17. Find the average atomic mass unit of silicon given the following isotopes and
abundances: Silicon-28, Silicon-29, Silicon-30 with masses of 27.977, 28.976,
29.974, respectively. The percent abundance of the silicon isotopes is 92.2%, 4.7%
and 3.1%, respectively. Periodic table and it’s trends

Answer:

4.7K

Explanation:

Given parameters:

Initial volume  = 75L

Initial pressure  = 125psi  

        to atm gives 8.5atm

Initial temperature  = 288K

New volume  = 6.1L

New pressure  = 25psi

        to atm gives 1.7atm

Unknown:

New temperature = ?

Solution:

To solve this problem, we use the combined gas law which is given below:

        [tex]\frac{P1 V1}{T1}[/tex]    = [tex]\frac{P2 V2}{T2}[/tex]  

P, V and T are pressure, volume and temperature

1 and 2 are initial and new states

                  [tex]\frac{8.5 x 75}{288}[/tex]   = [tex]\frac{1.7 x 6.1}{T2}[/tex]

        T2  = 4.7K

Answer:

3) Compound 1 is ionic, and compound 2 is molecular

Explanation:

Compound-1 is an ionic compound while Compound-2 is a molecular compound. Option 3 is correct.

Ionic Compound:

They are formed when an atom donates its electron to another atom. This results in one positive and one negative ion.

Hence, it is a very strong bond. These compounds have a very high melting and boiling point. They are very good electric conductors in the aqueous solution.

For example- NaCl.

Molecular compounds:

They are compounds that are made up of discrete molecular units. For example- [tex]\bold {H_2O}[/tex]

They have very weak intermolecular bonds hence have low boiling and melting point and do not conduct electricity.

SInce Compound-1 has higher MP and BP and Compound-2 has low melting and boiling point.

Therefore, Compound-1 is an ionic compound while Compound-2 is a molecular compound.

To know more about Ionic Compound:

https://brainly.com/question/9167977

Answer:

when the atom moves to the third energy level, its energy increases. However, when it goes back to the second energy level its overall energy decreases.

Explanation:

the smallest (or innermost) energy level has the least amount of energy and the largest (or outer most) level needs the most amount of energy. In order for the electron to move from one level to the other, it would need to match the energy of that level.

Answer:

You could have looked it up, but here ya go...

Explanation:

Wind is a type of dry deposition method. If original soil is eroded and wind exists, soil particles move via wind (sometimes it is called dust transport) and finally are deposited at final destination regions/areas. However, water erosion occurs when rainfall or hail occurs.

Hope this Helped! :)

Answer:

Its particles are evenly distributed.

Explanation:

Solutions are homogenous mixtures of solutes and solvents. In a solution the solute particles are evenly distributed in the solvent.

Here are some characteristics of solutions:

A characteristic of a solution is that its particles are evenly distributed.

A characteristic of a solution is that its particles are evenly distributed. In a solution, the solute (substance being dissolved) is uniformly distributed and mixed with the solvent (the substance doing the dissolving) at the molecular or ionic level.

The particles of the solute become thoroughly dispersed and do not settle out over time. Solutions are generally clear and do not scatter light, unlike suspensions or colloids which may exhibit light scattering due to the presence of larger particles.

More on solutions can be found here: https://brainly.com/question/30665317

#SPJ6

Answer:

Explanation:

H₃PO₄ + 3NaOH = Na₃PO₄ + 3 H₂O.

1 mole     3 mole

22.85 mL of the standardized 0.0995M NaOH solution will contain

.0995 x .02285 moles of NaOH

= 22.7357 x 10⁻⁴ moles of NaOH

3 moles of NaOH reacts with 1 mole of H₃PO₄

22.7357 x 10⁻⁴ moles of NaOH reacts with 1 x 22.7357 x 10⁻⁴  / 3 mole of H₃PO₄

= 7.5785 x 10⁻⁴ moles of H₃PO₄

7.5785 x 10⁻⁴ moles of H₃PO₄  is contained in 10 mL or 10⁻² L

molarity of H₃PO₄ solution = 7.5785 x 10⁻⁴ / 10⁻²

= 7.58 x 10⁻² M

= .0758 M .

Answer:

The magnification is 10x

Explanation:

Answer: The magnification of the eyepiece on the microscope is the lens at the top of the microscope that the user looks through. This lens most commonly magnifies a sample by 10x

Explanation: The eyepiece magnifies the primary image produced by the objective; the eye can then use the full resolution capability of the objective. The microscope produces a virtual image of the specimen at the point of the distinct vision.

Answer:

dora needs help

Explanation:

Answer:

...........................

Answer:

true

.......................

Answer: You're Welcome!

Oh, It's False - Kinetic energy depends upon the speed of the object; potential energy depends upon the position of the object.

Answer

oh you again?

Explanation:

Answer:

melting and vaporization

Explanation:

Answer:

17.6

Explanation:

Answer is explained above

Answer:

One electron per single hydrogen atom.

Explanation:

Hello!

In this case, given the reaction:

[tex]H_2+O_2\rightarrow H_2O[/tex]

Whereas we can identify the following half-reaction for hydrogen:

[tex]H_2^0\rightarrow H_2^+[/tex]

Whereas we see that each single hydrogen atom gains one electron in order to go from 0 to +1, which is also related to an oxidation half-reaction.

Best regards!

Answer:

The attractive force between the sodium and chloride ions has a magnitude of -2.94 x 10⁻⁹ N

Explanation:

An electron is a negatively-charged particle. The charge on an electron is -1.6 x 10⁻¹⁹ C. This is also known as the fundamental unit of charge, e. A proton has the same charge as as electron but its charge is positive.

The charge on the chloride ion is negative and is due to an electron whereas the charge on the sodium ion is positive and is due to a proton.

The magnitude of the force of attraction between two charges is given by the Coulomb's law: F = Kq₁q₂/r²

where K is a constant = 9 x 10⁹ N.m₂.C⁻², q₁ = -1.6 x 10⁻¹⁹ C, q₂ = +1.6 x 10⁻¹⁹ C, r = 0.28 nm = 0.28 x 10⁻⁹ m

F = {(9 x 10⁹ N.m₂.C⁻²) (-1.6 x 10⁻¹⁹ C) (+1.6 x 10⁻¹⁹ C)} / (0.28 x 10⁻⁹ m)²

F = -2.94 x 10⁻⁹ N

Therefore, the attractive force between the sodium and chloride ions has a magnitude of -2.94 x 10⁻⁹ N

Answer:

the total distance moved by the wave from it's equilibrium point.

Explanation:

I picture the equivalent as standing on the floor is equilibrium point or starting. how high you jump is your amplitude.

Answer:

0.266 grams of calcium sulfate

Explanation:

We can calculate the mass of calcium sulfate added using the given volume and concentration of the solution:

First we convert 600.0 mL to L ⇒ 600.0 mL equals 0.6000 L (600 ÷ 1000).

0.444 g/L * 0.6000 L = 0.266 g

Thus the answer is 0.266 grams of calcium sulfate.

Answer:

Mass of water produced = 19.8 g

Explanation:

Given data:

Mass of hydrogen peroxide = 37.7 g

Mass of water produced = ?

Solution:

Chemical equation:

2H₂O₂      →        2H₂O  + O₂

Number of moles of H₂O₂:

Number of moles = mass/molar mass

Number of moles = 37.7 g/ 34 g/mol

Number of moles = 1.1 mol

Now we will compare the moles of H₂O₂ and H₂O from balance chemical equation in order to determine the moles of water formed.

                                   H₂O₂      ;           H₂O

                                      2         :             2

                                     1.1         :          1.1

Mass of water formed:

Mass = number of moles × molar mass

Mass = 1.1 mol × 18 g/mol

Mass = 19.8 g

A. They are the same

Given

C3H6 and C4H8

Required

The percent compositions

Solution

%C = 3.12/42 x 100% = 85.71%

%H = 6.1/42 x 1005 = 14.29%

C₄H₈(MW=56 g/mol)

%C = 4.12/56 x 100% = 85.71%

%H = 8.1/56 x 100%=14.29%

So they are the same, because mol ratio of C and H in both compounds is the same, 1: 2

Answer:

yes

Explanation:

Answer:

8.87 L.

Explanation:

From the question given above, the following data were obtained:

Mass (m) of gas = 12 g

Initial volume (V₁) = 14.5 L

Initial pressure (P₁) = 52 cmHg

Final pressure (P₂) = 85 cmHg

Final volume (V₂) =?

The final volume of the gas can be obtained by using the Boyle's Las equation as illustrated below:

P₁V₁ = P₂V₂

52 × 14.5 = 85 × V₂

754 = 85 × V₂

Divide both side by 85

V₂ = 754 / 85

V₂ = 8.87 L

Thus the volume of the gas will be 8.87 L

Shure what you need help with

Answer:

1. 10moles

2. Find the summarized equation below

Explanation:

Mole = mass ÷ molar mass

Molar mass of oleum (H2S2O7) = 1(2) + 32(2) + 16(7)

= 2 + 64 + 112

= 178g/mol

According to the information provided, the mass of oleum is 1780g, hence, the number of moles in it is:

Mole = 1780/178

Mole = 10moles

2. The summarized equation of the contact process is:

1) S + O2 → SO2

2) 2SO2 + O2 → 2SO3

3) SO3 + H2SO4 (conc. sulfuric acid) → H2S2O7

4) H2S2O7 + H2O → 2H2SO4 (dilute sulfuric acid)

Explanation:

The half-life is the time taken for a radioactive substance to decay to half of its original composition.

    Let us assume that the original amount is x atoms;

                     Half - life   = 60days

Days                          Composition           Half-life number

0                                         x                                   0

60                                   x/2                                    1

120                                  x/4                                    2

180                                   x/8                                   3

240                                  x/16                                   4

300                                  x/32                                  5

360                                   x/64                                6

The fraction that would be left after 360 days will be [tex]\frac{1}{64}[/tex]

Answer:

strontium nitrate

Explanation:

hope this helps you....:)

because they need a medium to travel they can travel everywhere if they got the medium

Answer:

Dehydration synthesis reactions build molecules up and generally require energy, while hydrolysis reactions break molecules down and generally release energy. Carbohydrates, proteins, and nucleic acids are built up and broken down via these types of reactions, although the monomers involved are different in each case.

Explanation:

Answer:change in number of atoms

Explanation:AP3X

Answer:

Explanation: Avogadro number,N, = 6.02214076*10^23per mole —> 22.71L

—>( 7.41*10^26/N)*22.71 = 22.79*10^3 = 22,790L