A tennis ball is dropped from a height of 3 m and bounces back to a height of
1 m after hitting the ground (s = 0).

Use the equation V^2=U^2 + 2as to calculate the velocity of the tennis
ball when it hits the ground.

Answer:

momentum before: 100kgm/s

momentum after: 20kgm/s

Explanation:

initial velocity: 10

final velocity: 2

p=mv

before: 10kg×10m/s

after:10kg×2m/s

I'm not 100% sure btw

Answer:1590 N

Explanation:

Impulse =  change in momentum/time

change in momentum = 0 - 50 x 35 = -1750

-1750/1.1 = 1590 (3s.f.) N

Answer:

Drawing the triangle:

H / x = tan 52.2 = 1.29

H / (4.6 - x) = tan 28.8 = .550

H = 1.29 x

H = .55 * 4.6 - .55 x

1.84 x = 2.53        combining equations

x = 1.38

4.6 - 1.38 = 3.22

Total base of triangle = 1.38 + 3.22 = 4.6

H / x = tan 52,2 = 1.29

H = 1.29 * 1.38 = 1.78 height of triangle

Check:

1.78 / 3.22 = tan 28.9    

This agrees with the given value of 28.8

Answer: Solids have definite shapes and liquids fill their containers.

Explanation: Liquids have got further apart molecules than solids, so the liquid molecules have a higher degree of locomotion than solid molecules, hence able to fill the container though without a definite volume, which is not the case for solid molecules.

Answer:

Answer: B. Explanation: For an object to accelerate the force on it must be increased. According to Newton's second law of motion.

Explanation:

I do Accelerate to good luck

Answer:

A hydraulic press works on the principle of Pascal's law, which states that when pressure is applied to a confined fluid, the pressure change occurs throughout the entire fluid. Within the hydraulic press, there is a piston that works as a pump, that provides a modest mechanical force to a small area of the sample.

Explanation:

[tex]\\ \sf\Rrightarrow PE=mgh[/tex]

[tex]\\ \sf\Rrightarrow m(10)(3)=120[/tex]

[tex]\\ \sf\Rrightarrow 30m=120[/tex]

[tex]\\ \sf\Rrightarrow m=4kg[/tex]

Answer:

1.67m

5m/s

Explanation:

Wavelength of the wave = 3m

Speed of the wave  = 5m/s

The distance between crest and the adjacent trough of water waves is known as the wavelength of a wave.

 To find the frequency ;

        V = f∧

V is the speed of the wave

f is the frequency

∧ is the wavelength

  Insert the parameters and find the frequency;

        f  = V/ ∧   = 5 / 3  = 1.67Hz

The rate at which the wave passed a given point is the speed of the wave and it is 5m/s

Answer:

Since there is no external force, there is no change (movement) in the center of mass. Internally, the center of mass might change position, but the external result is still zero net velocity.

The net recoil velocity must be zero.

Their combined speed will be 1m/s

Given the following parameters;

If the player collides and stick together, the combined speed is expressed as;

Hence their combined speed will be 1m/s

Learn more on collision here: brainly.com/question/7538238

Answer: A compass taken to Earth's moon does not point in a specific direction on the moon. The moon does not have a strong magnetic field.

The student who did the most work is student 2 with 2500 Joules.

Given the following data:

To determine which of the students did the most work:

Mathematically, the work done by an object is given by the formula;

[tex]Work\;done = Force \times distance[/tex]

For student 1:

[tex]Work\;done = 500 \times 1.2[/tex]

Work done = 600 Joules

For student 2:

[tex]Work\;done = 500 \times 5[/tex]

Work done = 2500 Joules.

Therefore, the student who did the most work is student 2 with 2500 Joules.

Read more: Read more: brainly.com/question/13818347

Answer:student 2 did the most work

Explanation:student 2 did more work because he pushed it up 5 m instead of 1.2.

Answer:

4.16875×10^-9

Explanation:

given,

mass(M1)=20kg

mass(M2)= 50kg

distance(d)=4m

gravitational constant value (G)=6.67×10^-11

we know,

gravitational force=(Gm1m2)÷d^2

=(6.67×10^-11×20×50)÷4^2

=(6.67×10^-8)÷16

= 4.16875×10^-9

To make the boiler more efficient, we would replace the resistor with another double the length.

We know that the resistance of the resistor in the boiler is given by R = ρl/A where

Also, the power generated by the resistor is P = i²R where

If i is constant, we see that P ∝ R.

So, to increase the efficiency, the value of the resistance has to increase.

Also, since R = ρl/A and ρ and A are constant, we see that R ∝ l.

Since P ∝ R and R ∝ l ⇒ P ∝ l.

So, to increase the efficiency, we would double the length of the resistor.

So, to make the boiler more efficient, we would replace the resistor with another double the length.

Learn more about resistors here:

https://brainly.com/question/25209910

Answer: When a child is riding on a sled down a steep, snow-covered hill, his elevation decreases and hence Kinetic energy increases and potential energy decreases.

i think this will help you

Answer:

The conservation of momentum of a system is a fundamental principle in classical mechanics. The only condition for this principle being valid is that the system should be an isolated one, i.e. It should not be acted upon by any external force.

Answer:

Approximately [tex]5.11 \times 10^{-19}\; {\rm J}[/tex].

Explanation:

Since the result needs to be accurate to three significant figures, keep at least four significant figures in the calculations.

Look up the Rydberg constant for hydrogen: [tex]R_{\text{H}} \approx 1.0968\times 10^{7}\; {\rm m^{-1}[/tex].

Look up the speed of light in vacuum: [tex]c \approx 2.9979 \times 10^{8}\; {\rm m \cdot s^{-1}}[/tex].

Look up Planck's constant: [tex]h \approx 6.6261 \times 10^{-34}\; {\rm J \cdot s}[/tex].

Apply the Rydberg formula to find the wavelength [tex]\lambda[/tex] (in vacuum) of the photon in question:

[tex]\begin{aligned}\frac{1}{\lambda} &= R_{\text{H}} \, \left(\frac{1}{{n_{1}}^{2}} - \frac{1}{{n_{2}}^{2}}\right)\end{aligned}[/tex].

The frequency of that photon would be:

[tex]\begin{aligned}f &= \frac{c}{\lambda}\end{aligned}[/tex].

Combine this expression with the Rydberg formula to find the frequency of this photon:

[tex]\begin{aligned}f &= \frac{c}{\lambda} \\ &= c\, \left(\frac{1}{\lambda}\right) \\ &= c\, \left(R_{\text{H}}\, \left(\frac{1}{{n_{1}}^{2}} - \frac{1}{{n_{2}}^{2}}\right)\right) \\ &\approx (2.9979 \times 10^{8}\; {\rm m \cdot s^{-1}}) \\ &\quad \times (1.0968 \times 10^{7}\; {\rm m^{-1}}) \times \left(\frac{1}{2^{2}} - \frac{1}{8^{2}}\right)\\ &\approx 7.7065 \times 10^{14}\; {\rm s^{-1}} \end{aligned}[/tex].

Apply the Einstein-Planck equation to find the energy of this photon:

[tex]\begin{aligned}E &= h\, f \\ &\approx (6.6261 \times 10^{-34}\; {\rm J \cdot s}) \times (7.7065 \times 10^{14}\; {\rm s^{-1}) \\ &\approx 5.11 \times 10^{-19}\; {\rm J}\end{aligned}[/tex].

(Rounded to three significant figures.)

Answer:

because when an object approaches the speed of light, it's mass starts to increase exponentially, and would be infinite at the speed of light. It would therefore require MORE than an infinite amount of energy to accelerate even a single electron to the speed of light

Answer:

Hey There!

Refer to the attachment...

or in this way also you can solve shown in second attachment

Answer:

Since the gravitational force is directly proportional to the mass of both interacting objects, more massive objects will attract each other with a greater gravitational force. So as the mass of either object increases, the force of gravitational attraction between them also increases.

Answer:

thanks

Explanation:

for answer byebye

Answer:

A major difference between tangential acceleration and centripetal acceleration is their direction. Centripetal means “center seeking”. ... Tangential acceleration results from the change in magnitude of the tangential velocity of an object. An object can move in a circle and not have any tangential acceleration.

The direction of acceleration is a key distinction between tangential acceleration and centripetal acceleration. Centripetal is defined as "center-seeking." The amount of an object's tangential velocity changes, which causes tangential acceleration. Without experiencing any tangential acceleration, an item can move in a circle.

Acceleration is the rate at which the speed and orientation of a moving object change over time. When a spot or object moves faster or slower along a straight line, it is said to be accelerated. Even though the speed is constant, motion on a circle accelerates so because the direction is always shifting. Both by and to acceleration for all other types of motion.

It is a vector quantity because it has both magnitude and direction.

Any object's rotation experiences tangential acceleration, which is the speed at which the tangential velocity fluctuates. When an object is moving, it behaves in a tangential direction. An object moving in a circle will also experience the very same tangential velocity action.

To know more about Acceleration:

https://brainly.com/question/12550364

#SPJ6

Answer: 25N to the right

Explanation: 35N - 10N = 25N

Answer:

Momentum Packet Answer KEY - Science Online

YOU WILL SEE THE PDF

Answer:Answer:

See diagram for answers. The force and acceleration vectors are directed inwards towards the center of the circle and the velocity vector is directed tangent to the circle.

Explanation:

Answer:

1kW = 1000W

600W = 0.6kW

Cost of electric bill = 0.6kWh × 24 × 30 × $0.05

                               = $21.60