The simulation which is least suitable to scientists for solving a problem is when performing an experiment that would be too costly or dangerous to conduct in the real world.

Scientific approach is an empirical method of acquiring knowledge and result. This method involved the careful observation of the problem, applying skepticism about the problem and giving cognitive assumptions also.

If a scientist wants to investigate several problems, then they will perform a large no. of trials at regular intervals to get the required result. But if performing of any experiment is dangerous to conduct in the real world then scientists will ignore to solve that problem.

Hence, option (C) is correct.

To know more about scientific approach, visit the below ink:

https://brainly.com/question/497944

Answer:

Explanation:

Answer: There are [tex]145 \times 10^{23}[/tex] atoms in 24 moles of Fe.

Explanation:

According to the mole concept, 1 mole of a substance contains [tex]6.022 \times 10^{23}[/tex] atoms.

Therefore, atoms present in 24 moles of Fe are calculated as follows.

[tex]24 mol \times 6.022 \times 10^{23} atoms/mol\\= 144.52 \times 10^{23} atoms\\or, 145 \times 10^{23} atoms[/tex]

Thus, we can conclude that there are [tex]145 \times 10^{23}[/tex] atoms in 24 moles of Fe.

Carbon has an outer shell consisting of 4 valence electrons. ... Thus, a carbon ion can have a charge of anywhere from -4 to +4, depending on if it loses or gains electrons. Although the most common oxidation states of carbon are +4 and +2, carbon is able to make ions with oxidation states of +3, +1, -1, -2, and -3.

Answer: 61 μg of aluminum phosphate in grams is equal to [tex]61 \times 10^{-6} g[/tex].

Explanation:

According to standard conversion of units, 1 microgram [tex](\mu g)[/tex] is equal to [tex]1 \times 10^{-6}[/tex] g.

Therefore, [tex]61 \mu g[/tex] is converted into grams as follows.

[tex]1 \mu g = 10^{-6} g\\61 \mu g = 61 \mu g \times \frac{10^{-6}}{1 g}\\= 61 \times 10^{-6} g[/tex]

Thus, we can conclude that 61 μg of aluminum phosphate in grams is equal to [tex]61 \times 10^{-6} g[/tex].